Jump to content
SAU Community

Suspecting Gearbox Problems

Sage222

By Sage222,
in Four Door Family & Wagoneers

 Share

Recommended Posts

Sage222 Rising Star

Sage222

Posted
Posted (edited)

So i seem to have a wierd issue with my m35.. just doesnt feel right under accelaration and numerous times the speed is going up though the revs are not.. (yes i know slipping is the other way round!) i must admit i am new to automatic gearboxes and this is the first i have ever owned and i might be simple paranoid though at approx 2800rpm and above some wierd shit is going on...

car pulls great up to then..though once it hits approx 2800rpm then the engine noise changes to what sounds like air blowing (yes thats very vague) and despite is still accelarates it doesnt accelarate well like it should..

just checked the transmission oil and its running way too much (about 1 cm above the full line when hot).. the oil itself doesnt look too old though it is not the red stuff i was expecting..

so how hard is to change the gearbox oil and filter? i have read Nulon or Matic S is the way to go.. how much work am i looking at and where do i get a filter? (350z is the same i presume?)

once again appreicate all your help.

Edited by Sage222
Link to comment
https://www.sau.com.au/forums/topic/373785-suspecting-gearbox-problems/
Share on other sites
  • Replies 46
  • Created
  • Last Reply

Top Posters In This Topic

Popular Days

Top Posters In This Topic

Popular Days

ironpaw Veteran

ironpaw

Posted
Posted

I had a similar issue when my car was worked on by the gas conversion mob.

It would rev up but then when it hits boost all I get is a crap load of hissing sound.

Scott looked at it and found some pipe was loose. Can't remember which one...

zei20l Grand Master

zei20l

Posted
Posted

So i seem to have a wierd issue with my m35.. just doesnt feel right under accelaration and numerous times the speed is going up though the revs are not.. (yes i know slipping is the other way round!) i must admit i am new to automatic gearboxes and this is the first i have ever owned and i might be simple paranoid though at approx 2800rpm and above some wierd shit is going on...

car pulls great up to then..though once it hits approx 2800rpm then the engine noise changes to what sounds like air blowing (yes thats very vague) and despite is still accelarates it doesnt accelarate well like it should..

just checked the transmission oil and its running way too much (about 1 cm above the full line when hot).. the oil itself doesnt look too old though it is not the red stuff i was expecting..

so how hard is to change the gearbox oil and filter? i have read Nulon or Matic S is the way to go.. how much work am i looking at and where do i get a filter? (350z is the same i presume?)

once again appreicate all your help.

no its matic J, DONT put matic S in it!!!! it will destroy your transmission.

mine sometimes does that too, doesnt accellerate as hard as it should, i just kick it back a gear. its entirely possible youre not pushing the throttle enough to force the torque converter to unlock.

ironpaw Veteran

ironpaw

Posted
Posted

no its matic J, DONT put matic S in it!!!! it will destroy your transmission.

mine sometimes does that too, doesnt accellerate as hard as it should, i just kick it back a gear. its entirely possible youre not pushing the throttle enough to force the torque converter to unlock.

REally? Matic S will ruin the box? I thought S is better then J?

Isn't it Matic D that's bad for the tranny?

Sage222 Rising Star

Sage222

Posted
  • Author
Posted (edited)

nah its not 5th i have confirmed it happens in every gear by driving round in manual.. ironpaw sounds like he had the exact same issue.. come on scotty you must remember what pipe!:)

its almost as the engine isnt seeing the boost..

Edited by Sage222
Ross Collaborator

Ross

Posted
Posted

The box is suppose to be service free, unsure if there is a filter to change.

The fluid is simple to change, just warm the car up, drain the box via the lower plug.

Then drain the transcooler.

Replace the same volume of fluid as you drew out of the box and cooler(around 4-5 L) via the transmission fluid inspection pipe located next to the fire wall.

A full flush involves more work and uses a fair amount more fluid (8-10ish L?).

There are youtube videos for G35s/350z that can be of some assistance if you get stuck.

zei20l Grand Master

zei20l

Posted
Posted

there is no filter, but there is a strainer in the valve body. its worth probably cleaning any metal bits out of that. but youll need to remove the pan.

just remember to check the fluid level after you have filled it. go for a short drive and check it again after.

iamhe77 Grand Master

iamhe77

Posted
Posted

What colour is it if is isn't red???

What was used in it and whom did the service?

I'd drop a little out of it (unhook one of the trans cooler hoses) and make sure it is on or just below the "FULL" line when hot.

I know if you have too much or too little in there it can do what you are describing.

no its matic J, DONT put matic S in it!!!! it will destroy your transmission.

Nup, Matic S is the synthetic replacement for Matic J (which is a semi-synth) and will be fine for our transmissions.

It's Matic D (or Dextron III) you can't put in there

Sunkist Grand Master

Sunkist

Posted
Posted

What colour is it if is isn't red???

What was used in it and whom did the service?

I'd drop a little out of it (unhook one of the trans cooler hoses) and make sure it is on or just below the "FULL" line when hot.

I know if you have too much or too little in there it can do what you are describing.

Nup, Matic S is the synthetic replacement for Matic J (which is a semi-synth) and will be fine for our transmissions.

It's Matic D (or Dextron III) you can't put in there

not going against what your saying, but ive been tod by ALOT of trans auto joints that its not bad to overfill by a little, and that a lot of trans joints actually overfill

bigkevracer Grand Master

bigkevracer

Posted
Posted

not going against what your saying, but ive been tod by ALOT of trans auto joints that its not bad to overfill by a little, and that a lot of trans joints actually overfill

Isnt that when cold though? And just below the line when hot = just above the line cold?

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing


  • Similar Content

  • Latest Posts

    • joshuaho96
      Tomei gasket

      By joshuaho96 · Posted

      I've heard the Tomei USA head gaskets are decent if you want to o-ring the heads but otherwise not recommended.
    • GTSBoy
      What brakes on R34 GTT(Europe)

      By GTSBoy · Posted

      The 296mm rotors are the R33 turbo brakes. The 310mm rotors are the R34 turbo brakes. The calipers are nearly the same, but not. They're the same caliper but the R34 caliper has longer legs so that it sits out far enough to go over the rotor. The pads are the same for both. When you say, "I bough tsome EBC"....did you just mean pads? Or rotors? 310mm rotors fit under 17" wheels. There may be some wheels without enough clearance though. I can't fit my fingers between the barrel of my wheel and the "corners" of my R34 calipers, but there is plenty of room behind the spokes. This is on Enkei RPF1. You can fit 324mm rotors inside a 17" wheel, but I'd be willing to bet that it would be close to impossible with the Nissan/Sumitomo caliper (using an adapter, of course), because the Sumitomo caliper is fatter than the Brembo caliper that is supposed to go on the 324mm rotors.
    • Kapr
      What brakes on R34 GTT(Europe)

      By Kapr · Posted

      Hi. Can someone tell me what brakes(and mainly WHERE) can i buy brakes on R34 GTT? I bought some EBC which SHOULD go on my car(i have GT but it has GTT brakes) but it does not fit, Brakes are "too" small(296mm) Are 310mm be good or? I have 17 inch wheel so no "big boys" but for me driving i just need one that fits and i can get here in EU/Czech.
    • Marek
      Hi everyone.

      By Marek · Posted

      Since winter isn't that harsh anymore in Poland, i will definetely drive it 365 days a year 😉. But if the snow hits i will try it for sure and let U know. Only swap i am planning to do is of course R34 GTR front 😍.
    • Marek
      WGNC34 - floor mats

      By Marek · Posted

      Hey. Very valuable information about pitwork, I will pay attention when buying any consumable parts 🙏 As for the carpets - I got a handful of information from nengun, from which it appears that indeed the carpets for the driver's side are OEM. They are not able to show me any pictures due to the long chain of different sales entities but after I place the order, as soon as the goods arrive at the nengun warehouse from which they will send the shipment to me they can send me photos and if my purchase differs from OEM I can immediately return it / cancel the purchase. I think I will give it a try 😉. Of course i'll let you know what's what as soon as i get them P.s. I know the topic is not relevant to the thread, but both nengun and amayama have these SICK 😍 trunk room lamps available. Do you know anyone who ordered them? I need to have one in my car
×
×
  • Create New...