Jump to content
SAU Community

Recommended Posts

The Grill Room, i posted early in the thread etc - It used to be a Squires Loft, and then went out on their own years ago.

So it's certainly "up there".

Been to the CBF Squires Loft a few times myself, very good venue also.

LOL @ Pub, everytime i've had a steak @ a pub - asked for Med Rare, it's come out with only a slight tinge of pink in the middle.

You get over trying to have an argument with the staff about how it's not Med Rare and some 17yo comes outta the kitchen to try and tell me I'm wrong :D

Agree, never had a bad steak at The City Grill Room. Highly reccomended.

Edited by llama_au

what should i do wth my car

lots of things wronhg with it :(

would rattle of a fair $$$$ fixing it all

almost too much wrong to sell as well

ho hum

What's so wrong with your car? I could get a rwc on mine straight away no probs :s

just general wear and tear given the kms it has

i mean its in good nick considering

but yeah some things need work

wheel bearings

diff

tyres

wheels need paiting

engine refresh

paint touch up

just general wear and tear given the kms it has

i mean its in good nick considering

but yeah some things need work

wheel bearings

diff

tyres

wheels need paiting

engine refresh

paint touch up

Weigh up how much to fix it all.

I bet parting it out might be an option

yeah i mean it will keep going

but i would like to fix some of the things

ie the wheels are farked

the diff is hopeless

engine is tired

anyhoo we shall see

gonna buy another daily so will have some options

what should i do wth my car

lots of things wronhg with it :(

would rattle of a fair $$$$ fixing it all

almost too much wrong to sell as well

ho hum

park it in a river

When i can stomach paying more than 5-600 for a radiator i'll consider it >_<

my alloy radiator was like $300ish from memory, couldn't get the car to overheat if I tried :)

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • So, this shouldn't be such a mission, but there were a few tricks so I thought I'd post up a DIY for it. This was on a Q50 Red Sport but I doubt any other V37 model is very different (maybe just less steps for the intake heat exchanger hoses) I pulled the radiator out to flush it because the car was running hot at the track, but obviously the same steps apply for changing a radiator for any reason including an upgrade. If you are removing the radiator, you of course need to drain and refill, so have 5+ litres of blue coolant ready. You don't need to drain the intake heat exchanger to remove the radiator but depending on your plans you may need a couple of litres for that as well. You will also need something to deal with the auto transmission lines, I used 2x 8mm rubber caps on the radiator side, and a short length of 8mm pipe on the car side.....unless you can block these lines quickly you will loose AT fluid and it may be enough to hurt the transmission if you don't refill it. Other than that....lets go... "First, jack up your car". Yes really, and put it safely on stands. If you are not confident doing that you need to give this job to a mechanic
    • If the forester is anything like our old 2007 GTB Liberty, I could near on run ling Long's and "rate them", as no matter what, it just hung to the road, even when abusing it in a hard launch in the wet, or throwing it at corners.
    • LOL, all of the CAI like Craig I just need to put a hole saw through my bumper Done and dusted, the car runs, which is nice, I'll take it for a spin when the weather clears up Just need to put the bumper back on for good
    • Brooooo Please send ABS control unit schematic Please! R33 gts25t ABS (Its two plug ecu, black and white) wire colors possible? [email protected]
    • Don't even try to run it on the stock ECU if you're going to have the boost controller bring boost above ~10 psi. I've already told you that. If you use the Nistune ECU, you will need to CAREFULLY read the available documentation for Neo tuning, and read some threads on the Nistune forums, to discover the various things you have to do to prevent the ECU from going bananas when the boost is too high. The is a table associated with th boost sensor that must be modified to prevent it from shitting the bed. This is just one of the things that you will need to do to the tune in Nistune, because the Neo turbo ECU will be expecting to see a number of things (such as the TCS) that are not there, and you have to block the DTCs on those. It is totally not surprising to me that you are having the problems that you are, but the solutions to these problems have been known for >15 years. So just get it done.
×
×
  • Create New...