Jump to content
SAU Community

Recommended Posts

24 minutes ago, Leroy Peterson said:

Y'all here complaining about $300 for someone to drive to your house, use materials, fix something and then drive off. But at the same time people here have been discussing hourly charge out rates for IT staff to sit at their desk and take 3 piss breaks an hour for $270+

 

If it cost $300 to see how easy a job is and what materials to use, so you can DIY it in future... Maybe it's not so bad.

 

you missed also have a warranty on their work, insurance and such.

if you fix a pipe and it causes an issue lets say backs up water and floods the house,  will your house insurance pay out?

 

and bitch please I'm charged out at 340+ even for lunch breaks

 

and bitch please I'm charged out at 340+ even for lunch breaks

 

Hang on, who do you currently work for again?

 

Have done shovel work. Don't deserve to get paid a whole lot for it, but it's not fun.

3 minutes ago, Leroy Peterson said:

Have done shovel work. Don't deserve to get paid a whole lot for it, but it's not fun.

Grew up on a farm..learn the hard way when literally knee deep in crap that there has to be a better way to earn a $

 

 

thus computers.

 

 

once 88E hits 25c, imma blow it on something stupid like this

http://www.trademe.co.nz/motors/specialist-cars/other/auction-1360027694.htm

shame its only a 4 seater :( cant cart around too many friends.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • Yep, the closest base tune available was for the GTT, I went with that and made all the logical changes I could find to convert it to Naturally Aspirated. It will rev fine in Neutral to redline but it will be cutting nearly 50% fuel the whole way.  If I let it tune the fuel map to start with that much less fuel it wont run right and has a hard time applying corrections.  These 50% cuts are with a fuel map already about half of what the GTT tune had.  I was having a whole lot of bogging when applying any throttle but seem to have fixed that for no load situations with very aggressive transient throttle settings. I made the corrections to my injectors with data I found for them online, FBCJC100 flowing 306cc.  I'll have to look to see if I can find the Cam section. I have the Bosch 4.9 from Haltech. My manifold pressure when watching it live is always in -5.9 psi/inHg
    • Hi My Tokico BM50 Brake master cylinder has a leak from the hole between the two outlets (M10x1) for brake pipes, I have attached a photo. Can anyone tell me what that hole is and what has failed to allow brake fluid to escape from it, I have looked on line and asked questions on UK forums but can not find the answer, if anyone can enlighten me I would be most grateful.
    • It will be a software setting. I don't believe many on here ever used AEM. And they're now a discontinued product,that's really hard to find any easy answers on. If it were Link or Haltech, someone would be able to just send you a ECU file though.
    • Yes sir am asking is there possible way from aem tuner from wiring pins 
    • Have you checked cam to crank timing and confirmed balancer marks are correct?
×
×
  • Create New...