Jump to content
SAU Community

Recommended Posts

Safe to say everyone loves coronas

not really... there are plenty of "too cool for schoolers" that say it's shit...

however NOTHING beats Augustiner Brau helles... problem is due to not being able to meet production demands as it is..... it's not sold ANYWHERE outside of bavaria :down:

hame thats a fair intake of alcohol mate. might wanna watch that

/medical brain

everyone loves corona yes, but you gotta use lime. lemon is for wimmin. others that are on my regular list are asahi, beez neez, little creatures pale and golden, james squire, becks, bluetongue (white rabbit is pretty similar to this too), heineken, boags. guiness goes down a treat too

i try to drink something new as often as possible. dont drink spirits as much nowadays but partial to a bit of CC and Hennessy. can not even smell vodka after a certain incident a couple of years back lol

lol @ corona fags, enjoy your bland tasting beer that tastes like the fruit stuffed into it, or nothing at all :down:

german beers ftw! (and yes I am aware that most of them taste very similar lol)

been liking Cascade atm as well, tastes a bit like a microbrewery beer

Other then that, I usually go for Bourbon or Vodka or Scotch.

+1

stocked up my fridge with coronas, crowns, scotch and vodka for my 18th, none left by the end of the night lol

nothing beats a beer on a warm day though

boz- james boags isnt that bad either,

but u almost forgot

NOTHING will EVER top ouzo from Syria. lol when i went last year, i dont think there was a day where i was sober

Edited by Mohsen
Safe to say everyone loves coronas

too many metro fags in here. Drink a VB and get some hair on your chest :down:

German beer is win. Especially the 500ml standard size, was hard swapping back to regular 300ml size :P

Going back to Germany in November, so can enjoy the goods once moar!

People who say Boags is a good beer are kidding themselves :down: I worked there for two bottle line upgrades, and I can't stand the stuff! That's all they sell in Launceston. Even Irish pubs have excessive amount of Boags on tap :P

Good beers for me are:

James Squire Amber and Golden Ales

Weihenstephaner (Dunkel, and the one with the blue label)

Paulaner Weiss Bier

Matso's Mango Beer (It's a microbrewery from Broome)

Hoegaarden (Must only be from tap)

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • So, this shouldn't be such a mission, but there were a few tricks so I thought I'd post up a DIY for it. This was on a Q50 Red Sport but I doubt any other V37 model is very different (maybe just less steps for the intake heat exchanger hoses) I pulled the radiator out to flush it because the car was running hot at the track, but obviously the same steps apply for changing a radiator for any reason including an upgrade. If you are removing the radiator, you of course need to drain and refill, so have 5+ litres of blue coolant ready. You don't need to drain the intake heat exchanger to remove the radiator but depending on your plans you may need a couple of litres for that as well. You will also need something to deal with the auto transmission lines, I used 2x 8mm rubber caps on the radiator side, and a short length of 8mm pipe on the car side.....unless you can block these lines quickly you will loose AT fluid and it may be enough to hurt the transmission if you don't refill it. Other than that....lets go... "First, jack up your car". Yes really, and put it safely on stands. If you are not confident doing that you need to give this job to a mechanic
    • If the forester is anything like our old 2007 GTB Liberty, I could near on run ling Long's and "rate them", as no matter what, it just hung to the road, even when abusing it in a hard launch in the wet, or throwing it at corners.
    • LOL, all of the CAI like Craig I just need to put a hole saw through my bumper Done and dusted, the car runs, which is nice, I'll take it for a spin when the weather clears up Just need to put the bumper back on for good
    • Brooooo Please send ABS control unit schematic Please! R33 gts25t ABS (Its two plug ecu, black and white) wire colors possible? [email protected]
    • Don't even try to run it on the stock ECU if you're going to have the boost controller bring boost above ~10 psi. I've already told you that. If you use the Nistune ECU, you will need to CAREFULLY read the available documentation for Neo tuning, and read some threads on the Nistune forums, to discover the various things you have to do to prevent the ECU from going bananas when the boost is too high. The is a table associated with th boost sensor that must be modified to prevent it from shitting the bed. This is just one of the things that you will need to do to the tune in Nistune, because the Neo turbo ECU will be expecting to see a number of things (such as the TCS) that are not there, and you have to block the DTCs on those. It is totally not surprising to me that you are having the problems that you are, but the solutions to these problems have been known for >15 years. So just get it done.
×
×
  • Create New...