Jump to content
SAU Community

Recommended Posts

Wonder what these would look like on my falcon:

http://www.importmonster.com.au/shop/product_info.php?cPath=40_45&products_id=1846

also why the f**k are they $2300 lol

Edited by UNR33L

Wonder what these would look like on my falcon:

http://www.importmonster.com.au/shop/product_info.php?cPath=40_45&products_id=1846

also why the f**k are they $2300 lol

See them and lowball them.

Wonder what these would look like on my falcon:

http://www.importmonster.com.au/shop/product_info.php?cPath=40_45&products_id=1846

also why the f**k are they $2300 lol

Cause fanbois think most people can tell if you've spent $1000 or $5000 on wheels, then proceed to gutter rash them

Fake woodgrain just reminds me of those early Ssangyongg 4WDs with the 'mercedes' engines and fake woodgrain *vomit*

dude... you drive a pulsar, you don't like meisters, you think stickerbomb is cooler than woodgrain...

stop, please stop, just STAHP!

  • Like 1

if those wheels were 1 grand cheaper I'd buy them, unfortunately I cant see them accepting my offer :P

Just go them and hand out mouth hugs while lowball them.

I'm sure they'd be thrilled.

Wasteland has now turned from 90% food posts to 90% FIFO posts the past week haha

Best thing about it, you don't know what topic is going to be for next week.

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • So for the wide band is a Bosch 4.9 correct for the Link G4+ along with a Can bus? Just get the Link gear or is generic ok too? Eg here: LINK LINK DIGITAL WIDEBAND CAN MODULE WITH BOSCH 4.9 SENSOR : KYP Performance House  
    • Bit difficult to follow. Have a look below and see what the standard R32 layout was like. Note there was a restrictor in place immediately before "turbocharged pressure control solenoid" that, if removed, magically got you 1 bar boost.
    • I might be way off the mark here.. there must be a T junction under the manifold. That takes manifold pressure through a check valve prior to the T, one side splits out to this bleed off orifice, the other straight to the wastegate actuators. 
    • Carrying out some engine due diligence before my first drive in a 260RS that has been in storage for 10+ years, and found two lines that are susposed to be plumbed into the boost control solenoid. One of the lines (the wastegate boost supply line) to actuate the gates, had a bolt in one end blocking it. The other line (main boost signal line) from the very rear of the intake manifold (RB26DETT) and runs up to the boost controller had this pill in the end of it as seen in photos. Other than the obvious (T28 Ceramic turbos might well be cooked)  Can anyone shed any light on if there is any validity at all with this mod, bleeding a constant fixed rate of manifold boost pressure off through this 3mm hole?  Is it deliberate?  Was this a 90s Jap mod done to RB26's? Or has someone just fitted this without any idea of what happens to ceramic T28s if they are not gate controlled?    
×
×
  • Create New...