Jump to content
SAU Community

Recommended Posts

Total washout today, sat on our arses till 4pm.

Let us out for restricted laps, somehow blew a coolant hose off when on the gas one lap :(

Then found the oil cooler leaking pretty bad once on the garage. Going to use a 180 fitting to bypass it and throw this cooler in the bin. Pretty bad quality for an Earls item, both fittings snapped off in the past, the brazing is just really bad.

Anyway, hope to be fixed in the morning for more aquaplaning :rolleyes:

Here is a skid from the other day.

Took it back to Earls when the second fitting snapped off, Martin wouldnt replace it because he said I should have come when the first one snapped?!

I said the brazing is obviously not strong enough as both fittings have snapped off... No dice.

Brand new cooler, both fittings broke off on first use, no refund?

Pretty open and shut, try once more then take it to fair trading.

Only questions I'd have are were the hoses supported well or able to move around fatiguing the joint? And when the fittings were done up was a second spanner used on the cooler end to make sure it doesn't twist.

Crap summer to be doing skids in a high power car, eh?

Brand new cooler, both fittings broke off on first use, no refund?

Pretty open and shut, try once more then take it to fair trading.

Only questions I'd have are were the hoses supported well or able to move around fatiguing the joint? And when the fittings were done up was a second spanner used on the cooler end to make sure it doesn't twist.

Crap summer to be doing skids in a high power car, eh?

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • neither stumble or cut really seem to be an appropriate term....hard to explain its like a rev limiter but at 4k, but it violently shakes engine and entire vehicle as the rpms will not rise over 4k, even with slow acceleration. as soon as it hits 4k, it sounds like entire spark is lost entirely. plugs were 1.1 which I used as such, but later put in new plugs gapped down to .8 changed back after issue arose when I replaced the coils, still does it with either plug gap...damn and it was all running so good.
    • Oh how times have changed! I actually lean it out relative to my water/methanol injector duty cycle. The methanol adds a lot of fueling and you can then lean it out even more due to reduced knock. 
    • Yeah my thoughts are the same, a well thought out WMI setup, would be slightly ahead of just straight E85 and you're also chemically intercooling the charged air, dropping it even further. This is why you need to add so much more fuel as soon as you spray. I remember someone taking me through their set up before (Dennis, has a R33, lives around Cabramatta - no idea if he's still around on this forum). He would target AFR 10:1 on 98, then as WMI ramped on, AFR would lean back up to 11:1. Amazingly, he did this all through his PowerFC, a relay to cut power to his EBC solenoid if there was not enough line pressure on his WMI kit. And of course, if there wasn't any boost made above gate pressure, you wouldn't be accessing the load cells with heaps of timing for WMI. One downside to that rudimentary setup, once the WMI came on, the EBC would unleash the dragon, and of course all the timing. Tyres would fry lol.
    • Shimmed or shimless, still solid, no hydraulic pump up stuff.
    • They have said food will be limited. Mainly meat pies and sausage rolls from memory. But they have a coffee van!
×
×
  • Create New...