Jump to content
SAU Community

Recommended Posts

Be kind to Jason, the poor bugger might have a poor set up on the rear end of his car.

Have you had a wheel alignment since you have owned the car and if so what was the rear camber?

I would be having a good close look at that first as excessive negative camber made mine a pig in the wet when it landed ex-Japan.

  • Replies 44
  • Created
  • Last Reply

Top Posters In This Topic

I reckon get better tyres & fix up the factory camber.. I could smash the pedal on my old 250rwkW R33 in 3rd in the wet and it would barely spin

I was running -0.8mm camber either side (couldn't make it any more neutral) and 255 Kumho KU31 SPTs pumped up to 38 psi and toed in 0.5mm either side.

learn throttle control in the wet lol, I can drive with the shitest tyres that were 100 a side and with 270kw I can make it not slide in the wet just control your foot.

thx man i will

Easy fix. Buy Nismoids Laser and learn Gary's foot control. You will be the bane of wet roads. I can just see you taking corners at 20, 30 or even deadly 40's

lol

Lasers are a lot of things.....cutting edge isn't f**kin one of them!!

I'd argue there. It was the only car that didn't require servicing I've ever known of...

About 18months, drove it within an inch of its life for around 35,000km's and not once did i spend a cent other than petrol :P

I reckon get better tyres & fix up the factory camber.. I could smash the pedal on my old 250rwkW R33 in 3rd in the wet and it would barely spin

I was running -0.8mm camber either side (couldn't make it any more neutral) and 255 Kumho KU31 SPTs pumped up to 38 psi and toed in 0.5mm either side.

this cant be right. i run same kumho's in 265 @38psi. rear camber is -1deg. around 220kw, smash the pedal in 3rd in the wet, and it's on for young and old.

Edited by Munkyb0y
hi all. im totally new in skyline sense.

coz the weather recently , i found my car is really slippery in wet. although in 3 gear around 3000rpm, it still can go side way on a straight line accelerating.

is it normal?

i ve checked my tyre, still in good condition. i was just worrying is it because any inappropriate setting

R33 GTST SeriesII

190kw at 12psi

Falken tyre: F235 R255

thx :P

dude get an alignement good wet/dry tires and dont put your foot down so hard

Put a pair of space savers on ur car and try to negotiate round a bouts in the rain.

I can say this because I'm not on the same roads as u. Maybe u should warn the locals though.

My first car was an 89 ke laser. I loved it. Couldnt kill it. I dont know how it survived untouched

thx man

so which brand r u recommended ?

There's a sticky thread about which tyre to choose. A lot of the higher performance tyres are designed to be great in dry weather and not so good in wet weather.

Look at the street tyres if you want something decent in wet weather, but you should be driving every carefully in wet weather with any tyre, otherwise you won't have the car long...

I second that. Ease off the throttle a little more and granny drive more in the wet regardless of what tyres you run in. Wet = less traction, less traction = less control in an emergency. I throttled harder than normal at the lights once in the wet and my wheels lost traction. I eased off, grannied for the rest of the trip and all was fine again.

There's a sticky thread about which tyre to choose. A lot of the higher performance tyres are designed to be great in dry weather and not so good in wet weather.

Look at the street tyres if you want something decent in wet weather, but you should be driving every carefully in wet weather with any tyre, otherwise you won't have the car long...

He's asking about trying to do the safe thing and get more grip which all of us should be pushing to make sure we have as much control over our cars as possible. He's not some idiot asking to make it easier to fish tail everywhere all the time cause its 'cool' to be a duche... so easy up on the comments on someone who is new and hes trying to do the RIGHT thing.

I had something like this when I first got my line, had a good/expensive set of Potenza's on there and had brillant grip in the dry but as soon as it was a little wet it was bad always loosing traction even under 10kmph/1500-2000rpm if the road was slippery enough.

Check your tyres, there are different types of tyres i.e. ones that perform better in dry/wet situations. Also, check or get your suspension checked out, I had stockies that had tighter springs on the front, therefore making my car dip at the front so the rear was really light and liked to jump around. If your suspension is really worn then this also explains why your having issues with grip as when you loose grip your suspension is suppose to apply force and help hold your wheel to the ground so you have contact with the surface, obviously the more contact you have, the more grip you have.

After I changed my suspension setup + tyres to my liking, I've been in complete control at all times unlike before.

Also, (try this as a temp) if your tyres are pumped up a lot say 38/40psi try lowering them to 33/35psi as the tread will hug the road more meaning you'd have more grip.

PS you may not think of it this way, but getting more grip means the power your engine is making more of it will be going to the road meaning you will be making more power safely. :)

lol

I'd argue there. It was the only car that didn't require servicing I've ever known of...

About 18months, drove it within an inch of its life for around 35,000km's and not once did i spend a cent other than petrol :)

I blew the head gasket 3 times in mine and the 4th bottle of sealup didn't fix it. Apparently it doesn't seal oil gallery vs cylinder leaks....only water ones.

I got $40 for it in scrap metal. Well worth it.......still not cutting edge

He's asking about trying to do the safe thing and get more grip which all of us should be pushing to make sure we have as much control over our cars as possible. He's not some idiot asking to make it easier to fish tail everywhere all the time cause its 'cool' to be a duche... so easy up on the comments on someone who is new and hes trying to do the RIGHT thing.

I had something like this when I first got my line, had a good/expensive set of Potenza's on there and had brillant grip in the dry but as soon as it was a little wet it was bad always loosing traction even under 10kmph/1500-2000rpm if the road was slippery enough.

Check your tyres, there are different types of tyres i.e. ones that perform better in dry/wet situations. Also, check or get your suspension checked out, I had stockies that had tighter springs on the front, therefore making my car dip at the front so the rear was really light and liked to jump around. If your suspension is really worn then this also explains why your having issues with grip as when you loose grip your suspension is suppose to apply force and help hold your wheel to the ground so you have contact with the surface, obviously the more contact you have, the more grip you have.

After I changed my suspension setup + tyres to my liking, I've been in complete control at all times unlike before.

Also, (try this as a temp) if your tyres are pumped up a lot say 38/40psi try lowering them to 33/35psi as the tread will hug the road more meaning you'd have more grip.

PS you may not think of it this way, but getting more grip means the power your engine is making more of it will be going to the road meaning you will be making more power safely. :rofl2:

tl;dr

this is no place for serious posting :)

Actually erderr, keep tyres pumped UP, or even UPPER, in the wet. It holds the tread open so it can shed water better.

Back to the OP - what suspension do you have? If you have Japanese "coilovers", the suspension will be quite stiff. This does not allow good weight transfer on acceleration, and the drive wheels will lose traction in the wet. I had a 240Z with VERY stiff rear springs - in the wet, I could spin wheels DOWN Mt Jane (Calder).

I don't know a single person with 190-200rwkw (because they usually have factory turbo still fitted) that can stop it from wheel spinning past 3k in the wet. Tyres will help, wheel alignment will help suspension will help.....it's always going to spin in the wet if you put your foot down.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • After my last update, I went ahead with cleaning and restoring the entire fuel system. This included removing the tank and cleaning it with the Beyond Balistics solution, power washing it multiple times, drying it thoroughly, rinsing with IPA, drying again with heat gun and compressed air. Also, cleaning out the lines, fuel rail, and replacing the fuel pump with an OEM-style one. During the cleaning process, I replaced several hoses - including the breather hose on the fuel tank, which turned out to be the cause of the earlier fuel leak. This is what the old fuel filter looked like: Fuel tank before cleaning: Dirty Fuel Tank.mp4   Fuel tank after cleaning (some staining remains): Clean Fuel Tank.mp4 Both the OEM 270cc and new DeatschWerks 550cc injectors were cleaned professionally by a shop. Before reassembling everything, I tested the fuel flow by running the pump output into a container at the fuel filter location - flow looked good. I then fitted the new fuel filter and reassembled the rest of the system. Fuel Flow Test.mp4 Test 1 - 550cc injectors Ran the new fuel pump with its supplied diagonal strainer (different from OEM’s flat strainer) and my 550cc injectors using the same resized-injector map I had successfully used before. At first, it idled roughly and stalled when I applied throttle. Checked the spark plugs and found that they were fouled with carbon (likely from the earlier overly rich running when the injectors were clogged). After cleaning the plugs, the car started fine. However, it would only idle for 30–60 seconds before stalling, and while driving it would feel like a “fuel cut” after a few seconds - though it wouldn’t fully stall. Test 2 – Strainer swap Suspecting the diagonal strainer might not be reaching the tank bottom, I swapped it for the original flat strainer and filled the tank with ~45L of fuel. The issue persisted exactly the same. Test 3 – OEM injectors To eliminate tuning variables, I reinstalled the OEM 270cc injectors and reverted to the original map. Cleaned the spark plugs again just in-case. The stalling and “fuel cut” still remained.   At this stage, I suspect an intermittent power or connection fault at the fuel pump hanger, caused during the cleaning process. This has led me to look into getting Frenchy’s fuel hanger and replacing the unit entirely. TL;DR: Cleaned and restored the fuel system (tank, lines, rail, pump). Tested 550cc injectors with the same resized-injector map as before, but the car stalls at idle and experiences what feels like “fuel cut” after a few seconds of driving. Swapped back to OEM injectors with original map to rule out tuning, but the issue persists. Now suspecting an intermittent power or connection fault at the fuel pump hanger, possibly cause by the cleaning process.  
    • For race cars, this is one part where I find having the roll cage bar having gone through a hole in the floor better than the build it up on a ledge inside... The Merc I help on, the main hoop ends are marked on the car, and the jack is marked... Jack goes under a few inches and lifts one whole side of the car up... Removes that fight for long slim jacks for race car duties!   My biggest issue for the daily drivers I work on, is my jacks don't go high enough. The jacks start out on a few blocks, jack it up, then start a second jack under it on more blocks, and then I can get an axle stand under it. My axle stands are presently in use, and are nearly fully extended. The car is sitting with barely more than a cm of clearance to get the wheel off the studs! Sarah's Kluger is the same, as it has an ungodly amount of droop available in the suspension and a distinct lack of good jacking points!
    • Happy? Yep, my to do list is getting shorter and shorter. Either this light approaching is the end of the tunnel, or I'm about to be hit by a train... Ha ha ha   Also, Duncan isn't that far out of town that you need to make a multi day drive out of it. 😛
    • Sorry I meant that we are building the EH for a client.
    • LOL, when one "money pit" is never enough Noice, and excellent work mate
×
×
  • Create New...