Jump to content
SAU Community

Recommended Posts

Hmmm, i'm looking into getting one once my car is on the road.I am just going to box in my Pod filter.

In other news my o2 sensor, radiator hoses, thermostat and radiator cap arrived from kudos today so i'll throw them on tomorrow and do my timing and use your compression tester just to see how my motor is going.

An extra turbo, abs, etc...

No wonder they cost so much to do up, stuff would have to be custom made just right to fit in there.

but arent they wider?

engine bays are identical once stripped.

I wonder if its the same od as any copper pipe.

Then a plumber can silver solder in a new one.

Even put that lip on it.

Even if you get close, you can expand the pipe a little.

TBH what i might do is just leave it for the moment. When i did the water pump not long ago there was no corrosion in the block and now looking inside the block where the thermostat goes it's super clean, same with the new radiator. I'm sure it must be built in to be sacrificial. I need to running to get it to the panel shop probably next week to get it fixed up. Once it's back on the road I think I will just take it to a good radiator place and get the to do a professional fix on it. I flushed everything out anyway to be sure and pretty much all the bit of the pipe were in the hose. *sigh* nissans... fix one thing find another, at least i found it now and not when it exploded in the middle of summer.

Ring Andrew @ Kudos. The whole unit will either be $50 or $80.

Depending if inlet or outlet.

This be common across the entire Skyline range.

Has to do with silly Japs and the coolant they use (or don't use) and composition of the part.

Kasko had the same issue. Hammered in a piece of pipe.

John (Trojan) found the same with mine. Cleaned it up and reckoned it will be fine with proper coolant/distilled water.

Hmm - not like Andrew.

Tell him to pick his game up :P

haha yeah he was like "I have sent you GTR hoses by mistake, they are not going to fit at all"

He also said Nissan don't have that inlet piece as a serviceable part but said he would look around for me and get back to me with an answer for that as well as when he can get me new hoses. I might get my self one of those anodes as well. My drain plug comes from the side though, not the bottom so i would probably have to shorten the zinc rod.

Yep already spoke to Andy about it.

I ended up going to Nat Rad and they cut me up a bit of pipe that a bashed in.

Mine was super super rusted so it was easy to get out.

Andy explained me that he couldn't even remove his with vice grips.

So a little different to mine.

I have cleaned it up best I can, it's not super corroded so i will chuck the new thermostat in and get it running just so i can get it to the panel shop then as soon as it's out i'll take it to a shop who can get it out, replace it and do a proper job, i don't really want to cut corners on my cooling system.

remove the blade from your hack saw. Then cut the inside of the pipe till you reach the outside housing that holds the pipe. If you tap it the pipe should buckle inwards then it should be easy to pull it out.

So thats gearbox oil, diff oil and exhaust polish done today :D

Whoever did the gearbox oil last time definitely made sure the plugs were tight... They were a real pita even with a breaker bar... :angry:

At least gearbox feels a lot nicer now, will be interested to see how it feels cold mornings now.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • Back again. I returned to Japan in Jul/Aug to spend time with the car on my birthday and remind myself what all the sacrifice and compromise is for. It happened to line up with the monthly morning meet in Okutama, which I have been wanting to go to for a long time. It's a unique event at a unique spot with really rare, interesting, and quirky cars. It's where all the oldheads and OGs gather. The nighttime scene at DKF certainly has its place and should be experienced if you're into cars, but there's too much bad attention and negativity around it now. IMO the better time is Sunday morning at DKF or Okutama; it's more chill and relaxed. I'm glad I was finally able to go, but not sure it's worth the drive from all the way from Nagoya immediately the day before, unless I was already staying in Tokyo for the days right before the meet, because you have to wake up quite early to make it in time. Funnily enough though I didn't drive the car all that much this trip because it was just too damn hot. While there were zero issues and running temps were nominal and the A/C was strong, RBs already run crazy hot as it is. Sure, it took it all like a champ but something about driving these cars in the ridiculous heat/humidity bothers me and makes me feel like I'm asking too much of it. I'm just me being weird and treating the car like a living thing with feelings; I'm mechanically sympathetic to a fault. Instead I was mainly driving something else around - a KX4(silver) 2001 X-Trail GT, that I acquired in May. There's a few different flavors to choose from with Xs, but visually it's the Nissan version of the Honda CR-V. Mechanically it's a whole different story as this, being the top-trim GT, has an SR20VET mated to a four-speed auto and full-time AWD! It was a very affordable buy in exceptional condition inside and out, with very low mileage...only 48k kms. Most likely it was owned by an older person who kept it garaged and well-maintained, so I'm really happy with how it all worked out. It literally needs zero attention at the moment, albeit except for some minor visual touch-ups. I wanted something quirky, interesting, and practical and for sure it handily delivers on all three of those aspects. I was immediately able to utilize the cargo and passenger capacity to its full extent. It's a lot of fun to drive and is quite punchy through 1st and 2nd. It's very unassuming -in the twisty bits it's a lot more composed than one would think at a glance- and it'll be even better once I get better tires on it(yes, it's an SUV but still a little boat-y for my liking). So...now I have two golden-era Nissans in silver. One sports car and one that does everything else; the perfect two-car solution I think👍 The rest of the trip...I was able to turn my stressed brain off and enjoy it, although I didn't quite get to do as much as I thought. I did some interesting things, met some interesting people, and happened into some interesting situations however, that's all for another post though only if people really want to know. Project-wise, I went back to Mine's again to discuss more plans and am hoping to wrap that up real soon; keep watching this space if that interests you. Additionally, while working in the tormenting sweatbox that is the warehouse, I was able to organize most of the myriad of parts that my friend is storing for me along with the cars, and the 34 has a nice little spot carved out for it: And since it can get so stupid hot in there, that made it all the more easy -after I was standing there looking at the car and said 'f**k it'- to finally remove all the damn gauges that have mostly been an eyesore all this time. Huzzah. The heat basically makes the adhesive backing on the gauge mounts more pliable to work with, so it was far less stressful getting this done. I didn't fully clean it up or chase the wiring though; that will happen once I have the car in closer possession. Another major reason to remove all that stuff is to give people less reasons to get in my car and steal s**t while it's being exported/imported when/if the time comes, which leads us to my next point... ...and that is even though it's time in Japan is technically almost up since it's a November car and the X would be coming in March, I'm still not entirely sure where my life and career is headed; I don't really know what the future looks like and where I'm going to end up. I feel there's a great deal of uncertainty with me and as a result of that, it feels like I'm at a crossroads moreso now than any point in my life thus far and there are some choices I need to make. Yes, I've had some years to consider things and prepare myself, however too much has happened in that time to maintain confidence and everything feels so up in the air; tenuous one might say. Simply put, there's just too much nonsense going on right now from multiple vectors. Admittedly, I'm struggling to stay in the game and keep my eyes on the prize. So much so in fact, that very recently I came the closest I ever have before to calling it quits outright; selling everything and moving on and not looking back. The astute among you will pick up on key subtext within this paragraph. In the meantime I've still managed to slowly acquire some final bits for the car, but it feels nice knowing there's not much left to get and I'm almost across that finish line; I have almost everything I'll ever want for my interpretation and expression on what it is I think an R34 should be. 'til later.
    • Thanks for that, hadn’t used my brain enough to think about that. 
    • Also playing with fire if they start to flow more air down low than what the stock twins can. It's not even up top you need to worry, it can be at 3000rpm and part throttle and it's getting way more flow than it should.
    • Any G40/1000 or G40/1250 results out there?  
    • You still want a proper tune on the stock ECU though. Stock tune + stock ECU with GT-SS/-9s is probably playing with fire if you're running more than stock airflow/power.
×
×
  • Create New...