Jump to content
SAU Community

Recommended Posts

I hate 3 spokes, but those are nice. Good job on picking the only set in existence :)

dual exhaust is fat!

Y eah I wouldn't mind re-barrelling them.

I mean what make is it lol.

Yeah sorry mate. As far as I know they are custom as is the rest of the exhaust, but I'll have a look on the mufflers to see what brand they are.

Yeah I love the 90's flavour.

I'm thinking about changing the exhaust but the wheels are growing on me.

exhaust looks mean...wheels are fine but need fatter rubber...

you will find its cheaper to buy new enkeis than it is to rebarrel old ones btw...

A few pictures of my 33, not everyone's cup of tea but I love it. (Not sure if I've posted some of these before)

Mexipoke 15x10j-26 all round, exhuast dropped at diff (no mufflers/decat)
cymera20130318185258.jpg
cymera20130117210752.jpg
cymera20130202012526.jpg
Vanquish Roof spoiler
cymera20130123142446.jpg
cymera20130312050613.jpg
Edited by Autumn33

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • So....to find any R chassis part number, get your VIN (will be something like ER33-xxxxxx for you) and go to: https://www.amayama.com/en/genuine-catalogs/nissan and enter it. From there you have access to a web version of Nissan's part system, FAST. It is a bit tricky to get used to, so maybe have a shot and post up what you think.  You can also search by general model but note in some cases your car might have different options so VIN is safest.  On diagram 211 I got 14075-75T16 for Connector, Water Hose If I search for part 14053‑21U10 that you posted, that is also a water hose but not the one bolted to the plenum and 14075‑04U00 is the fitting where the water hose goes into the block.
    • Yeah now we are talking I much prefer coolers in the front middle because it lessens the chance of a small bump to a corner stopping the whole event. I was thinking the AT cooler can move out of the radiator, delete the AT/engine coolant interwarmer and mount a separate cooler with a thermoswitch somewhere further back as is common in racing, that would be one thing. Beyond that, the engine oil cooler is an obvious one to move to the wheel arch, potentially one on each side, but unused space is an issue. I did have a earlier pic with the bumper off but it doesn't show how busy the corners are: DS is full of the auto driving sensors and PS is totally fully of windscreen washer fluid reservoir But ultimately I was hoping to keep the AC, and the water/air heat exchanger is fundamental so it is not just the radiator that needs to be in front BTW here's airflow to the rad as it ran at the track (one horn is gone now and I'll remove the lights next time):
    • your right the maps for Australia came out in 2017 but are 2010 maps. i got the updated maps SD card put it in and it was the same. Same maps in my Brothers Nissan Patrol. 2020 i think his car is
    • Yeahhhh, the costs have killed me. Spent more than the cost of an engine rebuild and it most mostly servicing and a tune lol.
×
×
  • Create New...