Jump to content
SAU Community

Recommended Posts

yeh, but 230 kw is eeeeeeeasily enough to skid a gtst and you can spend the remaining coin on trackdays/tires etc

and you can tell hwp to smoke your pole if they EPA you....

pretty much what I do now, dat feel is pretty good

(nek minit fined for fog lights) LOL

Edited by UNR33L

Might get intercooler, run a smaller pulley and e85 down the track, however then I need injectors and fuel pump as well which is all $ and don't think the change from 370 to 450 odd would be that different.. would get me dat 10 though best someone has got with a tune only is 11.3 down the 1/4 mile with good tyres

Or perhaps it's time I save for a house :(

Edited by UNR33L

I'm thinking a shed, I need to be able to store at least 4 cars, preferably more!

I'm limited by my sloping block, designing a 6x9 with extra height to stack cars with a hoist, so should fit 3 with storage

Garage.png

Might get intercooler, run a smaller pulley and e85 down the track, however then I need injectors and fuel pump as well which is all $ and don't think the change from 370 to 450 odd would be that different.. would get me dat 10 though best someone has got with a tune only is 11.3 down the 1/4 mile with good tyres

lol... do you NEED a 10?

370 is stupid power! why risk blowing an engine on a 50k car for extra power that you wont be able to use?

don't you hate it when you've lost the rear end (more than once) on your FWD when out on a track, later find out the previous owner hit a gutter a few years ago and knocked one of the rear wheels out.

get it measured up at Tyre Factory when they were doing other work and find one of the wheels to have 6mm toe-in and the other 1mm. then take it to Centreline Suspension (more than reputable from what I've seen/read) and they measure 1mm toe-in on both rear wheels........

grrr

My Pulsar also had near on 0mm toe in on one side and 6mm toe in on the other side - as you know that is within Nissan spec and the only way to get it better is to bend the rear beam. It almost always has nothing to do with accident damage - that's how they came out of the factory.

I agree it makes the car very unstable particularly with quick changes of direction. Could best describe it as crabwalking. Noticed it at turns 11 & 12 at Sandown more than anywhere else.

Edited by llama_au

lol... do you NEED a 10?

370 is stupid power! why risk blowing an engine on a 50k car for extra power that you wont be able to use?

One day I NEED that 10! :P

221302-vlcsnap_2010_05_24_19h00m39s163.jpg

Edited by UNR33L

ETA for BRZ is now April, oh yeah! Nearly time for nervous butterflies.

That's quick! What happened to 12 month wait? Our 18 month wait for 86 has been upgraded to ~6 months too.

So you can be free?

yes.

Polo TDi...I'm impressed. Averaging 3.4L on the freeway. Could get to Sydney on $60.

yeah that would definitely be my car of choice if i were to go down that path, love the golfs are the GTI much worst?

yeah that would definitely be my car of choice if i were to go down that path, love the golfs are the GTI much worst?

Golf GTI is a great all rounder daily. Great tuning potential too. For the money though, Polo kicks ass. Turbo diesel moves off the line and the 7 speed DSG helps. Would get one if it was a bit better looking, but compared to others in the same market it's probably the best looking.

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • What copper washer do you guys use on the bleeder bolts? The existing one I have I had no idea where to find it in a local store, I did buy some online but that are only 1mm thick whereas my old one is 2mm+ thick and when I put the new washer out and squeeze the top radiator hose I can hear a bit of air but not with the old one. Does this matter? The new one doesn't leak, but the inner diameter is a bit loose whereas the old one threads on the bolt.
    • Howdy all, after being out a few weeks ago on a spirited drive in my GTR I have 2 issues that oddly have appeared at the same time. Whilst accelerating quickly through the gears all of a sudden i’ve lost power at the top of third gear (below redline around 6000rpm) for no obvious reason.    From that point onwards the car has been running rich on idle, won’t really rev under load without a ton of black smoke and the odd backfire, and dying as a pull up to a set of lights unless I keep the revs up around 1500rpm. In addition when shutting down the car that same night (I was 10 minutes from home) I noticed one of the turbos was significantly noisy on wind down when shutting off the engine. After letting the car cool down overnight it starts up fine, although once it gets to temp the revs start to creep up and down, the exhaust is darker than it should be and it also sounds like it’s running rich (fat note) I’ve put a new set of plugs in it - no change, the old plugs all seemed OK with two of them being somewhat richer/fueled up than the other 3 with 1 being borderline. I’ve smoked tested the intake system via the front of the Turbos, found a split vacuum hose going to the factory boost gauge sender, which I have since replaced.  Also found another leak on the gasket coming off the rear turbo outlet, have also replaced this. After fixing both of these leaks - still have the running rich issue. I’ve also tried another pair of AFM’s - no change here After pulling off the front turbo intake pipes, there is obvious shaft play in the front turbo, which now hisses loudly on light revvs although I can’t see why this would make the car run funny even under idle. I’m curious to know why it’s running rich before I potentially replace/rebuild turbos. The car is completely stock <50,000kms  other than an exhaust. Oil and coolant are all clear. I haven’t bothered with coil packs as it looks like they won’t be the issue due to condition of the plugs. Any help appreciated as I cry myself to sleep!
    • No probs at all. I used to love trying to dig up obscure info for those in need where possible going back 20+ years on SAU.  I did have another look and couldn't come up with any closer match. I'm leaning towards those skirts in your first pic are custom fitments, cut down/extended or from another car entirely and modded to fit an R34 sedan. I would've thought someone in Japan had them and taken a photo at some stage over the last 2 decades but there's nothing. Someone out there must know surely.
    • Welcome mate. Any pics? Even with a DE I'd be well happy if I had that as a 1st car. 
×
×
  • Create New...