Jump to content
SAU Community

Recommended Posts

Yep, they were originally copied off some imported mats I think but they now curve around all the floor bulges and the drivers one has the hole for the clip.

The rear cargo didn't go up the back of the seat as they couldn't work out how to hold it there. I didn't want the metal clamps I have seen on the JDM mats so I left mine as only the floor.

Edit: I did tell them they could drape it over the top and have the headrest bars go through it, they could possibly do that if you wanted but I would have to go and get my car remeasured for you.

want me to take a photo of my boot mat ??? they have plastic tab's that fold into the back seat, not perfect but pretty good.

passenger side HID died last week, bought aftermarket replacement pair (8000K) for quite cheap, took an hour to fit both plus new LED parkers since i didn't have access to hydraulic jack & had to figure out how many clips/screws i had to take off the plastic guard...

would like 5000K but seller only has 8000K for now

next to do: paint rear spoiler, fit new phillips 80+ bulbs for the fog/high beam & fit new spoiler once painted

While fitting the V35 mid pipe today I discovered the typical M35 cam cover leak. Must have just started as wasn't there last month.

Is it very bad? I discovered a few drips on some bolts when I was changing the turbo & ordered a gasket. But now that I'm driving it again it doesn't look too bad so may put it off for a while.

Any chance you have the part number handy?

Cheers

Sure, 13270AL612 Passenger side cover gasket & 13270AQ800 – Driver side cover gasket.

I only bought the passenger side & it was $28 but can't see why they would be different prices unless 'supply & demand' rules apply. I've heard they can be bought for as low as $25 - i wasn't going to quibble over 3 bucks.

1999 NISSAN STAGEA 260RS

post-83989-0-67350100-1330845554_thumb.jpg

post-83989-0-49862600-1330845537_thumb.jpg

post-83989-0-38822000-1330845571_thumb.jpg

post-83989-0-64287100-1330845506_thumb.jpg

stageawing.jpg

The only mods apart from a fresh engine is

hid boost controlla

gtss turbos

tomei dump pipes [so fu*#%n expensive but worth it]

n*power y pipe

200 cell cat then 3inch pipe into a 3inch cannon

nistune computer the computer makes a diffrence

i also have a catch can being made for me by a friend [keep cost down]

and i have jc forge pistons

ajustable cam gears

walbro 400lph fuel pump

arp stud kit

nitto gaskit kit

and just made this wing

Edited by R33huntme

While fitting the V35 mid pipe today

And how is the mid pipe :thumbsup:

No problems clearing that centre body brace by the transmission tunnel? Mine still clonks occasionally, must get underneath the car and loosen, wiggle and tighten some time...

And how is the mid pipe :thumbsup:

No problems clearing that centre body brace by the transmission tunnel? Mine still clonks occasionally, must get underneath the car and loosen, wiggle and tighten some time...

It fit up easily and only had to reshape the heat shield around the tail shaft a little by hand. No knocks or noises. Exhaust note is a little nicer now as I can actually hear a nice little burble but still very quiet when on cruise. Power wise I have noticed a slight increase but not huge, as to be expected. Still need to change the front pipe to a 3" with high flow cat.

I was able to sell the rear muffler from the v35 for $25 so that's dropped the cost of the mid pipe to only $75! So good cheap upgrade.

Oh and the m35 mid pipe is bloody heavy compared to the v35.

Just a quick update on the v35 mid pipe upgrade I did. A bit of good luck for me. I payed $100 for the complete exh comprising of exh manifolds to rear muffler. Fitted the mid pipe to my m35, sold the rear muffler for $25, took both the cat converter sections to recycle yard and got $120 for the pair and then $2 for the rest of the exhaust for scrap metal.

So after all that my mid pipe was free and gained $47 on the deal.

Best bang for buck mod I've done yet!!!

Just a quick update on the v35 mid pipe upgrade I did. A bit of good luck for me. I payed $100 for the complete exh comprising of exh manifolds to rear muffler. Fitted the mid pipe to my m35, sold the rear muffler for $25, took both the cat converter sections to recycle yard and got $120 for the pair and then $2 for the rest of the exhaust for scrap metal.

So after all that my mid pipe was free and gained $47 on the deal.

Best bang for buck mod I've done yet!!!

Scott! Sell all those rusting stock zorst in your yard!!!

Paul, that story is just so full of win!

OT - got my car ready for dyno tomorrow - packed up parts to install and Lappy, topped off fluids, got into skidz mode and left my drill at teh workshop :glare:

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • Seat of the pants assessment of the new intake: The car is way less "doughy" when hitting the loud pedal, especially off idle when stopped or in traffic, I did use a cheapo lazer thermal thingo to measure the temp around where the pod filter got its air, it was between 55 - 60°C, in saying this the car was shut off and not moving, so the OEM intake pipe was not supplying any fresh air to where the pod was when the car was at least moving A weird bonus was induction noise on the throttle in the cabin increased a bit,  I was worried that I was actually going to lose some of that induction noise I love so much, outside though, when I got the daughter to do a WOT drive by pass for me, the induction noise has increased alot when on the throttle, not quite ITB doort, but well up there I'm extremely happy with the results and have been exploring the country roads in the region  As for house mods: 1.New front fence is up and is awesome, it really upgraded how the joint looks from the street, and the added security is nice 2. Electricians have replace some interior lights, and with more lighting in the garage, a few new motion detecting lights out the front above the garage, front room, and at the front door, which I have already found heaps helpful coming and going, also now has fancy pants CCTV all round the house The only hold point for power though is the solar and batteries due to supply issues, although this will happen over the next few weeks 3. I have done a heap of landscaping out the front and I'm almost ready to do a new small retaining wall with some nice blocks to replace the brick and cemented in rocks around the raised garden beds cemented in river stone "was the fashion at the time" the house was built. I currently have a pallet of retaining wall blocks and 2 bulka bags of 20mm blue metal to replace the wood chip that is in the raised garden beds around the house 4. I now have 3 big raised garden beds for out the back to grow some vegetables, about 70cm high, 200cm long and 100cm wide 5. My 2 compost bins are already pretty full with brown, green and kitchen waste from the landscaping I'vedone so far, but they will probably take a few months to break down, so anything else that gets chopped, trimmed, and kitchen waste will just start filling the base of the raised garden beds to about 30cm before I start throwing 40cm of good compost, and stuff, for the vegetables to grow in, I'll need a few ton of compost and soil, but the local supplier can sent me bulka bags of the stuff Basically the logs, wood chips and a few strategically placed rocks for drainage, will give the beds some good organic materials down low to break down over time, and they will hold moisture during the warmer months to save the water in my big arse water tank if we don't get alot of rain So, all in all, the car and house mods are going well, and I'm really enjoying being retired, I sleep in too 0700 and slowly plod around inside until I feel like actually doing anything, and only work in the yard for as long as want, which has actually been alot over the last few weeks,  although when you look at it, it seems that not a huge amount of work has been done,  until I look at the before I started the work pics Happy days and good times indeed 
    • hahaha yeah. Plan is to get side skirts and probably just rear pods. But going to do them one-by-one. I've got a set that I really like from RHDJapen, but that one isn't shipped to AU. So need to find someone who can get it for me
    • Here's an idea, answer the questions I asked you as they are trying to work out WHY the LSD will be binding up in a straight line.
    • You haven't driven many modern cars then have you? Most of them have sfa steering feel with their stupid electric bullshit steering systems.
×
×
  • Create New...