Jump to content
SAU Community

Recommended Posts

Diagnosing a misfire. Anyone have experience with these kinds of coils? When i got the car, these were already in here. Wholesale Ignition Coil Pack, 6 Pieces, RB20DET Series 1 R33 for R32 RB25DET RB26DETT 22433-60U01 22433-60U02 not an actual picture, but they look exactly like this. 

Right, so unfortunately there was a time aftermarket coils became cheap and readily available, but many of them are junk, including the common yellow and red ones.  Splitfires (purple) seem to be OEM quality, or go OEM (or OEM from another car, there are lots of kits these days_.

2 screws each in the 4 screw bracket. I think that was because the front and rear brackets are identical.

If you have an aftermarket ECU then 100% as above go R35 coils.

there’s probably a couple of simple questions like:

- What are the other mods?

- when we’re the spark plugs changed?

- what type of spark plug and what gap?

 

Yes ran the red ones in R33 for about 80000km, after my OME ones failed, as they were cheap.

Eventually one failed and then went over to Spitfires and haven't looked back.

Now been in the motor for around 350000km still going

Chucked the red ones in a box somewhere in a box as a sacrifice to the Gods of speed !

2 hours ago, r32-25t said:

Just go straight to r35 coils! do not pass go and do not collect $200. 

Out of interest, why change to a different setup (brackets, plug change etc)? I only run moderate power (up to 400kw) but OEM/splitfires have been fine for me in a couple of cars

2 hours ago, Duncan said:

Out of interest, why change to a different setup (brackets, plug change etc)? I only run moderate power (up to 400kw) but OEM/splitfires have been fine for me in a couple of cars

For me the cost of R35 coils including bracket was actually cheaper (and easier) than sourcing genuine OEM units. Splitfires seem to be around $700 and the cost of R35 kit was approx $1000 (on special). I assumed that a newer coil would be better for spark and provide headroom for future power increases.

So Duncan is taking the conservative approach, being that for his usage requirements, staying with the original design coils is sufficient. And, if, like him and myself (and my requirements are even lower than D's) you already have good OEM coils or Splitfires then there is no point in paying for an upgrade.

I am of the opinion though that, if I were to suffer coil death on any of my Splitfires, such that I needed to spend ~$700 to replace the lot, then I would definitely just stump up the extra to convert to modern pencil coils and buy headroom (that I might not need) but also just blast the bejeezus out of the mixture every time it sparks, making damn sure that it burns nicely. It's an opportunity to move the design of everything forward a notch, upgrade the coilpack loom to new wires and connectors, etc etc. All the things that you might not do if you just like-for-like replace.

6 hours ago, R3N3 said:

If you have an aftermarket ECU then 100% as above go R35 coils.

there’s probably a couple of simple questions like:

- What are the other mods?

- when we’re the spark plugs changed?

- what type of spark plug and what gap?

 

You don't even need aftermarket ECU/Nistune, the factory ECU and R35 coils will not misfire if you're within the bounds of the stock tune. Someone local to me has tried this and he did not have misfires with the stock tune and R35 coils before switching to a Link. He did have a no-start but it was due to horrendous fuel pump wiring and possibly a dead fuel pump.

9 hours ago, Duncan said:

Out of interest, why change to a different setup (brackets, plug change etc)? I only run moderate power (up to 400kw) but OEM/splitfires have been fine for me in a couple of cars

The ignitors are starting to fail with age as well now and the looms are getting old and brittle as well so it fixes all the problems at the same time 

Thanks guys, i'm getting a misfire and think its those red coils. It's too bad because they look decent, but i might have to shell out the money for the spitfires or the R35s... Now to decide which one to get.. If i got the R35 ones, am i going to have to get the whole kit? The bracket, coil boot covers, and the harness?

1 hour ago, kevboost7 said:

Thanks guys, i'm getting a misfire and think its those red coils. It's too bad because they look decent, but i might have to shell out the money for the spitfires or the R35s... Now to decide which one to get.. If i got the R35 ones, am i going to have to get the whole kit? The bracket, coil boot covers, and the harness?

Yes you’ll need the full kit

A cheaper alternative (with the same coils) is to get the one from efisolutions

https://www.efisolutions.com.au/coil-conversion-kit-rb-to-r35-gtr

If you have a NEO head

https://www.efisolutions.com.au/coil-conversion-kit-rb25-neo-to-r35-gtr

 

You have the option of choosing R35 coils or 370Z as well. No PRP tax.

  • Like 2

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Depending on how long the car sat it is very possible for injectors to be stuck open or closed, I'd get them cleaned and flow tested. Other than that, obviously when the loom changes and the car doesn't start any more....the loom is suspect so some tracing / comparing may be required
    • Harness is for a s1 Rb25det, and it is engine and lower harness.  the old harness had broken off plugs and was in very rough condition/exposed wires and splices etc. it is not able to be put back on the car, I could visually inspect to see if they had rewired any pins on the ecu plug. The fuel pump definitly isn’t turning off it’s an external pump and very loud you can hear it. Will look at the other harness tonight, am also going to pull the fuel rail and watch the injectors spray, will update here with what I find. Pretty sure at this point it has to be something to do with injectors because car will fire up on starting fluid and cas is clicking the Injectors. Fuel pressure is steady 43psi 
    • Check the injectors flow evenly, and are actually flowing what you and the ECU think they should be flowing. If it's starting up on starter fluid, you have a fuel issue. Is it possible under cranking your fuel pump is turning off?   The harness you replaced, is that the whole engine harness? Do yourself a test, and drop the old harness on and plug it into the Z32 ECU. It's possible they've wired things different. From memory S1 to S2 is different in RB25 and you may have a wrong loom
    • I haven’t pulled the injectors to watch them spray yet but they are clicking from the cas and all of the spark plugs are wet with fuel. I’ve thought the cylinders were being flooded from the beginning and was hoping fuel pressure would fix it. Tonight I am going to pull the rail and watch the injectors spray. Don’t know how to test/diagnose if the plugs are firing in correct sequence but that should be a timing thing and as far as timing goes my car still has the half moon for the cas can only install it 1 way. And my mechanical timing is 100% correct I posted photos above. Confirmed with the balancer on and off. 
×
×
  • Create New...