Jump to content
SAU Community

Recommended Posts

Pull ups for wide grip lat pulldown; chin ups or neutral grip for close grip lat pulldown. Dips or dumbell overhead tricep extensions for tricep pushdown.

eh.. pull ups and chin ups.. I can't even do one of either unassisted. Will need to get elastic bands and rig up a bar in the garage... not sure if I can do that though. Anything else possible? Tricep extension I can do.

eh.. pull ups and chin ups.. I can't even do one of either unassisted. Will need to get elastic bands and rig up a bar in the garage... not sure if I can do that though. Anything else possible? Tricep extension I can do.

I'd get bands and work towards it. Chins are underestimated. Work towards weighted chins and dips

I wouldn't say that was an overly provacative photo :/

To the dude saying Charlie won't take a pic like that coz she's not in a position to look as good as she does, blah blah - You're a bit of a dick to say something like that.

Thanks for your opinion.

It wasn't a negative, more so that from my experiences people start to enjoy taking photos of themselves once they can see progress and results. Charlie is still progressing towards her goals and doing well.

hahaha love the honesty

I give nothing but and seldom care how it makes me sound :)

P.S. I don't have a FB and cbf making a BC account, so didn't vote for your car, though I did look at it. As for not replying to the PM, that was sheer laziness.

Made a new concoction for my protein shake tonight. Might seem excessive but trust me it's the only way I sleep at night.

Protein powder ~30gm protein

Banana

Milk

Bowl of nutrigrain

It's the nutrigrain part that made it, made it urgh.

porridge in the morning...every morning. With cinnamon... thermo properties son

eh?

cinnamon - stimulates thermogenesis - helps to temporarily increase your body temperature slightly which causes a slight raise in your metabolism..

cayenne and green tea also have similar properties (but not as yummy!)

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Latest Posts

    • Thanks GTSboy. I will inspect the valves actually, is this something I can do while they are still in the head? The block/bores don’t look bad to be honest hey, I can still see the cross hatches in the bores and they still measure 86.5mm. I’m not sure how to measure the installed ring gaps but I will do that and take it to someone who can. 
    • I’ve had the same headache with my lowered car, scissor jack first then floor jack every time. Ended up grabbing an extra-low profile aluminum jack (about 70mm entry height) and it finally slides under the lip without drama.
    • No sync errors , i have installed AEM disk will return original 360 slot disk and check if there’s any one with running AEM disk could share setup 
    • Its been a while! Finally thought to do something on this car, so here we go. This will be a slow burning, multiple posts as I spend 0.5-1hr a day on this job, over multiple days... Full set of GKTech suspension arms!   Step 1: Buy Arms, done! Step 2: Start removing stuff. HICAS was easy. Rear suspension arms are now gone, they were a bitch but breaker bars with long handle extensions, 2 1.5hr slots later, stock arms are off! Next step, remove the hubs and take them to work to press out the bearings and bushings!  
×
×
  • Create New...