Jump to content
SAU Community

Recommended Posts

I don't think the Australian contingent on here can really help answer the question of value, over here we would not pay more than 8,000 or maybe 10,000 aussie pesos but r32 gtst are readily available here....

Link to comment
https://www.sau.com.au/forums/topic/479985-worth-the-buy/#findComment-7926697
Share on other sites

Also don't trust the millage on any Skyline. Assume they all have had the clocks been wound back to what it currently shows,  then focus on the condition of the car, how well it's been cared for and how it's been used. 

  • Like 1
Link to comment
https://www.sau.com.au/forums/topic/479985-worth-the-buy/#findComment-7926699
Share on other sites

There is no way that that has been only 120k km since about 2002!!! Lolz.

Also, it does not have GTSt seats in it, so consider that it might have been built up out of something else. I  would check the VIN on the GTR registry. See what pops up. Nissan FAST also good for that.

The car doesn't look too bad. The oil weep around the HICAS solenoids is not great. But there's too little else to go on.

Link to comment
https://www.sau.com.au/forums/topic/479985-worth-the-buy/#findComment-7926701
Share on other sites

In the fourth picture, the left hand side looks a bit rusty and should be looked into - also the compliance plate is missing or did i miss it? The pictures of underneath do not look too bad, but overall i'd say do not rush into it. Better examples out there for sure.

You can always go for a japan car history report and save yourself a headache - normally gives km's, accident history etc.

Edited by Jip
added info.
Link to comment
https://www.sau.com.au/forums/topic/479985-worth-the-buy/#findComment-7926908
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • There's restrictor pills in the stock boost control hoses. That's how they set the amount that was bled off and hence the "high" boost setting. The usual mod in the day was to remove it and send the "high" boost setting up to about 14 psi.
    • Thanks Duncan, that's the best info I've read. Furthermore after learning about the PCM programming side controlling the factory boost solenoid, the purpose of the solenoid is to "bleed" boost when pin 25 is earthed, thus allowing spring pressure in the wastegate actuator to overcome diaphragm boost pressure, thus closing or reducing the position of the wastegate flap creating more boost as the turbo is able to spin faster. It's pretty cool to see a designated Pill to do exactly this, would have liked to have seen it with a tiny filter over the end for those moments in vacuum.  The constant bleed pill has now been removed completely from the system and solenoid boost control has been restored once again.   Case closed 😂
    • The wideband reading is meaningless if it's not running. Why are you using shitty old sidefeeds on any engine, let alone a Neo? What manifold and fuel rail are you using to achieve that? Beyond that, can't help you with AEM stuff as I've never been their ECU/CAS combo.
    • Manual boost controllers (where a little of the boost was bled off) were quite common back in the day, because they were cheap and easy. Generally they had a manual adjustment screw rather than being fixed like yours. Down side is they always bleed boost, not just when you want them to so an electronic boost controller that uses a solenoid will have less lag.
    • Hello , im new here and i have A31 home build  RB25det neo stock eng / turbo  aem ems 2 blue connector  aem 3.5 map aem cas disk aem wideband connected to ecu  355 lph pump 550 nismo yellow injectors side feed aftermarket regulator  and won’t start with base aem tuner basic tune eventually flipped cas 180 degree so it triggers on correct stroke not in exhaust cycle  Now it won’t start Wideband reads 10 and 11 at lowest fuel setting  and will share calibrations soon for aem tuner i think something is wrong in aem tuner    please if you have any information, am very grateful         
×
×
  • Create New...