Jump to content
SAU Community

Recommended Posts

Plenty of RWD skylines around here that are far from stock with plenty of traction :thumbsup:

+1, huge power rwd can have traction if setup is spot on.

With Supra, I'm not looking for huge power, only BPU since it'll be easier for me to get a roady (I go through many cars).

this is SS8_Gohan's car right?

I've seen a few of these shot on the internet but not on here?

tumblr_lysuj4G1Cw1qzwo50o1_500.jpg

(if these photos are not meant to be seen, please tell me to delete/edit this post. just curious is all)

This crab is tougher than Kris' brother:

rofl

Grant why would you want massive power on a rwd car, it's no good if you can't put it down.

spoken like a true GTR elitist... ;) 325rwkw over here and lovin' it!

this is SS8_Gohan's car right?

yes... and that's even Daniel himself in the car! ZOMG!

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • Possibly avoid using a Cometic one unless the deck/head surface are perfectly flat. I did have a look just then and forgiving gaskets such as Tomei or Nitto don't exist for the FJ20, however the Bar-Tek or Kameari ones look good and might do the trick.
    • Because pipe threads for pipe things. M threads for bolt things. Throw some teflon sealant onto it and dust your hands off knowing you did the right thing, instead of going twice around the block to achieve a result using the wrong things. Of course, all of these solutions are ignoring the fact that the minimum thread pitch we're talking about here is 1.25mm, with the 1/4" in NPT or BPS being out around 1.4mm. You will need to know that the boss you're tapping has enough thickness for at least a few threads. That's one of the reasons that 1/8" is commonly used - because the pitch is <1mm. And why would you look to use 1/4" NPT in a BSP country anyway? Ugh.
    • Just throwing around ideas, does it need to be in the compressor cover? Why not the hot side piping?
    • 1/8NPT drill size = 8.7mm. Since the hole got messed up by me, it’s probably around 9mm.    So 1/4” NPT would be next step. A drill size of around 11mm would be preferred there which is not way of my M12 (drill 10.5mm and tap M12 threads) 
    • 3 Kids are starting to hit that ages. I wanted to get them something special to learn on, put down the screens and have some fun. 4Door 2001 R34DE Black Pearl GV1 Jap Import, AU 2nd owner. Pre Work done. Suspension - Wheels Pedders SportsRyder Coilovers   Wheels TSG Spokey Boi 18'x9.5"+15 Body JASI Aero 4 door Type R Full Kit LED Conversion - Parker, Blinkers, & Reverse Exhaust Hurricane Headers 100 CPI high flow cat 2.5" Piping Cannon muffler Internal Bride low max stradia ii - front seats  Bride RO seat base and Rails (R/H) Cube short shifter LED Conversion - Interior   
×
×
  • Create New...