Jump to content
SAU Community

Rb20 Turbo Upgrade, All Dyno Results


Recommended Posts

309rwkw on 22psi

Rb20

Aries Pistons

Standard Rods

Standard Crank

Standard Manifold

GT3582r (.63 rear)

JUN cams and cam gears

Tial Wastegate

Microtech

Dyno sheet up later today

Fairly rushed tune that's fairly rich all round. At that stage we hadn't really finished tidying it up.

michaelsrb20.jpg

Link to comment
Share on other sites

  • 2 weeks later...

R32 RB20DET

HKS Cast Low Mount Ext Gate Manifold

Hypergear TR43 HF

Generic 38mm Tial Style Gate

Cam Gears

FMIC

POD

GTR Injectors

Z32 MAF

Remapped ECU

3" Turbo Back Exhaust

242 rwkw @ 21 psi (0% Correction)

Very Responsive for an RB20

post-179-1229573292.jpg

Link to comment
Share on other sites

R32 GTS4

rb20det

stock internals

td05h turbo

tial 38mm w/g, plumb back setup

rx7 flowed and tested injectors (550cc)

bosch fuel pump

Link ver5 ecu

600x300 hybrid style intercooler

k&n filter / custom stainless intake pipe

3'' full exhaust

turbo-smart ssq bov (type 2 vee port)

Running an Older Link is the problem here, cant keep up at the end and started to detonate, this was the highest run during tuning 221wkw @ 22psi.. Car is currently running 18psi @ 205wkw

96361397bw2.jpg

Edited by Vanilla_Rice
Link to comment
Share on other sites

  • 3 weeks later...
  • 2 weeks later...

I have a rb20det motor with stock internals

front mount intercooler

k&n pod filter

z32afm

gtr fuel pump

gtr ingectors

kkr430 turbo

kkr dump pipe

3inch exhaust

nistune ecu

hks boost controler

i had mine tune on dyno at turbotechinics on 10/11/08 and it made 301.2hp atw it peaks at 18psi and drops to 16psi

post-39975-1233479804_thumb.jpg

Link to comment
Share on other sites

Rb20 powered s13.5

- Un-Opened 9X,XXXkms RB20DET motor,

- Hypergear TR34 440hp ext gated.

- Tuned Length High Mount Manifold

- SARD INJECTORS....

- a fair bit more..... go to my link in signature for all mods..cbf em' typing all haha!

made 227rwkw on 17psi, with ext gate problem...and coilpacks shitting themselves...so should make more than that with new gate setup and my new packs ive got in on same psi..

img2yr3.th.jpg

but since then has been re-tuned to 14psi, while I get a new gate so I can run some more boost etc... and made 210rwkw on 14psi.. :(

will keep SAU updated on what happens...

***EDIT 3/02/09***

Today Micheal did another tune...

keep in mind it was a 37deg arvo here in Adelaide..

and my lil rb20 pumped out a pretty impressive 242.8rwkw on 21psi!!!!

effn stoked with that considering the day temp etc...

and backed it up with a few more 240+ runs as well just to show it wasn't a once off...

only thing ill be looking at doing is getting a bigger waste gate just to control a lil better as the KKR 38mm on its limits..

img03gf9.jpg

Link to comment
Share on other sites

  • 3 weeks later...

RB20DET - Stock internals

R34 GT-T Neo turbo

ARC Front Mount

3" GKTECH Front pipe/Dump pipe

3.5" Trust Mild Steel Straight Through Exhaust with 5" Cannon

Decat

Turbotech MBC - Running 13psi

untuned

Made 171.1 atw on RE Customs Dyno

Should make 200atw with a tune!! :)

Link to comment
Share on other sites

RB20DET - Stock motor

Custom Intake Manifold by Autoplus

Front Mount Intercooler with aluminum piping

3-inch full exhaust from downpipe

HKS Super Power Flow Filter

TurboXS Manual Boost Controller set to 12psi drops to 10psi

NISTune ECU

AI-dyno.jpg

Just an update. We did a tune again today, after a major electrical overhaul.

Car is now pushing out 249.14 rwhp and 251.91 lbs-ft of torque. Boost set at 1.21bar dipping down to 0.8bar.

Link to comment
Share on other sites

1993 R32 GTS-t

Standard RB20

ARC 105mm SideMount intercooler (50% larger than r34 gtt)

SplitFire Coilpacks

Apexi Catback

Batmbl Split Front/Dump 3inch stainless steel

Xforce hiflow cat

GTR Fuel pump

3A Raciing Airpod

HKS GT2530 with rb20 actuator

Standard Ecu - No Tune

Standard Injectors - maxing out

A lot of thanks to ReCustoms - www.recustoms.com.au

Update 26/2/09

GTR Injectors

Z32 AFM

TurboTech bleedvalve

Nistune - Tuned by Status Tuning http://www.statustuning.com

1.1mm spark plugs

A very safe tune of;

207.9kw atw @ 15psi with 11.5afr

afri.th.jpg boosty.th.jpg kwnm.th.jpg

----

Next update will be 18psi, adjustable cam gears and 12afr :)

Link to comment
Share on other sites

rb20det silvertop

gt2871r

std exhaust manifold

front facing plenum

haltech e11v2

gtr injectors

walbro pump

pwr 600x300 intercooler

kn panel filter

splitfire coils

3" turbo back exhuast

224.1rwkw at 17psi :P

Link to comment
Share on other sites

Well i just picked up my new ride.. mods are

RB20Det Silver Top (RB POWAH) Lazer Cut In Coil Cover

Cooling Pro Intercooler

GCG Highflowed Std Turbo

Pod Filter

Engine Dampner

Walbro Fuel Pump

HKS SSQV BOV

Stainless Exhaust Manifold

Oil Filter Relocation Kit with Oil Cooler In Rhs Of Mspec Front Bar

Anyways It managed to make a lousy 183Rwkw On 14psi

I have Gtr 444cc Injectors and Z32 AFM all i need now is Power fc and a ballast resistor and then wind my boost up to 20psi and see how I go.. Happy dayz

Link to comment
Share on other sites

RB20silvertop

big aftermarket front mount

bosch 040 fuel pump

GT30 highflow turbo

800cc SARD injectors

eboost2 controller

3" zorst

HKS pod

z32 airflow meter

aftermarket dump pipe

Made a lazy 230rkw on 15psi on a hot day !

Link to comment
Share on other sites

RB20 silver top (145PSI comp across all 6, 0PSI difference)

TR43 (Garrett T04E internals), internal waste-gate, low mount

3" exhaust with mid and rear muffler

600x300x75mm front mount intercooler

Turbotech manual boost controller

Z32 air flow meter

Standard airbox (bottom half removed) with CAI

3" metal intake pipe

R34 GTR injectors

Bosch 019 fuel pump

Adjustable cam gears (inlet and exhaust)

NGK BCPR7ES spark plugs

Car made 208.8rwkw/364.1nm on 15PSI with a steady 11.5 AFR

Going back for re-tune with aftermarket coilpacks and expecting 220-230rwkw @ 17PSI

Big thanks to Trent at Status Tuning.

Edited by dmr
Link to comment
Share on other sites

  • 2 weeks later...
rb20det silvertop

gt2871r

std exhaust manifold

front facing plenum

haltech e11v2

gtr injectors

walbro pump

pwr 600x300 intercooler

PWR 42mm radiator

kn panel filter

splitfire coils

3" turbo back exhuast

224.1rwkw at 17psi :blink:

post-20540-1238295565_thumb.jpg

Link to comment
Share on other sites

  • 2 months later...

RB20DET NICS

VG30 Highflow

R33 GTR Injectors

FMIC

Haltech Platinum ECU

3" Exhaust

Walbro 500hp Fuel pump

Greddy EBC

276rwhp on 18psi

300rwhp+ on 20psi (not exactly sure on figure, tuner backed off due to spiking)

Edited by HR31_RB20DET
Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • Hi i do buy a aftermarket headlight on ebay. For v35 skyline coupe. I know that its a plug and play and just use the old low beam light and balast from old headlight. But my problem is i dnt have knowlage on car and electrical thing. And the head light getnon ebay is the wire for halo ring light is not connected. I talk to the seller and he said that. What white and black wire for halo robg light is need to connect to RDL. Running day light. Anyone here can tell me how to connect it to Rdl? Which wire is yhe RDL?
    • Hey Kaz, Unfortunately I am not at home currently and wont be for a few more months so I do not have access to my files or CAD. And at this point I prefer to keep the files to myself as I want to potentially make a few more pairs and see if they will sell within the EU before openly marketing them. But the way it's shaped and how small it is, I don't think you can fit both an indicator and a fog light onto the same surround, unless they were very small LED-type clusters.
    • I’ve just installed a Uniclutch sport into my R32. I’ve been blown away by it… it drives like a stock Toyota Corolla. It doesn’t make sense to me that a performance clutch can drive this well. I was about to pull the trigger on a Nismo Coppermix twin plate when I discovered the Uniclutch and decided to give that a shot instead. They’ve changed the game and I couldn’t be happier.    I was previously using an Extreme cushioned button clutch with lightened flywheel. I’m still using the same lightened flywheel with the Uniclutch.
    • Mmmm no, that's a white series 2 R33 GTS-t
    • Oh and.... "no bubble on the dash" ---> immediate no mod status.
×
×
  • Create New...