Jump to content
SAU Community

Recommended Posts

Diagnosing a misfire. Anyone have experience with these kinds of coils? When i got the car, these were already in here. Wholesale Ignition Coil Pack, 6 Pieces, RB20DET Series 1 R33 for R32 RB25DET RB26DETT 22433-60U01 22433-60U02 not an actual picture, but they look exactly like this. 

Right, so unfortunately there was a time aftermarket coils became cheap and readily available, but many of them are junk, including the common yellow and red ones.  Splitfires (purple) seem to be OEM quality, or go OEM (or OEM from another car, there are lots of kits these days_.

2 screws each in the 4 screw bracket. I think that was because the front and rear brackets are identical.

If you have an aftermarket ECU then 100% as above go R35 coils.

there’s probably a couple of simple questions like:

- What are the other mods?

- when we’re the spark plugs changed?

- what type of spark plug and what gap?

 

Yes ran the red ones in R33 for about 80000km, after my OME ones failed, as they were cheap.

Eventually one failed and then went over to Spitfires and haven't looked back.

Now been in the motor for around 350000km still going

Chucked the red ones in a box somewhere in a box as a sacrifice to the Gods of speed !

2 hours ago, r32-25t said:

Just go straight to r35 coils! do not pass go and do not collect $200. 

Out of interest, why change to a different setup (brackets, plug change etc)? I only run moderate power (up to 400kw) but OEM/splitfires have been fine for me in a couple of cars

2 hours ago, Duncan said:

Out of interest, why change to a different setup (brackets, plug change etc)? I only run moderate power (up to 400kw) but OEM/splitfires have been fine for me in a couple of cars

For me the cost of R35 coils including bracket was actually cheaper (and easier) than sourcing genuine OEM units. Splitfires seem to be around $700 and the cost of R35 kit was approx $1000 (on special). I assumed that a newer coil would be better for spark and provide headroom for future power increases.

So Duncan is taking the conservative approach, being that for his usage requirements, staying with the original design coils is sufficient. And, if, like him and myself (and my requirements are even lower than D's) you already have good OEM coils or Splitfires then there is no point in paying for an upgrade.

I am of the opinion though that, if I were to suffer coil death on any of my Splitfires, such that I needed to spend ~$700 to replace the lot, then I would definitely just stump up the extra to convert to modern pencil coils and buy headroom (that I might not need) but also just blast the bejeezus out of the mixture every time it sparks, making damn sure that it burns nicely. It's an opportunity to move the design of everything forward a notch, upgrade the coilpack loom to new wires and connectors, etc etc. All the things that you might not do if you just like-for-like replace.

6 hours ago, R3N3 said:

If you have an aftermarket ECU then 100% as above go R35 coils.

there’s probably a couple of simple questions like:

- What are the other mods?

- when we’re the spark plugs changed?

- what type of spark plug and what gap?

 

You don't even need aftermarket ECU/Nistune, the factory ECU and R35 coils will not misfire if you're within the bounds of the stock tune. Someone local to me has tried this and he did not have misfires with the stock tune and R35 coils before switching to a Link. He did have a no-start but it was due to horrendous fuel pump wiring and possibly a dead fuel pump.

9 hours ago, Duncan said:

Out of interest, why change to a different setup (brackets, plug change etc)? I only run moderate power (up to 400kw) but OEM/splitfires have been fine for me in a couple of cars

The ignitors are starting to fail with age as well now and the looms are getting old and brittle as well so it fixes all the problems at the same time 

Thanks guys, i'm getting a misfire and think its those red coils. It's too bad because they look decent, but i might have to shell out the money for the spitfires or the R35s... Now to decide which one to get.. If i got the R35 ones, am i going to have to get the whole kit? The bracket, coil boot covers, and the harness?

1 hour ago, kevboost7 said:

Thanks guys, i'm getting a misfire and think its those red coils. It's too bad because they look decent, but i might have to shell out the money for the spitfires or the R35s... Now to decide which one to get.. If i got the R35 ones, am i going to have to get the whole kit? The bracket, coil boot covers, and the harness?

Yes you’ll need the full kit

A cheaper alternative (with the same coils) is to get the one from efisolutions

https://www.efisolutions.com.au/coil-conversion-kit-rb-to-r35-gtr

If you have a NEO head

https://www.efisolutions.com.au/coil-conversion-kit-rb25-neo-to-r35-gtr

 

You have the option of choosing R35 coils or 370Z as well. No PRP tax.

  • Like 2

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Dredgggggeeee time; I have recently finally started driving the car. It sat for so long that the fuel tank gave birth to rust sludge and blocked my lift pump sock and one of my walbro 460's and left grime, rust chunks and muck all through the surge tank and system. I decided to commit and pull the trigger on an oem r32 gtr fuel tank and Frenchys twin 460 / sender / surge tank hanger combo and all new larger lines and fittings etc, also boost doc heater hose kit / new heater core and a heap of other bits and shits like wideband sensor installed in the dump and Syltech iacv + lines and all wired and added to current tune. now having lightly driven it a couple times without issue, I can happily report on the hta3076 in its current tune. still no boost control switched on, 20psi gate springs, car makes 22psi at 3200rpm in 6th gear with 30-50% TPS from cruise at 100kmh. Going by the old graph, this means it should be making 300-325whp at the same numbers above. Very very responsive setup under true road driving loads. all that's left for the build is body loom + PDM, finish the remote aircon setup, install carbon fibre parts and go for full tune and 30psi. the 315 rear tyres are now performing like they're 195's, wheel spin in any gear at almost any rpm, whereas my previous setup hooked up in 3rd no issue, albeit Nt01's back then / RB25 5spd vs (new) old date r888r's Z34 6spd now, + obviously all the support upgrades I listed in the quoted post above. car sits at 1-3psi on cruise at 100kmh, expectations totally exceeded and I'm beyond stoked with all this so far. IMG_4848.mov
    • I've also been eyeing their rear axles for my car. I purchased seat mounts from them about 7 years ago and they were hot garbage so I've been a little wary about purchasing them. With that being said, please buy them and get back to us haha. 
    • Can a moderator please move this into the right category.. I've accidently put this into racing build thread 🤦🏽‍♂️
    • Being a manual, we very quickly ordered new R34 gearbox (From Nissan) and remaining parts from Kudos motorsports. Would highly recommend the team there. Ultra helpful and quick to share advice and upgrades. We are in the middle of taking the Auto out (Genuine 94,000/kms) and putting the Manual in this weekend. Part 2 of the build will include likely a Plazaman Intercooler and Plenium, Hks Exhaust with Tomei Dump (ordered).
×
×
  • Create New...