Jump to content
SAU Community

Recommended Posts

or maybe she just wanted to be spanked cuz she was driving a 33 ???

Good call Gus :devil:

Curves! 33's have their own post code......... like yo mama

(jokes)

Curious tho ~ What's the ratio of girls driving 33's in comparison to 31,32,34 +35's ?

Edited by Sinista32
Link to comment
https://www.sau.com.au/forums/topic/30059-spotted/page/528/#findComment-4340058
Share on other sites

Spotto'd Gus (I think) in Jerrabomberra today, and a Bayside blue R34 GT-t on Erindale Drive this arvo, and spotted Rumble in Braddon tonight, as well as a few other R33s and 2 R34 GT-R in braddon as well.

Link to comment
https://www.sau.com.au/forums/topic/30059-spotted/page/528/#findComment-4343277
Share on other sites

Spotted a white R33 with black bonnet driving up Northbourne near Dickson... I was in stealth mode in the Audi :D

Also saw a whole heap of tossers driving round and some copper in an undercover white Falcon pulling over some crappy old car.

Looking forward to this crap being over and Flemington road opening again.

Link to comment
https://www.sau.com.au/forums/topic/30059-spotted/page/528/#findComment-4344296
Share on other sites

Spotted Erica's GT Forrester " Mrs GT" and a whole bunch of others in Braddon. Most of the street is Domminated by parked Mustangs, a few Hot Rods and of course the Subaru wagons.

Still looking good J + E :happy:

Bayside Blue Phat 34 at QIX Fyshwick.

PS. Looked like your 31 was on the street Blueprint ?

Edited by Sinista32
Link to comment
https://www.sau.com.au/forums/topic/30059-spotted/page/528/#findComment-4344496
Share on other sites

aww you didn't see my car Richard? :blink: I was only a few back from Bluprint

It was cloaked in invisibility, Did you have it switched to stealth mode again? I was probably looking at cute distraction at the time :happy: sowwy.

Edited by Sinista32
Link to comment
https://www.sau.com.au/forums/topic/30059-spotted/page/528/#findComment-4344941
Share on other sites

Spotted a white 33 GTS-T last night at about 9.30 on Ballumbir Street in Civic. It had chrome rims, a black(painted, Im pretty sure) bonnet, lowered with a pretty blond in the passenger seat and a young fella steering. I think it was the same one I'd seen parked in Lonsdale Street earlier watching the 'Nats merriment. Anyone on here?

Link to comment
https://www.sau.com.au/forums/topic/30059-spotted/page/528/#findComment-4345043
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • Yeah, nah. I had the actuator rod off it today. The arm will not move at all. Neither out, nor in. Yeah, you'd think so, but I've been thinking about that. Even when the actuator rod fell all the way off at the beginning of this saga, it would build more boost and faster in lower gears than it would in higher gears, and you'd think that that was the opposite of what should happen. But I strongly suspect that there is a thing with the gearing getting the revs to rise faster, that there must be some transient effect with the gas flow rate rising quickly, that you don't get with the more steady state case of the higher gears. Keep in mind - the gate is not shut in either of my weirdnesses. So things are not "normal". We normally think about a turbo spooling up (below the wastegate target) with the gate shut. I have all sorts of mental models running now where the gate is a little bit open, and having it stuck open allowing gas out while it should be going through the turbine has all sorts of weird effects (in these mental models). I'm thinking in the higher gears, the ex mani pressure builds to the point where enough gases spill out the wastegate to just prevent the pressure rising much more at all, or just creeping up, all the whole the revs are increasing and getting closer to the point where a gear shift becomes necessary.
    • Is it possibly wastegate actuator itself is sticking, or even the rod to flapper? Otherwise I reckon things are getting a bit rusty/worn   Also odd it won't boost in 3rd to 5th, but will in 1st, I'd expect the other way around with it slightly open as there's more time on your way to redline for it to spin up
    • Does anyone know ow what these two plugs are for and if they should be unplugged? Just put the dash back together and can't remember if these were plugged in before or unplugged! (Blue and white plugs) 🤦🏽‍♂️
    • Did some FASTing ...got the impression that the actual part# was a moot point ; seems all of these hardlines for coolant are discontinued/NLA... like, I take it you're after the hardline that bolts onto to the manifold...that's NLA according to amayama & nengun .... ...just to clear up some confusion, they typically mounted the AAC valve to the intake manifold somewhere near a coolant passage, so the body of the valve heats up & holds it open when engine's up to temp - no coolant flows through the valve, it's a mechanical, thermal connection.
    • And now the bloody flapper is jammed slightly open. Lazy as all f**k in 3rd-5th (very hard to convince it to make much boost before you run out of revs), but will make 12 psi in 1st, which shouldb't be possible with a 5 psi spring and controller set to <10 psi. Methinks I'm lucky it jammed where it did, rather than fully closed. It's actually a well weird situation. Careful examination of what's happening in the back of that housing when the gearbox comes out and all the other stuff (injectors, AFM retune) is supposed to be done, next week.
×
×
  • Create New...