Jump to content
SAU Community

Recommended Posts

Would be good if the power FC was like the cappa flash tuners that way you can store a 98, e85, valet tune and not actually get pulled up on it by the cops because it still only flashes the factory ECU so you don't actually need anything plugged it

inb4 fords are gay, bikelineaustralia etc.

Since this thread is now run by crotch rocket enthusiasts.

Compared to cars, how expensive/cheaper are insurance on these things?

Generally cheaper, but what car and what bike are you comparing? My R1 is ~$800/year full comp, plenty of cars cheaper than that, plenty more expensive. Also plenty of bikes that cost ~$1400/year full comp and plenty that are ~$400/year. Plenty.

Cut up standard ECU, cover PFC in standard ECU housings, use a laptop to switch tunes!

4350772539_55ff96415a_o.jpg

I didn't want to cut up my ecu, so I just switched the covers on the pfc front to back, so the big apexi logo faces inwards. Put the Nissan sticker on the outside of the pfc, done.

Inb4 hwp

Birds, say your GTST and R1.

Both cost me ~$800/year full comp. Just pick a bike you like and do an online quote with a bike insurance company, that will give you the best idea. There are too many variables involved.

I didn't want to cut up my ecu, so I just switched the covers on the pfc front to back, so the big apexi logo faces inwards. Put the Nissan sticker on the outside of the pfc, done.

Inb4 hwp

Good idea, might try that.

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • There's restrictor pills in the stock boost control hoses. That's how they set the amount that was bled off and hence the "high" boost setting. The usual mod in the day was to remove it and send the "high" boost setting up to about 14 psi.
    • Thanks Duncan, that's the best info I've read. Furthermore after learning about the PCM programming side controlling the factory boost solenoid, the purpose of the solenoid is to "bleed" boost when pin 25 is earthed, thus allowing spring pressure in the wastegate actuator to overcome diaphragm boost pressure, thus closing or reducing the position of the wastegate flap creating more boost as the turbo is able to spin faster. It's pretty cool to see a designated Pill to do exactly this, would have liked to have seen it with a tiny filter over the end for those moments in vacuum.  The constant bleed pill has now been removed completely from the system and solenoid boost control has been restored once again.   Case closed 😂
    • The wideband reading is meaningless if it's not running. Why are you using shitty old sidefeeds on any engine, let alone a Neo? What manifold and fuel rail are you using to achieve that? Beyond that, can't help you with AEM stuff as I've never been their ECU/CAS combo.
    • Manual boost controllers (where a little of the boost was bled off) were quite common back in the day, because they were cheap and easy. Generally they had a manual adjustment screw rather than being fixed like yours. Down side is they always bleed boost, not just when you want them to so an electronic boost controller that uses a solenoid will have less lag.
    • Hello , im new here and i have A31 home build  RB25det neo stock eng / turbo  aem ems 2 blue connector  aem 3.5 map aem cas disk aem wideband connected to ecu  355 lph pump 550 nismo yellow injectors side feed aftermarket regulator  and won’t start with base aem tuner basic tune eventually flipped cas 180 degree so it triggers on correct stroke not in exhaust cycle  Now it won’t start Wideband reads 10 and 11 at lowest fuel setting  and will share calibrations soon for aem tuner i think something is wrong in aem tuner    please if you have any information, am very grateful         
×
×
  • Create New...