Jump to content
SAU Community

Recommended Posts

Did the major service in februrary and since then i've just been enjoying driving it without needing or wanting anything. besides more power :D 

After the tune, suspension, brakes, and tyres the car has been fantastic and has transformed it into a capable and enjoyable car to drive.

 

The mod bug hit me again a few months and i've put it off until breaking point. The next step is to clean it up ready for sale, starting with the engine bay.

So far i have almost everything needed for the hotside clean up and wiring tuck etc. Once the hotside is done i will move on to the cold side, and then the exterior.

  • 8 months later...

So a few things have happened in the last few months. 

 

The turbo is an ATR43G3SAT from Hypergear. The install of these is pretty easy if you do your research and have all the things needed infront of you.

The dump pipe is an xforce one which I die grinded the inlet to match the turbo.

I got a new muffler which is 2.3" so it's pretty quiet when cruising around, and you can see at the kink there is a 3" electric valve cutout. Sounds unreal once it's opened.

The engine bay is no where near done, but i thought i'd post a pic of some of the things i've done. 

 

Tuning this new turbo has been fun so far, It was a little bit concerning when i went on my first drive and it only made 13psi by 4.5k under wastegate pressure haha. A few logs and some tuning i am now able to make 8psi at 50% throttle at 2.8k which is more than enough usable boost, and my midrange has picked up significantly.

Stock injectors have been holding up... not really. They're sitting around 120%DC. So i'll put in some 480cc i have from 2 jap sr20's. 

Once i think i have the tune perfect ill be going to see Johhny who will let me know if im on the money, I can't wait to go and see him.

 

image1.JPG

image2.JPG

image3.JPG

image5.JPG

image6.JPG

image7.JPG

image8.JPG

image9.JPG

image10.JPG

image11.JPG

image12.JPG

image13.JPG

image14.JPG

image15.JPG

image16.JPG

22 minutes ago, admS15 said:

Looking good except for that dump pipe gasket, that belongs in the bin. Compare it to an oem or permaseal one and you'll see why. I suppose its in there now, once it lets go, u know what to replace it with.

It was the only thing that was skimped on and you pick it out :P I just couldn't justify $50 for a dump gasket... They can't be too bad of a design as they squish flat? The perforated holes will probably link into a crack eventually i guess.

:O wish I knew that when I orders the permaseal t3 gaskets... o well.

I just noticed I didn't have any photos of the new turbo in.
Just a bit of a mockup of the intake and hot side from today's efforts. Will be finished off with new clamps, paint, silicone, stock heat shield etc once they get here.

IMG_7523.jpg
IMG_7524.jpg

The 440* s15 injectors are in and tuned. Sitting at a nice 70% DC. Which i have pushed to 90% already...

I'll just get a turbosmart fpr2000 from Johnny and run a base pressure of 50psi. The fpr looks very stable and reliable in Andy's tests and it will push the cc to around 480

I was about to ask why not a manual??? but then I saw the Corona box...pretty hard to be drinkin' a coldy and manually shifting at the same time :P

I can't imagine the dump would see enough pressure for that gasket to be an issue... could you believe a reputable workshop used a turbo gasket (manifold to turbo) similar to that material in my R33 which gave out??  Forgot to take a picture, but OEM was soo much better quality

What's the second new turbo for??

  • Like 1

Hahaha same as holding hands while driving. My love is never broken.

I was given these flat plates for the turbo gaskets, threw them out and got a multilayer permaseal. Much better!

Second is Tyler's, the white stag with 34 front above

  • Like 1
  • 2 weeks later...

Fuel pump is dying. So i grounded the pump, and a new walbro is on it's way.

Gearbox needs a shift kit and billet servo. The box is still tight, but not enjoying the 1-2-3.
Heaps of stuff has been changed or removed, re did most of my wiring and tucked it away. 

Found the wastegate arm was getting loose because the bracket isn't strong enough, I'll make a new one.

Found a huge boost leak and a few other problems which are now rectified. 

Johnny has been helping immensely on the tuning. He setup closed loop boost and adaptive tuning for safety, and did quite a lot of work on the ign and fuel table which has helped boost come on earlier and keep afrs more stable.

 

 

image1.jpeg

  • 2 months later...

Cars still driving fine.

Gearbox hasn't exploded into a million pieces as of yet.

I've got some Sard injectors almost ready to go in, I just need to make another loom and do a little tuning. Then 20+psi.


It does 0-100 in 5sec flat according to my logs, which isn't too bad for standard stall.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • Back again. I returned to Japan in Jul/Aug to spend time with the car on my birthday and remind myself what all the sacrifice and compromise is for. It happened to line up with the monthly morning meet in Okutama, which I have been wanting to go to for a long time. It's a unique event at a unique spot with really rare, interesting, and quirky cars. It's where all the oldheads and OGs gather. The nighttime scene at DKF certainly has its place and should be experienced if you're into cars, but there's too much bad attention and negativity around it now. IMO the better time is Sunday morning at DKF or Okutama; it's more chill and relaxed. I'm glad I was finally able to go, but not sure it's worth the drive from all the way from Nagoya immediately the day before, unless I was already staying in Tokyo for the days right before the meet, because you have to wake up quite early to make it in time. Funnily enough though I didn't drive the car all that much this trip because it was just too damn hot. While there were zero issues and running temps were nominal and the A/C was strong, RBs already run crazy hot as it is. Sure, it took it all like a champ but something about driving these cars in the ridiculous heat/humidity bothers me and makes me feel like I'm asking too much of it. I'm just me being weird and treating the car like a living thing with feelings; I'm mechanically sympathetic to a fault. Instead I was mainly driving something else around - a KX4(silver) 2001 X-Trail GT, that I acquired in May. There's a few different flavors to choose from with Xs, but visually it's the Nissan version of the Honda CR-V. Mechanically it's a whole different story as this, being the top-trim GT, has an SR20VET mated to a four-speed auto and full-time AWD! It was a very affordable buy in exceptional condition inside and out, with very low mileage...only 48k kms. Most likely it was owned by an older person who kept it garaged and well-maintained, so I'm really happy with how it all worked out. It literally needs zero attention at the moment, albeit except for some minor visual touch-ups. I wanted something quirky, interesting, and practical and for sure it handily delivers on all three of those aspects. I was immediately able to utilize the cargo and passenger capacity to its full extent. It's a lot of fun to drive and is quite punchy through 1st and 2nd. It's very unassuming -in the twisty bits it's a lot more composed than one would think at a glance- and it'll be even better once I get better tires on it(yes, it's an SUV but still a little boat-y for my liking). So...now I have two golden-era Nissans in silver. One sports car and one that does everything else; the perfect two-car solution I think👍 The rest of the trip...I was able to turn my stressed brain off and enjoy it, although I didn't quite get to do as much as I thought. I did some interesting things, met some interesting people, and happened into some interesting situations however, that's all for another post though only if people really want to know. Project-wise, I went back to Mine's again to discuss more plans and am hoping to wrap that up real soon; keep watching this space if that interests you. Additionally, while working in the tormenting sweatbox that is the warehouse, I was able to organize most of the myriad of parts that my friend is storing for me along with the cars, and the 34 has a nice little spot carved out for it: And since it can get so stupid hot in there, that made it all the more easy -after I was standing there looking at the car and said 'f**k it'- to finally remove all the damn gauges that have mostly been an eyesore all this time. Huzzah. The heat basically makes the adhesive backing on the gauge mounts more pliable to work with, so it was far less stressful getting this done. I didn't fully clean it up or chase the wiring though; that will happen once I have the car in closer possession. Another major reason to remove all that stuff is to give people less reasons to get in my car and steal s**t while it's being exported/imported when/if the time comes, which leads us to my next point... ...and that is even though it's time in Japan is technically almost up since it's a November car and the X would be coming in March, I'm still not entirely sure where my life and career is headed; I don't really know what the future looks like and where I'm going to end up. I feel there's a great deal of uncertainty with me and as a result of that, it feels like I'm at a crossroads moreso now than any point in my life thus far and there are some choices I need to make. Yes, I've had some years to consider things and prepare myself, however too much has happened in that time to maintain confidence and everything feels so up in the air; tenuous one might say. Simply put, there's just too much nonsense going on right now from multiple vectors. Admittedly, I'm struggling to stay in the game and keep my eyes on the prize. So much so in fact, that very recently I came the closest I ever have before to calling it quits outright; selling everything and moving on and not looking back. The astute among you will pick up on key subtext within this paragraph. In the meantime I've still managed to slowly acquire some final bits for the car, but it feels nice knowing there's not much left to get and I'm almost across that finish line; I have almost everything I'll ever want for my interpretation and expression on what it is I think an R34 should be. 'til later.
    • Thanks for that, hadn’t used my brain enough to think about that. 
    • Also playing with fire if they start to flow more air down low than what the stock twins can. It's not even up top you need to worry, it can be at 3000rpm and part throttle and it's getting way more flow than it should.
    • Any G40/1000 or G40/1250 results out there?  
    • You still want a proper tune on the stock ECU though. Stock tune + stock ECU with GT-SS/-9s is probably playing with fire if you're running more than stock airflow/power.
×
×
  • Create New...