Jump to content
SAU Community

Recommended Posts

Worh the comparison i can see that now. What did it cost?

300$ for a set of headlights

120$ for the 3 pairs of halos

And about 1 or 2 hours of your time

(one of the smaller rings turns orange with the turn signal on the headlight with 3 halos)

  • Like 1

Power steering belt replaced on the 260, took 3 days lol. (Lazy b$%td)

940 came off, was shredding not completely foobah.

960 on hand..........too long.

925 on hand...........way too short.

Bought another 940.....................effin tight as to fit but works OK.

Hindsight suggests 945 or 950.

Amen.

GW

Failed a Warrant of Fitness with it. :( Leaking front left shock. Do these match any other model's OEM shock? I had a quick look through the suspension thread but everyone seems to be not married to accountants and they go straight to coilovers.

Failed a Warrant of Fitness with it. :( Leaking front left shock. Do these match any other model's OEM shock? I had a quick look through the suspension thread but everyone seems to be not married to accountants and they go straight to coilovers.

Part number 56110-7W026 is for the front left shock according to FAST.

From August 2004 on VQ25DD and VQ35DE RX Four models.

Not used on any other Nissan.

I got KS-ROM ECU today and replaced with OEM one. Will test the power output next week with my Blitz powermeter. Current my best record is 6.5s for 0-100km

attachicon.gifImageUploadedBySAU Community1434630026.869021.jpgattachicon.gifImageUploadedBySAU Community1434630011.402433.jpgattachicon.gifImageUploadedBySAU Community1434630044.119363.jpg

attachicon.gifImageUploadedBySAU Community1434630273.532056.jpg

Nice, were you able to order it with your mods listed? Or was it just a random tune from someone else's car?

  • Like 2

Nice, were you able to order it with your mods listed? Or was it just a random tune from someone else's car?

absolutely random tune from someone's car. it is really hard for us to get specific tune from Japan

absolutely random tune from someone's car. it is really hard for us to get specific tune from Japan

It is near impossible hence the question. Make sure you get it on a dyno sooner rather then later to at least make sure the tune is safe.. you never know what it could be tuned for. Maybe even different injector sizes

It is near impossible hence the question. Make sure you get it on a dyno sooner rather then later to at least make sure the tune is safe.. you never know what it could be tuned for. Maybe even different injector sizes

yes, it is true. but from what I know for KS-ROM, it is a light tune and it is suitable for factory car, not like impul and nismo ECU. anyway, i will try to figure out if the ECU is safety for my car or not.

currently I have EBC on my car that could avoid over boost, that is the biggest risk for unknown tuned ECU.

Edited by YangLIU

yes, it is true. but from what I know for KS-ROM, it is a light tune and it is suitable for factory car, not like impul and nismo ECU. anyway, i will try to figure out if the ECU is safety for my car or not.

Talk to mark at MRC castle hill. See what he will charge juat for a quick dyno test. He has na awd dyno so woild be able to do it without pulling shafts etc

Talk to mark at MRC castle hill. See what he will charge juat for a quick dyno test. He has na awd dyno so woild be able to do it without pulling shafts etc

yup, i always do the service from MRC. thanks mate.

  • Like 1

Went to start the car this morning to go get a coffee and no start. It sounded like a fuel pump issue and sure enough it was! The DW301 was dead, only 2ish years old lol. Pulled it out and put 12V on it and its totally dead.

DW301

Ordered premium plates just for cosmetic reasons. South Australia premium plates look much better on Jap cars if you use a large rear (on the rear) + a normal rear (on the front).

I've also saved probably twice as much cash as i need to look at better tuning for the M35 plus i'm still holding onto the Manual dream.

Edited by Beregron

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • To back this up, I'm always looking on the outside, seeing the level, and then opening it up anyway, as I'm worried the level I've looked at, is more so a scunge line. Then you end up dipping your damn finger in it too depending on the type of tank you're looking at just to make sure I'm not going insane.   PS, Mark, polish up the none moroso one a bit and then give it a clear coat. The Moroso one looks to be way shiner (not mirror polished, just shinier) and it'll still look weird with the two different alloys beside each other. Either that, or Id probably paint them a flat black...
    • Good old Orange Park hey... 😛   f**k I miss that race track
    • lo, it was a death trap. Good times. Got any Fatz Drift Day DVDs still available?
    • Yes, overthinking. Many PS reserviors are completely opaque. Our Skyline ones, for example. Have to remove lid, peak inside, swirl the dipstick, try to remember how to read it, etc etc. Normal. Radiator overflows are often sufficiently opaque and scunged up that you can't see the true level inside anyway, and have to open and have a peak. Besides which, I replaced the (massively expensive, even back then) plastic overflow in my Alfa GTV, back in the '90s with a stainless one that I had a good fabricator make up to be dimensionally same-same, that looks remarkably similar to the Bogan's Moroso one above, and I never suffered any particular paranoia that I didn't know how much coolant was in it.
    • Looks great, but I'm always concerned that it makes it difficult to see what level the fluids are at. Am I overthinking this?
×
×
  • Create New...