Jump to content
SAU Community

Recommended Posts

On 9/10/2020 at 11:06 PM, Tobz said:

Also would be interested in your voltage values for the fuel level

I still haven't gotten around to sorting this yet, but I will soon. 

I didn't think I'd have any speed bumps other then the charge light =/ When I get around to doing this job, I'll pull the dash out, take the car for a drive and see what else breaks. 

I'll post up the fuel level vs voltage table that I'll build as well when its done. 

1 hour ago, Murray_Calavera said:

I still haven't gotten around to sorting this yet, but I will soon. 

I didn't think I'd have any speed bumps other then the charge light =/ When I get around to doing this job, I'll pull the dash out, take the car for a drive and see what else breaks. 

I'll post up the fuel level vs voltage table that I'll build as well when its done. 

So this is what I’ve worked out that you need to sort if you replace the dash;

battery light

central locking control unit

interior light (I think the door light on the dash powers the interior light when you open and close the doors.

speed sensor 

 

then the wires you need to add to connect to the new dash are the indicators, hand brake, high beam

Edited by Tobz
  • 5 weeks later...

I used the fuel sender value I found on HERE

I really didnt want to pull the sender out at the time. I'm curious to see your readings

 

On a side note you may need the Haltech GPS module to clock the speed correct for the IC-7. The speedo signal goes to the OEM cluster before the ECU which makes it a pain to get the speed correct.

  • Like 1
On 9/11/2020 at 5:53 PM, Tobz said:

So this is what I’ve worked out that you need to sort if you replace the dash;

battery light

central locking control unit

interior light (I think the door light on the dash powers the interior light when you open and close the doors.

speed sensor 

 

then the wires you need to add to connect to the new dash are the indicators, hand brake, high beam

I have my IC-7 installed and I can confirm the interior lighting works w/o original dash

The IC-7 can display the battery voltage/set alarms so there's no need to wire for the light

1 hour ago, SLVRBAKSLPZ said:

I used the fuel sender value I found on HERE

I really didnt want to pull the sender out at the time. I'm curious to see your readings

 

On a side note you may need the Haltech GPS module to clock the speed correct for the IC-7. The speedo signal goes to the OEM cluster before the ECU which makes it a pain to get the speed correct.

And annoyingly, the IQ3 dash GPS is not available on the Haltech CAN, so you end up needing 2 GPS receivers :/

1 hour ago, SLVRBAKSLPZ said:

I have my IC-7 installed and I can confirm the interior lighting works w/o original dash

The IC-7 can display the battery voltage/set alarms so there's no need to wire for the light

I have an R34, may be different?

And i think the battery light is wired in as an exciter for the alternator? Without it the alternator may not be charging your battery properly?

2 hours ago, SLVRBAKSLPZ said:

I used the fuel sender value I found on HERE

I really didnt want to pull the sender out at the time. I'm curious to see your readings

 

On a side note you may need the Haltech GPS module to clock the speed correct for the IC-7. The speedo signal goes to the OEM cluster before the ECU which makes it a pain to get the speed correct.

On my car we took the speed sensor wires from the Gearbox and then and spliced them into the wires going to the ecu, so we bypassed the dash. 

Sorry just to confirm i used a GPS speed app on my phone to work out what 60kph is.

Then in the haltech ecu I went to the speed sensor page and hit the calibrate button when i was doing a constant 60kph according to the gps app.

Once that was done it was all calibrated and perfect :)

1 minute ago, Tobz said:

Just needed to calibrate it, which was pretty easy, got my phone out, did a constant 60kph on a straight road, hit the calibrate button, and now its perfect

Copy. So just the signal to the proper pin (53 on R33) at the ECU then ground (any ground)? Does the R34 VSS go to the dash first like the R33?

 

I may try this and see what happens. I really didn't want to GPS module for the possibility of it dropping out.

1 minute ago, SLVRBAKSLPZ said:

Copy. So just the signal to the proper pin (53 on R33) at the ECU then ground (any ground)? Does the R34 VSS go to the dash first like the R33?

R34 GTT went to to the dash first. There are two sensor wires that leave the gearbox near the front cross member on the driver side. I cut those, then wired in some new wires, went up through the gearbox shifter and routed them to the ECU. There are two wires, they are non polarised so it doesnt matter which way they are wired. There is no ground.

2 hours ago, SLVRBAKSLPZ said:

I have my IC-7 installed and I can confirm the interior lighting works w/o original dash

Also sorry my interior light still works, but doesnt automatically turn on when u open the door. i think it ran off the door open light on the dash

6 minutes ago, Tobz said:

R34 GTT went to to the dash first. There are two sensor wires that leave the gearbox near the front cross member on the driver side. I cut those, then wired in some new wires, went up through the gearbox shifter and routed them to the ECU. There are two wires, they are non polarised so it doesnt matter which way they are wired. There is no ground.

Ok. I will try to mess with this over the weekend. I will still install the GPS just in case I have troubles.

So re-wire directly to the ECU, one wire to VSS pin 53 and one to 12v power on the ECU

1 hour ago, SLVRBAKSLPZ said:

Ok. I will try to mess with this over the weekend. I will still install the GPS just in case I have troubles.

So re-wire directly to the ECU, one wire to VSS pin 53 and one to 12v power on the ECU

there should be two pins for the speed sensor on the ECU..... 

1 minute ago, Tobz said:

there should be two pins for the speed sensor on the ECU..... 

OK for the R33, 7 is the Tacho speed signal and 53 is the vehicle speed sensor. is the tac signal the 2nd pin? that the only other pin  i assume get spliced

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • Back again. I returned to Japan in Jul/Aug to spend time with the car on my birthday and remind myself what all the sacrifice and compromise is for. It happened to line up with the monthly morning meet in Okutama, which I have been wanting to go to for a long time. It's a unique event at a unique spot with really rare, interesting, and quirky cars. It's where all the oldheads and OGs gather. The nighttime scene at DKF certainly has its place and should be experienced if you're into cars, but there's too much bad attention and negativity around it now. IMO the better time is Sunday morning at DKF or Okutama; it's more chill and relaxed. I'm glad I was finally able to go, but not sure it's worth the drive from all the way from Nagoya immediately the day before, unless I was already staying in Tokyo for the days right before the meet, because you have to wake up quite early to make it in time. Funnily enough though I didn't drive the car all that much this trip because it was just too damn hot. While there were zero issues and running temps were nominal and the A/C was strong, RBs already run crazy hot as it is. Sure, it took it all like a champ but something about driving these cars in the ridiculous heat/humidity bothers me and makes me feel like I'm asking too much of it. I'm just me being weird and treating the car like a living thing with feelings; I'm mechanically sympathetic to a fault. Instead I was mainly driving something else around - a KX4(silver) 2001 X-Trail GT, that I acquired in May. There's a few different flavors to choose from with Xs, but visually it's the Nissan version of the Honda CR-V. Mechanically it's a whole different story as this, being the top-trim GT, has an SR20VET mated to a four-speed auto and full-time AWD! It was a very affordable buy in exceptional condition inside and out, with very low mileage...only 48k kms. Most likely it was owned by an older person who kept it garaged and well-maintained, so I'm really happy with how it all worked out. It literally needs zero attention at the moment, albeit except for some minor visual touch-ups. I wanted something quirky, interesting, and practical and for sure it handily delivers on all three of those aspects. I was immediately able to utilize the cargo and passenger capacity to its full extent. It's a lot of fun to drive and is quite punchy through 1st and 2nd. It's very unassuming -in the twisty bits it's a lot more composed than one would think at a glance- and it'll be even better once I get better tires on it(yes, it's an SUV but still a little boat-y for my liking). So...now I have two golden-era Nissans in silver. One sports car and one that does everything else; the perfect two-car solution I think👍 The rest of the trip...I was able to turn my stressed brain off and enjoy it, although I didn't quite get to do as much as I thought. I did some interesting things, met some interesting people, and happened into some interesting situations however, that's all for another post though only if people really want to know. Project-wise, I went back to Mine's again to discuss more plans and am hoping to wrap that up real soon; keep watching this space if that interests you. Additionally, while working in the tormenting sweatbox that is the warehouse, I was able to organize most of the myriad of parts that my friend is storing for me along with the cars, and the 34 has a nice little spot carved out for it: And since it can get so stupid hot in there, that made it all the more easy -after I was standing there looking at the car and said 'f**k it'- to finally remove all the damn gauges that have mostly been an eyesore all this time. Huzzah. The heat basically makes the adhesive backing on the gauge mounts more pliable to work with, so it was far less stressful getting this done. I didn't fully clean it up or chase the wiring though; that will happen once I have the car in closer possession. Another major reason to remove all that stuff is to give people less reasons to get in my car and steal s**t while it's being exported/imported when/if the time comes, which leads us to my next point... ...and that is even though it's time in Japan is technically almost up since it's a November car and the X would be coming in March, I'm still not entirely sure where my life and career is headed; I don't really know what the future looks like and where I'm going to end up. I feel there's a great deal of uncertainty with me and as a result of that, it feels like I'm at a crossroads moreso now than any point in my life thus far and there are some choices I need to make. Yes, I've had some years to consider things and prepare myself, however too much has happened in that time to maintain confidence and everything feels so up in the air; tenuous one might say. Simply put, there's just too much nonsense going on right now from multiple vectors. Admittedly, I'm struggling to stay in the game and keep my eyes on the prize. So much so in fact, that very recently I came the closest I ever have before to calling it quits outright; selling everything and moving on and not looking back. The astute among you will pick up on key subtext within this paragraph. In the meantime I've still managed to slowly acquire some final bits for the car, but it feels nice knowing there's not much left to get and I'm almost across that finish line; I have almost everything I'll ever want for my interpretation and expression on what it is I think an R34 should be. 'til later.
    • Thanks for that, hadn’t used my brain enough to think about that. 
    • Also playing with fire if they start to flow more air down low than what the stock twins can. It's not even up top you need to worry, it can be at 3000rpm and part throttle and it's getting way more flow than it should.
    • Any G40/1000 or G40/1250 results out there?  
    • You still want a proper tune on the stock ECU though. Stock tune + stock ECU with GT-SS/-9s is probably playing with fire if you're running more than stock airflow/power.
×
×
  • Create New...