Jump to content
SAU Community

Recommended Posts

So it’s been over a year since an update.

The first event last year was the Poatina Mountain Race, it was pretty much a 7km hill climb with the option for a navigator. I put my girlfriend in the silly seat to call the notes. We came 5th outright, and were the fastest 2wd car up the hill for the day.

484894_10152232320262188_474206960_n.jpg

The next event was Targa Tasmania. As the car was going well I didn’t make any changes to it before the event, just freshened up the parts. But I did have a new navigator in Julie Winton-Monet. For the first 3 days we controlled the early modern competition. We won every stage on the first day and ended with a 30 sec lead.

On the second day we won all bar 1 stage and put another 30 secs on the field. Happy with our 1 min lead we backed off a bit and kept an eye on the times so we could slowly pull a gap, while being easy on the car. Our main competition had an oil pump failure, which gave us a 7 min lead at the end of the day.

Day four was really wet, so I put my green tyres on and filled the boot up for extra traction. We took off from the first stage and the alternator light came on, I turned everything electrical off I could and limped to the end of the stage. I got out and checked the belt and checked the plugs on the alternator. But it was all over, the battery went flat. The voltage regulator had failed. We got a jump start and limped along behind the field for the rest of the day dropping 30 mins.

We replaced the alternator and attacked day 5 at full pace. It was another wet day, and it turned out that the car is pretty good in the wet. We were 3rd overall on the wet first stage, only 5 secs behind the winning R35 GTR, it was our stage of the event. The stages ended up drying out and we won the last stage outright, which we were pretty happy with.

Targa was a what could have been, but sometimes that’s just how it is.

10580838_720072244731439_227152757468877
10553699_720072151398115_304434144055389
10552466_720071921398138_836836185488384

I had a lot of problems for the next few months. I blew a head gasket 3 weeks after Targa. So I pulled the engine down and found the head was damaged from valve float. I got that repaired and put new rings and bearings in the engine.

Next event the diff exploded, turns out when you take a diff to be checked, it means reset the pinion to the wrong position. When I had the car apart again I noticed it had pushed a heap of coolant out. I had to pull the engine out and get the block decked. I hadn’t checked it properly when it was apart the first time.

I put everything back together and headed to the Legerwood Lane hill climb. I finally had a good event coming 2nd overall and fastest 2wd.

Next event was the Phillip Island support race for the V8 Supercars, which would be my first ever open race meet. I loved the track. My fastest lap was a 1:43.9 which qualified me 4t, there was more time to be had, but I ran out of laps. The car was way too soft, it was still in full rally trim, but I had to live with it.

I finished the first race 2nd after 2 people dropped out. I finished the second race in 3rd and hit a seagull going over the start line. Last race I came 3rd again after some wheel to wheel on the first lap. I got 2nd overall for the weekend.

1922089_795179067209832_4465319367135263

1533733_782811248457538_3069334423641519

1459143_782810905124239_5375044671092430

Edited by sav man
  • Like 4

Next event is Targa Hellyer Gorge in 4 weeks. Targa have released new regs, which mean I need to add 100kg to the car. I'm currently putting the weight in, and re-springing the car to suit

EPIC!

Re Targa. You have had a few problems with alternators haven't you? Have you seen those $90 lithium jumper packs? Keep two of those in the car, they are only the size of two old VHS tapes. Hell, I would wire up a dual battery setup so at least if the alternator goes you can get through on battery power. What is another 8kgs?

We had a problem that the standard alternator couldn't drive the heated windscreen. I got a maxima 110a to drive it and that's the one that failed. I disconnected the passengers side of the windscreen to get round the current draw issue.

With the new regs I will be carrying a lot more spats

EPIC!

Re Targa. You have had a few problems with alternators haven't you? Have you seen those $90 lithium jumper packs? Keep two of those in the car, they are only the size of two old VHS tapes. Hell, I would wire up a dual battery setup so at least if the alternator goes you can get through on battery power. What is another 8kgs?

12V Lithium jumpers for $90? Where can I find these?

We had a problem that the standard alternator couldn't drive the heated windscreen. I got a maxima 110a to drive it and that's the one that failed. I disconnected the passengers side of the windscreen to get round the current draw issue.

With the new regs I will be carrying a lot more spats

Spats or spares? BTW what were those green tyres you mentioned for the wet? Cheers

Spares is what i meant.

We are able to run 8 tyres for Targa, so my plan was to run the first set into the ground, and save the new (green) tyres for the end or the wet.

I run Dunlop D03 in R2 compound

  • 1 month later...

I converted my car to the new Targa regs a couple of weeks ago. I bought 80kg of lead from the scrap yard, made a mould and melted it down with an oxy torch.

7E8903C6-625B-4D40-A9A9-14008862464F_zps

9249F095-2E6D-4940-9195-E244732CD1C3_zps

The car now has 51:49 weight distribution, which has given it awsome drive, but it understeers like a pig. Once I get some new springs and a rear sway bar it should make it better. Rear shocks will probably need a re-valve too.

I ran Targa Hellyer gorge last weekend. I ended up changing the lift and pressure pump during the event, as the 044 got very noisy, so I replaced it, then it got noisy again. Turns out the lift pump was failing and filling the surge tank while I was idling around, but but running out under load. The event also gave me a starting point for the new regs, so I know what I need to change to make it faster.

10960299_863144057041966_398360849286384

Edited by sav man

Is there something in the regs that says you have to run it inside the cabin? Personally I would make the lead into 5kgs sheets/plates and bolt them to the underside of the car.

I always envisaged running it under where the back seat would go. Close to the COG but between the axles and nice and low. That way you can run perhaps 3 under the rear seat to two under the drivers seat. Lowers the the COG and can play with weight distribution as you see fit

yep now 1430 with driver and nav.

Regs say you can put it where ever you want, only restriction is on mounting plates and bolts. I was looking at putting the weight above the diff, but there wasn't enough room and it was going to be way too hard. The chassis rail is restricting the bricks being any wider as it is

  • 1 month later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • To follow up a question from earlier too since I had the front bar off again (fking!) This is what is between the bumper and the drivers side wheel And this is the navigator side, only one thing but its a biggy! So basically....no putting coolers in the wheel arches without a lot of moving other stuff. Assuming I move to properly race prepping this car I'll take that job on and see how the computers respond to removing a whole bunch of ADAS modules
    • So I prepped the car for another track day on Wednesday (will be interesting to see coolant temps post flushing out and the larger reservoir, with a forecast of 3-14 being 20o cooler than last time I took it out). Couple of things to mention; since I am just driving the car and not taking a support vehicle, I took the rear seats out and just loaded the back up Team Trackday style. Look at all that space! To cover off removing the rear seat....it is weird (note the hybrid is probably different because it wouldn't have folding rear seats) Basically, you remove the lower seat base, very similar to a r series but it is a clip that pulls forward to release the base rather than it being bolted down. Easy Then, you need to remove the side section of the rear seat on each side. There is a 14mm head nut at the bottom of the side piece, the it slides upwards off a hook at the top to release; you also need to unhook the seatbelt from the loop at the top. Then the centre piece is weird. You need to release/fold the seats forward with the tab in the boot on each side From there, there are 2,x12mm headed bolts holding the rear of each seat to the folding bracket, under the trim between the rear seat and the boot (4x christmas tree clips there, they suck). The seat is out but you can see where the bolts attach to the bracket
    • As discussed in the previous post, the bushes in the 110 needed replacing. I took this opportunity to replace the castor bushes, the front lower control arm, lower the car and get the alignment dialled in with new tyres. I took it down to Alignment Motorsports on the GC to get this work done and also get more out of the Shockworks as I felt like I wasn't getting the full use out of them.  To cut a very long story short, it ended up being the case the passenger side castor arm wouldn't accept the brand new bush as the sleeve had worn badly enough to the point you could push the new bush in by hand and completely through. Trying a pair of TRD bushes didn't fix the issue either (I had originally gone with Hardrace bushes). We needed to urgently source another castor arm, and thankfully this was sourced and the guys at the shop worked on my car until 7pm on a Saturday to get everything done. The car rides a lot nicer now with the suspension dialled in properly. Lowered the car a little as well to suit the lower profile front tyres, and just bring the car down generally. Eternally thankful for the guys down at the shop to get the car sorted, we both pulled big favours from our contacts to get it done on the Saturday.  Also plugged in the new Stedi foglights into the S15, and even from a quick test in the garage I'm keen to see how they look out on the road. I had some concerns about the length of the LED body and whether it'd fit in the foglight housing but it's fine.  I've got a small window coming up next month where I'll likely get a little paint work done on the 110 to remove the rear wing, add a boot wing and roof wing, get the side skirt fixed up and colour match the little panel on the tail lights so that I can install some badges that I've kept in storage. I'm also tempted to put in a new pair of headlights on the 110.  Until then, here's some more pictures from Easter this year. 
    • I would put a fuel pressure gauge between the filter and the fuel rail, see if it's maintaining good fuel pressure at idle going up to the point when it stalls. Do you see any strange behavior in commanded fuel leading up to the point when it stalls? You might have to start going through the service manual and doing a long list of sensor tests if it's not the fuel system for whatever reason.
×
×
  • Create New...