Jump to content
SAU Community

Recommended Posts

Dear all,

So... I just faced an issue with my BNR32. I was leaving the carpark (cold start), but i stalled (don't ask why), so the car rolled back down.

THEN, i put it to neutral, and tried starting the car. BUT the car did not start. It was a "crank but no start" situation. 

I tried a couple of times, but just will not start. I googled, and came across an article about fuel pump, fuel injectors issue, etc.

THEN, i just tried my luck by cranking the car at 2nd Gear. Miraculously, the engine ignited. 

NOW, my question is WHY it happened? and WHAT to fix?

Link to comment
https://www.sau.com.au/forums/topic/477086-professional-helpadvice-needed/
Share on other sites

Stock ECU and stock injectors?

If so I'll start with cleaning your AFM, and injectors. If they're clogged or gummed up, it will be a bit too lean to start. If you're in this situation, unplug your coolant temp sensor (2x pin one not the 1x pin one) and it should start.

If not stock ECU, tuned and worked etc. then could be a poor cranking table or coolant/IAT/fuel correction table issue or clogged injectors or anything really.

  • Like 1

Hey! thank you!

I was able to start the engine normal prior to stalling. But after the stall, the car cannot be ignited but cranks (both at 1st gear and neutral).

After a while, the car was able to ignite at second gear. Today, the car starts up normally and even though i stalled it on purpose, the car is working normally.

Is it something that happens normally? What exactly is the issue?

9 minutes ago, GTSBoy said:

Gear position / neutral has nothing to do with it. You have just experienced something weird. As my crystal ball is currently out getting resurfaced, I am unable to discern what caused it. Please call another psychic.

HAHA thank you. Didn't really understand what went wrong. Thought might get some answers from here!

Thank you all! Just an update and maybe someone could explain to me why so:

SO, i tried stalling the car the same way i did before. Again, the car could not be ignited. But this time round, i tapped the throttle whilst cranking the car and it worked.

My guess is that there isn't enough fuel injected when the car was climbing the slope of the carpark - causing it difficulty to start the engine (?).

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • For these last 7 years of ownership, I've always had to use a small scissor jack under one of the front tow hooks to raise the front just enough so my low-profile jack fits under to reach my subframe jack point. I'm beginning to get annoyed of always having to do this. Are there any lower low-profile jacks that fit under the gtr lip on a dropped car?
    • Seat of the pants assessment of the new intake: The car is way less "doughy" when hitting the loud pedal, especially off idle when stopped or in traffic, I did use a cheapo lazer thermal thingo to measure the temp around where the pod filter got its air, it was between 55 - 60°C, in saying this the car was shut off and not moving, so the OEM intake pipe was not supplying any fresh air to where the pod was when the car was at least moving A weird bonus was induction noise on the throttle in the cabin increased a bit,  I was worried that I was actually going to lose some of that induction noise I love so much, outside though, when I got the daughter to do a WOT drive by pass for me, the induction noise has increased alot when on the throttle, not quite ITB doort, but well up there I'm extremely happy with the results and have been exploring the country roads in the region  As for house mods: 1.New front fence is up and is awesome, it really upgraded how the joint looks from the street, and the added security is nice 2. Electricians have replace some interior lights, and with more lighting in the garage, a few new motion detecting lights out the front above the garage, front room, and at the front door, which I have already found heaps helpful coming and going, also now has fancy pants CCTV all round the house The only hold point for power though is the solar and batteries due to supply issues, although this will happen over the next few weeks 3. I have done a heap of landscaping out the front and I'm almost ready to do a new small retaining wall with some nice blocks to replace the brick and cemented in rocks around the raised garden beds cemented in river stone "was the fashion at the time" the house was built. I currently have a pallet of retaining wall blocks and 2 bulka bags of 20mm blue metal to replace the wood chip that is in the raised garden beds around the house 4. I now have 3 big raised garden beds for out the back to grow some vegetables, about 70cm high, 200cm long and 100cm wide 5. My 2 compost bins are already pretty full with brown, green and kitchen waste from the landscaping I'vedone so far, but they will probably take a few months to break down, so anything else that gets chopped, trimmed, and kitchen waste will just start filling the base of the raised garden beds to about 30cm before I start throwing 40cm of good compost, and stuff, for the vegetables to grow in, I'll need a few ton of compost and soil, but the local supplier can sent me bulka bags of the stuff Basically the logs, wood chips and a few strategically placed rocks for drainage, will give the beds some good organic materials down low to break down over time, and they will hold moisture during the warmer months to save the water in my big arse water tank if we don't get alot of rain So, all in all, the car and house mods are going well, and I'm really enjoying being retired, I sleep in too 0700 and slowly plod around inside until I feel like actually doing anything, and only work in the yard for as long as want, which has actually been alot over the last few weeks,  although when you look at it, it seems that not a huge amount of work has been done,  until I look at the before I started the work pics Happy days and good times indeed 
    • hahaha yeah. Plan is to get side skirts and probably just rear pods. But going to do them one-by-one. I've got a set that I really like from RHDJapen, but that one isn't shipped to AU. So need to find someone who can get it for me
    • Here's an idea, answer the questions I asked you as they are trying to work out WHY the LSD will be binding up in a straight line.
×
×
  • Create New...