Jump to content
SAU Community

Recommended Posts

Few days ago, Carlisle ave, just up from the Luxford rd traffic lights. heading away from GWH . Black R33 gts-t, female driving . I've seen you before on GWH, St Clair/St Marys, but a male was driving . Guessing its your partner? Either way, nice car.. And no, I wasnt attempting to race you, I was running a little late to see a lady friend, so my acceleration rate was a little... 'quicker' . Lol.

A couple of days ago, heading south on the F6 to wollongong, I was passed by a silver (I think?) Clean looking R33 Gts-t, and a silver R32 GTR that had a nice stance, Plates were something like ZIILLA.

I was in the black 32/4 (PIG)... driving slowly in the left hand lane like a granny, 'caus that's how I roll..:ph34r:

GTR's a-go-go for me this week!

Gunmetal R32 at BP Valley Heights. R34 wheels and tasty blue anodised calipers, very neat looking. :thumbsup:

Sounded very sweet coming on boost and snaking up the highway as I was filling up my daily.:thanks:

Made my night seeing one driven like they should be.

spotted a white r34 gt(t?) on the M4 onramp at concord. it was parked on the side and had big damage in the front end. must have hit another car or put it into the wall. shame it looked like a pretty nice car from what i saw.

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • Hi. This is just my curiosity because iam sure the tuner figure something out...but either way i want to ask. The "problem" is that the Nistune ECU (Stagea FW and RB25DET NEO from Stagea) sees many times the speed than the speedo does(he says the speedo show 120 km/h - correct speed and the ECU shows like 510km/h ) I told him that this car/tranny getting speed from rear diff. If iam not mistaken the RB25DET NEO "need" to see tranny speed sensor? (my tranny has the plug for it). So couple of "question" If he connects/wire the speed sensor to the tranny...are the signals gonna intervene and if...what if he disconnects the rear diff one and the speedo stops working? Or the "new" sensor from the tranny "take over" and will not going need the one from diff? As i said i know he figure/get that done...iam just curious to know what are the solutions 🙂 
    • Your IACV is set to idle too low. You need to adjust it via the screw Duncan mentioned. From memory it should be 650rpm with the valve electrics unplugged. What is it trying to idle at with the IACV plugged in?
    • Ahhh, I need the whole head unit. I definitely needed to roll back through and review your setup, ha ha! Neat setup they have going on. I just need a full double din head unit. But I want good and responsive. I might have to review what the likes of pioneer have out these days.
    • Ok so after much research and talking with knowledgeable people I've got my turbo conversion done and it's all running great other than 1 small issue.  Car has remained auto with the na auto and tcm, I've used a stagea ecu with. NIstune board and everything is great other than my gear selection on the dash. It illuminates park, reverse, neutral, 3rd and 2nd. But nothing drive or what gear your in when you pop it into tiptronic.  I'm sure there is may e 1 wire in the ecu plug I need to move to rectify this. Dose anyone here have any ideas?   Cheers guys
    • Sorry I haven't been following all the detail, so you may have tried this. Does it idle with the tiniest bit of throttle you can add? You've mentioned the IACV, does it have an AAC valve and have you adjusted it at all (ie, screw the idle adjust screw all the way in, then back it out a couple of turns until idle is stable)?
×
×
  • Create New...