Jump to content
SAU Community

Recommended Posts

shoulda bought my rims bru.

moh should buy my rims the attention you'll get from biatch's might even get ya knob wet!

Didn't want too many ladies crowding around lol

Nah sizes a bit too hardcore for my soft coilovers / fondness for traction :(

Rims arriving Friday or Monday shiiiiiieetttt

same ones from the start?

Chinese...

HAHAHAHA

not as shit as these

Weds-Kranze-LXZ.jpg

mmmm i have a chub..

B_0865.JPG

your f**ked if you believe the kranzes are shit, those Volks look like factory evo 7 enkei's LOL

???

You overtook me on the fwy yeah? The bike had the blue parkers

Ahhh thought that was you. Yer slow Skyline in the right lane of the freeway :P

Now people can recognise me...not sure if good or bad lol.

Tsk tsk Patty going slow in the right hand lane

Also lol at Pat leaving 5 mins earlier but him stopping behind me at the Springvale Rd exit on the eastern Freeway :P

Dad is getting old, crashed his car. I think he had a minor heart attack or something mum told me his chest was hurting last night.

Stubborn prick still went to work instead of doc's

What a way to start the day

Tsk tsk Patty going slow in the right hand lane

Also lol at Pat leaving 5 mins earlier but him stopping behind me at the Springvale Rd exit on the eastern Freeway :P

Lol everything is slow to a motorbike. I had to go 120 to keep up.

Haha went through brunswick st for a kebab :P

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • Yep, the closest base tune available was for the GTT, I went with that and made all the logical changes I could find to convert it to Naturally Aspirated. It will rev fine in Neutral to redline but it will be cutting nearly 50% fuel the whole way.  If I let it tune the fuel map to start with that much less fuel it wont run right and has a hard time applying corrections.  These 50% cuts are with a fuel map already about half of what the GTT tune had.  I was having a whole lot of bogging when applying any throttle but seem to have fixed that for no load situations with very aggressive transient throttle settings. I made the corrections to my injectors with data I found for them online, FBCJC100 flowing 306cc.  I'll have to look to see if I can find the Cam section. I have the Bosch 4.9 from Haltech. My manifold pressure when watching it live is always in -5.9 psi/inHg
    • Hi My Tokico BM50 Brake master cylinder has a leak from the hole between the two outlets (M10x1) for brake pipes, I have attached a photo. Can anyone tell me what that hole is and what has failed to allow brake fluid to escape from it, I have looked on line and asked questions on UK forums but can not find the answer, if anyone can enlighten me I would be most grateful.
    • It will be a software setting. I don't believe many on here ever used AEM. And they're now a discontinued product,that's really hard to find any easy answers on. If it were Link or Haltech, someone would be able to just send you a ECU file though.
    • Yes sir am asking is there possible way from aem tuner from wiring pins 
    • Have you checked cam to crank timing and confirmed balancer marks are correct?
×
×
  • Create New...