Jump to content
SAU Community

Recommended Posts

  • Replies 164
  • Created
  • Last Reply

Top Posters In This Topic

I'll be there. thinking about entering my nugget. can we get an award for most shagged front bar lol?
You and Cassbo can ro-sham-bo for it. :D:P
Lolz. I think mine is worse then Cassbo's

Did anyone else hear that? Sounds like a challenge was laid down :(

*Watches Cassbo fit factory front bar again*

Factory front bar has been on my car since the night before Putty Rd cruise :D

I just have an unfair advantage of being able to drag it under my car for a week and still have another front bar good to go :P

  • 2 weeks later...

Well, since it seems that I am fast becoming the self appointed NSW SAU Videographer I do plan to enter my car and spend the day shooting footage of all of the cars. Are there going to be any "special events"?

Also, are the "winners" going to be announced on the day? Would be nice if I could get special footage of their cars and do a small "feature" on each with the owner. Any chance of that?

A proper timeline of the day is still being sorted out, but I can tell you the hours right now :wave:

Regular entrants may turn up from 8am

Special entrants (trailered cars/stall owners etc) may turn up at 7:30am to have a bit of extra time to move things around without having cars in the way :(

Show Officiall opens at 10, goes til 4.

No one will be leaving before 4pm.

good question brus.....food. very important. Might have to bring the tail-gater.

Guys, probably already been covered but what is the adress of the show-ground? Ill have to put it in the GPS as ive no idea around Sydney. Looks like a 6.00am start...fun.

will there be places to get a feed? I may pack some lunch if we gonna be there till 4
Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • Yeh I think i'll message an old contact i had for ages that manages his own tyre shop now.. n tell him what i want n work with him before ordering..  Got this 17x9 +30 Driftteks on 245/45/17 PSR Drag Radials on the rear.. They fit well - for your reference in future - Rear guards  have been lipped in & minimal to non flaring of the rear Gaurds.    
    • If only it were that easy! I also needed to remove seats, shocks, brake calipers, send my car through a fence, and use measuring and ended up guessing because I didn't remove seats, shocks and brake calipers. It can be hard sometimes Can be a little more complex than 'just measure' if you want to truly measure the entire wheel through all of it's suspension travel. But if you aren't going for every last mm then yeah, you can check the space you currently have and guesstimate.
    • If you own a car, and it has wheels on it, and you know the offset of those wheels, and you have a measuring device, you have everything you need to work out if other wheels will fit.
    • Will this fit? but they are staggered set - RAYS 57DR SEMI GLOSS BLACK 18x8.5 +37 | 18x9.5 +38 5-114.3 STAGGERED SET   or If no go could just get a set 4's wheels of 18x8.5 +37 5-114.3 - would i run 8.5's 235s up front n 245's at the back if I do?   Thanks.        
    • Put a clamp on your return line. I have a feeling it's sucking air, and introducing bubbles to your fuel. With a lot of fuel, less problematic. I'd honestly be redoing all the lines in the tank and clamps on everything.   Also, you've given two different answers to the same question: Asked if being followed by the police you could get down to use the whole tank, you said yes you could, so long as you keep off boost. However, you then followed this up that free revving, it would also cause the issues. I'm doubting free revving is enough to make any noticeable boost on what is likely a decent sized turbo.   So now I have to ask, can you actually drive it lightly and use all the fuel, or does it break up even free revving? Also, have you put a fuel pressure gauge on it? Can you hear the pump change noise at all when you're having this issue?
×
×
  • Create New...