Jump to content
SAU Community

Recommended Posts

Hey guys,

Does anyone have the part numbers for nm35 A/C belt and Alternator belt?

The writing has worn off mine so makes ordering difficult without pulling them off to measure.

Cheers!

Ha, I was looking at belts today myself.

Genuine numbers were AY140-61175 and AY14N-4094E

Starter Motor 23300-AL600 (expensive new and ex Japan)

Starter Motor Brush kit 23378-EN20A also used in Australian model starters so readily available.

  • 2 weeks later...
  • 2 weeks later...

I did my wiper blades recently. Main thing with rear is to make sure that when you trim it down, there is something to hold the 'rubber' in place and prevent it simply sliding off the end, as the wiper arm holds the entire spine of the blade .... if that makes sense.

reason I say this is because it took me two lots of blades to find one that didn't just slip right off the end :S

Surely a r36 Passat is nicer in every aspect on comparison to a stock pm/nm35?

Apart from servicing costs and exploding DSGs that is...

And the fact they have tried to make a boring car cool and failed is also another reason to go stagea.

And when people ask you what you drive, R36 or not a passat is not a car you can tell them and be proud of it.

If you say stagea 90% of people dont know what they are. So your all sweet.

Edited by Howaitonaito
  • Like 1

And the fact they have tried to make a boring car cool and failed is also another reason to go stagea.

And when people ask you what you drive, R36 or not a passat is not a car you can tell them and be proud of it.

If you say stagea 90% of people dont know what they are. So your all sweet.

some would say the same about our lunchboxes. Wpuld depend on individuals wants and needs.

Im after front wheel bearing part number and if there are any cars that have same wheel bearing.

I have a few aftermarket front wheel bearings here from the US... Nissan ones are just too expensive.

I have a few aftermarket front wheel bearings here from the US... Nissan ones are just too expensive.

yeah i just purchased one from ebay but usa seller said week later he is sold out. What would you sell me one for scptty. Pm me
  • 5 weeks later...

Hmm Anyone know which fuse/relay the rear centre and rear right brake light run off? Globe seems fine (Cant check centre), comes on with lights hwoever no brake light..

Cheers

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • Yea - I mean I've seen my fuel pump which is decades old and uh, while I'm not saying this with real knowledge... but I sure get the ick at using anything in the fuel system that produced the state of that pump. Many years ago I went through multiple pumps (and strainers) before I dropped the tank to clean it out with extreme violence. I'm talking the car would do maybe 50km before coming to a halt, which resulted in me cleaning out the filter with some brake cleaner and going on my way. None of my stuff ever looked like what came out of your fuel tank. I don't think I'd be happy with it unless every single component was replaced (or at least checked/cleaned/confirmed to be clean here).
    • I'm not going to recommend an EBC pad. I don't like them. Just about anything else would suit me better. I've been using Intima pads for a while now.
    • Agreed, and in particular the earth strap that should go from the subframe to the chassis but it often broken or left off. There is a section in the R32 workshop manual you can follow for troubleshooting if you don't see anything suspicious, and depending where you are (there is no location on your user profile) you should be able to get your hands on a second hand replacement unit still if needed
    • Yeah they mention as a R34 for 2.5 Turbo...but then again thos "small" were also for R34 by that different site. But i look into it and that 310mm EBC is for R34 GTT. And by those you linked the specs are the same 🙂    EDIT: I found these on one site here: DBA 4000 series T3 DBA42304S They are 310mm...and it says are for R34GTT...are there good? EDIT2: ok they have pads too.  What "color" should i get for street use? I dont want/need some noisy ones...(and if they are not that dusty that is good too)
    • Yeah, shame. Maybe  driver's carpet is available 🙏. I am waiting for both amayama and nangun to confirm.
×
×
  • Create New...