Jump to content
SAU Community

Recommended Posts

Dumping twice as much cranking fuel in the engine, mine still has some issues at under 10 degrees. Obviously the lower the compression and further south you are, the worse off you will be. It really chuggs through the ethanol doing short school runs in winter...

Running the EMU previously I had no cranking enrichment table. I had to fit a stock injector into the plenum, with a 1L petrol reservoir and old stock fuel pump to get me started in the mornings. It worked well.

I'm starting to think water meth is a better idea than e85. No cold start issues, more k's to the tank, no jerries in the back on long trips. Perhaps even running 98, a secondary e85 tank and another set of injectors might work out better for me.

My car has no problems starting in the Icey cold winter monings on e85 must be atleast below 5•c outside cause there's ice on the roof and windscreens frozen starts first kick like I said before either you let it idle for a minute or if your in a hurry you just have to be smooth on the throttle for the first minute

It's all in the tune

Aslong as you have a good tuner and good spray pattern injectors should be fine cause in my brothers car when he had high flow std injectors it idled worse than my car on cold start and barely cauld accelerate for the first minute or 2 and that was on pump 98 the tuner told him the spray pattern was shit and it would have bad fuel economy and cold start so on e85 would be worse so definately need a good set of injectors Aswell

I've had my Nismo in tank flowing E85 for a good 4 years. Pulled it out for a check before Xmas and both the sock and pump looked brand new.

I have a magna fuel filter which I cleaned every 500km for 3000km then every oil change after that.

I guess I was lucky in having a clean tank to start with but I know a few people who have had dramas with pumps failing and filters blocking very quickly.

I've had my Nismo in tank flowing E85 for a good 4 years. Pulled it out for a check before Xmas and both the sock and pump looked brand new.

I have a magna fuel filter which I cleaned every 500km for 3000km then every oil change after that.

I guess I was lucky in having a clean tank to start with but I know a few people who have had dramas with pumps failing and filters blocking very quickly.

:whistling: :whistling:

They are, it's just that ethanol cleans ur tank and lines so most of the time ur fuel pump filter sock gets full of crud

I'm gona keep and eye on mine for the first month or so of using ethanol

They are, it's just that ethanol cleans ur tank and lines so most of the time ur fuel pump filter sock gets full of crud

I'm gona keep and eye on mine for the first month or so of using ethanol

I was one of the unlucky ones with a dirty tank, i blame it mainly on the idiots that removed my fuel pump ages ago and left the tank open for a few weeks :domokun: Since then nobody touches my car but me or JEM.....

I had a billet filter but it wasnt fine enough so the injectors copped it, after that we went back to Ryco inline with it and kept blocking those filters.... We re-did the whole system and cleaned the tank and its perfect now!

E70 in general is amazing BUT i had a lot of bad luck in a row which made it look pretty bad!

  • 2 weeks later...

Sorry to crash thread but i'm trying to find some quick answers without starting a new topic. I have an R33 GTS-T with a GCG Highflow turbo (XTRGTST). What power range could I excpect to get out of it?



http://www.gcg.com.a...mart&Itemid=101

There are other ways to scratch a little more out of each setup, but it gets expensive for small gains. Larger exhaust will help, as will larger cooler piping/intercooler, at the expense of response. Porting the head and cams will gain some more power also, with the same response losses. If you want more power than that, it is usually suggested to jump a turbo size or two as it's cheaper, but everyone has a different setup, funds and goals.

The hassle is the stock rear housing, depending which one you have it will restrict the amount of airflow you can get out the back, thus limiting your power.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • Can't you put the pistons to TDC and then do the valve seals? Or will the drop down too far to pull them back up?
    • One thing I can tell you is, do it properly the first time. If you encounter unexpected problems just let the car sit for a week or two if you have to get some other parts or figure stuff out.  I'd have said go and use as many OEM parts as possible but since you want to change the turbo later on a custom kit is probably the better choice. Since I have no experience with RB25 just compare parts diagrams and images before buying a line kit and it should be easy to see if it has everything you need. Amayama has very good parts diagrams and part number lists, that is what I used a bunch to figure out what I might need. And don't forget to plan ahead and possibly renew other stuff that's easy to get to while you're in there doing the turbo lines. Happy wrenching
    • Update 4:   Hi all, good news. Engine is running and all the gaskets and seals seem to be working as intended. No leaks so far, even the JB Weld seems to hold. I flushed out the old coolant a few times and put in fresh coolant, not Nissan stuff, I decided to try the Ravenol Protect FL22, they claim it works for a wide variety of JDM cars and the opinions on it by some people were pretty good. And it has the nice poison green color! And man am I glad I bought a coolant system tester earlier this year, vacuum filling works wonders on this engine. I can definitely recommend this to anyone still doing it the old school way. All you need is compressed air supply. Will have to do a small test drive as soon as I can, I removed the gauge cluster again as the tacho needle was still bouncing around a bit but it was much better than before already.  I also found some cracks on all 4 tires inner and outer sidewalls. Apparently these tires should 't be parked on for extended periods or be kept under 0 degrees during storage, which I did not know. Clearly the previous owner didn't look into those details either, he probably bought them just cause they are cool semi-slicks. I'm just wondering how tf I am supposed to reach 30-80 degree tire temperatures on the public road consistenly, these tires were never going to work for my use case. I'll probably order Continental SportContact7 ones as these are the best allround summer tire available right now and I don't think I'll need anything crazier for now. Do let me know if you have experience with various tires and which ones you recommend.
    • You have no idea how many goddamn boxes I received these past three months haha Most have been put to use by now though, luckily
    • Not going to pretend I didn't do a bit of junky work this time around, but mostly due to the fact that some things I am not willing to spend days fixing right now, like wiring. I try to do most things properly the first time around.
×
×
  • Create New...