Jump to content
SAU Community

Recommended Posts

  • Replies 7.5k
  • Created
  • Last Reply

Top Posters In This Topic

Top Posters In This Topic

Posted Images

you spend a lot of time going to different Macca's Amanda :)

i know LOL, but it is fun visiting different Macca's lol

i learnt 1 thing while i was at the Murray Bridge Macca's.

it's ALOT cleaner than any of the others i've been to, you actually

see them cleaning the floors at Murray Bridge haha

I see a gray stock looking 4 door r34 most mornings at about 7am on goodwood rd heading into town. anyone here?

Saw a white 33 GTR at Adelaide Pro Sound today, w Nismo stickers aswell as a Silver 33 GT

Saw a black R32 GTR turning right off sound road near Flinders.

-D

spotted a gtr with a magnectic p plate on the boot boost past me at glenlg last nyte... he saw me and my mates 33 turned around and blew past us again...

I saw him at the Bay today too. P plater GTR? Lucky guy!

Seen around last friday and on weekend a white 4 door (H)R30 with ubwet2 plates or something along those lines and a black R34 GTR today on killkenny road with NSW plates on it.........MMMMMMMMMMMMM gtr goodness

Where you in the cream 32 4 door at all? I was driving along next to a cream 4door for a while..

Ha! thought it was you! Yes that was my 33 you put the tyres on :(

Yeah, thats my g/fs car. If your 33 has mesh in the grille area then it was the same one!

SPOTTED

This morning on salisbury highway, 26/9 about 8-30am Whites R33 seies 1 with what looked like a 400R front bar and a wavy sticker from gaurd to rear quater panel..

Got a wave from him but was to slow to return the favour!!!

spotted today 2 x silver r33's, 2 x midnight purple r33's one with SAU sticker on the side window, a bluey coloured r33 with gtr badges, and a silver r34 with nismo front bumper

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • So for the wide band is a Bosch 4.9 correct for the Link G4+ along with a Can bus? Just get the Link gear or is generic ok too? Eg here: LINK LINK DIGITAL WIDEBAND CAN MODULE WITH BOSCH 4.9 SENSOR : KYP Performance House  
    • Bit difficult to follow. Have a look below and see what the standard R32 layout was like. Note there was a restrictor in place immediately before "turbocharged pressure control solenoid" that, if removed, magically got you 1 bar boost.
    • I might be way off the mark here.. there must be a T junction under the manifold. That takes manifold pressure through a check valve prior to the T, one side splits out to this bleed off orifice, the other straight to the wastegate actuators. 
    • Carrying out some engine due diligence before my first drive in a 260RS that has been in storage for 10+ years, and found two lines that are susposed to be plumbed into the boost control solenoid. One of the lines (the wastegate boost supply line) to actuate the gates, had a bolt in one end blocking it. The other line (main boost signal line) from the very rear of the intake manifold (RB26DETT) and runs up to the boost controller had this pill in the end of it as seen in photos. Other than the obvious (T28 Ceramic turbos might well be cooked)  Can anyone shed any light on if there is any validity at all with this mod, bleeding a constant fixed rate of manifold boost pressure off through this 3mm hole?  Is it deliberate?  Was this a 90s Jap mod done to RB26's? Or has someone just fitted this without any idea of what happens to ceramic T28s if they are not gate controlled?    
×
×
  • Create New...