Jump to content
SAU Community

Recommended Posts

Getting

-5's Garret

Tomie Dumps

Blitz front pipe connected to existing 3inch Nismo CAT

Custom Exhaust Back 3inch to twin pipe tip

Boost contoller

Adjustable Cam gears

Get 3.5" exhaust from the cat.

Your looking at about 350-370 rwkw from what I have read - depending on boost / tune etc.

Some people get cams, not necessary but may be something to think of when doing it all at once.

Happy with 300 at the moment. Got to get used to it :thumbsup:

When engine needs rebuild then re-tune for 400 with fuel pump etc.

You will get use to it very quickly, thats whats funny about GTRs because of the 4 wheel drive it will grip and just go, whereas if you have 300rwkw on a RWD car on street tyres and go to say 400rwkw.. it wont feel that much quicker simply just spin the wheels more than it did before :P

Be careful though, moreso in the wet - GTRs can still get VERY sideways.

Do the 33 Moh...much more reliable and an all round better built car. When you drive both side by side you'll see that. It's like when I drove a 34 after driving my 33...the difference in build is quite noticeable. Newer cars are almost always better in terms of an overall package.

As for looks...well yeah that's totally subjective, but there's a reason R33 are so common...whether the R32 fanbois like to admit it or not, they are received as a good looking car. I get the feeling a lot of people hate them purely because they are so common.

The R32 may LOOK better to some, as this is very subjective but no denying the R33 is the better car. And the 32 Interior is aids duno anyone who prefers it over R33 interior.

Excited to get my car back tonight after tune (status).. base dyno run was 238rwkw so only 5 off the racepace dyno so pretty much spot on when you take into account temp / baro preasure etc. I'll be happy to see anything over 260rwkw anything over would be a bonus for me, hopefully a lot more power early in the rev range as well.

only 32grts look better.

only 32grts look better.

I WAS going to get a 32 GTR.. but realized whats the point for the same price you can get a car up to 9 years newer and like I said the interior is AIDS! Very hard to find a clean 32 these days as well.

Hmmm it isn't that serious Atm so something that isn't all like omfg I love you would be pretty nice.

don't get her anything? just leave the toilet seat down as a thank you the next morning.

Too laggy for a street car.

They are utterly useless below 150km/h, -9s are faster to 150 - I can promise you that.

You also notice the lag in/out of gears massively.

Its now a case of pushing really hard up through Kinglake etc as there is so much lag coming outta corners.

stock dumps will be ok as well.

i had stock R33 GTR dumps, made 340rwkw outta -9s on a full build.

spent $600 on tomei when i put on -5s... all that changed was the exhaust note.

power/result was the same as other -5 equipped cars with factory dumps.

need 3.5" exhaust @ a min though, and big front pipes

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • Have you done the Ignition Sync Wizard in the AEM software?
    • Find out what RPM it was idling at with the IACV unplugged. It's very weird that the rpm didn't change at all, and then it stalled. When it stalls is it nearly like a switch off, like you've turned the engine off? Or is it more stutters and sputters and coughs to death over a few seconds? Or does the RPM just slowly keep going down and down? Have you done a test of trying to start it with the AFM unplugged? Does it still die?     If you Follow Josh's advice on using Nistune to check the voltages (which is a perfect method!) if you see anything out of wack voltage wise, THEN get the multimeter out and read the voltage directly at the sensor. If the two vary, then you're now looking for a wiring issue vs a sensor issue. So be aware, what the ECU sees, may not be what the sensor is actually saying too...
    • You very likely need to get it on a dyno and tune it. My assumption is, you've got an RB25DET tune in it, which has a different manifold, different injectors, and different cams as a minimum. What O2 sensor are you running?   When you say it runs extremely rich from idle all the way to redline, is this just free revving it you see that?
    • I seem to the be only person that is using a Haltech 2500 on an NA motor, I've installed a Bosch DBW throttle body to the OEM intake manifold and am having problems maintaining AFR even with the wideband o2.  It will run extremely rich at idle and up to redline, but under load it will go extremely lean in the 20s and i'm essentially having to rev it over 4k and feather the clutch to get it up to speed.  I've read a few other threads of about the butterfly, it seems removing the vacuum to it is supposed to have it remain open, i've noticed no difference under 4k with the vacuum line to it plugged.  I'm hoping someone here has had luck using the NA manifold with Haltech, and if they happen to have a tune for it.  
    • I don't know any details, but I really wouldn't be surprised if they do it as a LHD only version, at least initially.
×
×
  • Create New...