Jump to content
SAU Community

Recommended Posts

what kind of clear coat?

farkin e-toll karnts. 3 days of tolls cost me $54 with the hire car. only overcharged me $2.80 on one of them. not worth sitting on hold for 20mins to argue. when they say use of toll roads will only cost $3.30 a day = normal toll cost + $3.30 service fee + exceeding 100kms a day in hire vehicle fee (which they never told me about). city link is espensive :(

lesson learnt.

damn thats harsh of them!

i cant stand f**king toll ways..

they say 'oh its so easy to pay just go to breeze.com blah blah' its so f**king stupid.

i added it up and it was 12$ i owed them, like a month later did the same trip in someone elses car, they didnt pay yet it was 4$ for them.

where is my f**king 8$ change?

they make it so confusing for what it needs to be.

been thinking of buying a prepaid etag whatever it is.. went to look.. confused the f**k out of me and gave up

i'm just going to start waiting till they send me bills.

How long b4 new rule, no grey imports on P's....

but if your thinking a few more NA imports?

Pulsar VZ-R N1

This.

Or Autech Pulsar. but even then, both are usually $12k landed, and will only get more pricier and worse condition.

non-N1 VZR is probably a better go, can find a few in Aus but usually from Bankstown and molested and sitting on gumtree for 6 months.

is your skyline turbo miguel? or not running and bought maxima instead? speaking of which, is maxima 3L? dont see too many of those done up... would be a good sleep with some VIP touch.

is your skyline turbo miguel? or not running and bought maxima instead? speaking of which, is maxima 3L? dont see too many of those done up... would be a good sleep with some VIP touch.

It was a n/a, slow as hell wasn't quite sure why I'd bothered to drive it... Must be the tacho needle pointing towards 9,000.

FG xr6, 200 killerasps, plenty of torque and a car from this millennium

inb4 flame

nah but srs they go pretty good for a n/a

Better than your coyote powered taxi?

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • So for the wide band is a Bosch 4.9 correct for the Link G4+ along with a Can bus? Just get the Link gear or is generic ok too? Eg here: LINK LINK DIGITAL WIDEBAND CAN MODULE WITH BOSCH 4.9 SENSOR : KYP Performance House  
    • Bit difficult to follow. Have a look below and see what the standard R32 layout was like. Note there was a restrictor in place immediately before "turbocharged pressure control solenoid" that, if removed, magically got you 1 bar boost.
    • I might be way off the mark here.. there must be a T junction under the manifold. That takes manifold pressure through a check valve prior to the T, one side splits out to this bleed off orifice, the other straight to the wastegate actuators. 
    • Carrying out some engine due diligence before my first drive in a 260RS that has been in storage for 10+ years, and found two lines that are susposed to be plumbed into the boost control solenoid. One of the lines (the wastegate boost supply line) to actuate the gates, had a bolt in one end blocking it. The other line (main boost signal line) from the very rear of the intake manifold (RB26DETT) and runs up to the boost controller had this pill in the end of it as seen in photos. Other than the obvious (T28 Ceramic turbos might well be cooked)  Can anyone shed any light on if there is any validity at all with this mod, bleeding a constant fixed rate of manifold boost pressure off through this 3mm hole?  Is it deliberate?  Was this a 90s Jap mod done to RB26's? Or has someone just fitted this without any idea of what happens to ceramic T28s if they are not gate controlled?    
×
×
  • Create New...