Jump to content
SAU Community

Recommended Posts

Hey guys, I was in manly all last week for work. Saw heaps of skylines, was in heaven. Best of the lot, on monday 1st march bout 4:30 ish saw a silver r34 GTT cruising along north steyne. Looked excellent and extremely clean.

hey i think that was me....if it had the stock rims and an hks front mount, thats my baby.

hey i think that was me....if it had the stock rims and an hks front mount, thats my baby.

Its a very nice car. I dont think you've met my gf, but she likes your car a lot more than she likes mine.

I saw 2 skylines in a row drive past harbord shops today at about 5pm. I think they were both s1 gtsts, one had a gtr wing and a wierd rear bar.

I also saw a silver s2 gtst (which reminded me what my car use to look like) heading north on the harbour bridge at about 3pm. I was up the top of the bridge being very romantic taking my gf on the bridge climb.

I was the one wearing the grey and light grey jump suit if anyone spotted me :wavey:

Hey Mark,

Ya i've actually met your gf before. It was sometime last year. Your car will beat my car any day. Such a sweet ride especially w the carbon bonnet. How does your car look now? I haven't seen you in ages. Are you living back here in the northern beaches.?

Spotted: CRAVED!!! :P  Heading towards dural on boundry rd.... was stuck in traffic going the other way....and you were too close to the car in front for me to see who you were till the last minute!!!!  i waved after you'd gone past! :D

ha cool thats my mate :)

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • Update: tested my spark plugs that are supposed to be 5ohms with a 10% deviation and one gave me a 0 ohms reading and the rest were 3.9ohm<, so one bad and the others on their way out.
    • 9" wheels are a little too wide for a RWD 32. They can fit. People have put R33 GTR wheels on 32s for years and years. But they are a very tight squeeze. This has been known for about 30 years. As I said - there is no difference between a 17 and an 18 in terms of what will fit. The rolling diameter needs to stay about the same as stock - not very much larger. If you increase that, you will start to have problems. If you increae rolling diamater at the same time as yo increase width, you will have problems earlier. as 9" wheels are pushing the boundaries already, you would need to be careful with tyre choice. I would put 8.5s on the front of mine, but would expect problems with 9s.
    • post up screen shots of your injector tables
    • Diagnostic flow for a code 21 says check signal at the ECU pins, on a voltmeter of some kind it should read 0.1V at idle, 0.12V cranking, 0.15-0.25V at 2000 rpm. Check each coil such that +1, -3 is infinite or very high resistance, -3, +2 should do the same. (-1, +3), (+3, -2), (+1, -2), and (-1, +2) should all be somewhere between 0 ohms and high resistance. If you trace the path from the coil pin all the way back to the ECU in the diagram the resistance you measure at the coil vs connected to the harness should be pretty much the same. 
    • I have an elite 2500 running an adapter harness on an rb25de neo r34. I took the butterfly out and removed all that junk. But I also went Plus+t at the same time. The butterfly thing works in reverse to the boost solenoid on the Gtt if that makes sense
×
×
  • Create New...