Jump to content
SAU Community

Recommended Posts

Yeh grant spose drive it till it dies sell what parts I can and thatll be that

Unless someone wants it without a rwc but for 7-10k cars it's not worth spending 1-2k on a rwc unless ya cash strapped I spose

Don't you work inside Grant?

Every time I walk into Coles on a hot day its actually quite a relief, nice and air conditioned!

Yes I work indoors, but when you're working, pulling the pallets/stubborn cages on hot day, AC might do its job, cos I sweat bit easily.

Working in dairy was ftw during summer...I actually got cold on 40 degree days! Also, f**k cages...when I first worked at Coles we had stock wrapped on a pallet and that's the way it should have stayed.

To continue the "what I really do" posters...

being-in-a-band-what-my-parents-think-i-do.jpg

Lost my shit at this one

garbage-man-what-my-friends-think-i-do-meme.jpg

Birds, I've been doing lots of pallet work lately, one thing I hate most is that DC often dump tinned fruit/vegs on pallets, means extra work dumping them into cages for others to do the filling.

How often do you have customers come up and try to ask you a question? Or do you usually work out back?

Depends, on average 5 customers a shift. Sometimes 20 sometimes none.

90% of thing I get asked is 'where can I find eggs'

lol, aren't eggs always next to milk? I'd think that would be an easy one.

Every time I visit a new supermarket I always need to ask where the protein shakes are at :3 health food sections are sometimes only a shelf big and they're always scattered >_<

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • So for the wide band is a Bosch 4.9 correct for the Link G4+ along with a Can bus? Just get the Link gear or is generic ok too? Eg here: LINK LINK DIGITAL WIDEBAND CAN MODULE WITH BOSCH 4.9 SENSOR : KYP Performance House  
    • Bit difficult to follow. Have a look below and see what the standard R32 layout was like. Note there was a restrictor in place immediately before "turbocharged pressure control solenoid" that, if removed, magically got you 1 bar boost.
    • I might be way off the mark here.. there must be a T junction under the manifold. That takes manifold pressure through a check valve prior to the T, one side splits out to this bleed off orifice, the other straight to the wastegate actuators. 
    • Carrying out some engine due diligence before my first drive in a 260RS that has been in storage for 10+ years, and found two lines that are susposed to be plumbed into the boost control solenoid. One of the lines (the wastegate boost supply line) to actuate the gates, had a bolt in one end blocking it. The other line (main boost signal line) from the very rear of the intake manifold (RB26DETT) and runs up to the boost controller had this pill in the end of it as seen in photos. Other than the obvious (T28 Ceramic turbos might well be cooked)  Can anyone shed any light on if there is any validity at all with this mod, bleeding a constant fixed rate of manifold boost pressure off through this 3mm hole?  Is it deliberate?  Was this a 90s Jap mod done to RB26's? Or has someone just fitted this without any idea of what happens to ceramic T28s if they are not gate controlled?    
×
×
  • Create New...