Jump to content
SAU Community

Recommended Posts

House parties are the way to go, or in the loungeroom at home with a scotch and an ironic 45 on the decks you spun 10 years ago back when you were mainstream and uncool.

this any time.

think will drive up the country and have a few beers with my mates this year, shed party...

East west link would be alright, but using it to drive to my job where my hourly rate has just been cut in half, along with everything else they want to strip us of, not so much.

I didn't hear any of this from liberal ... Was this Union scaremongering?

I didn't hear any of this from liberal ... Was this Union scaremongering?

This was my point.

Labor scaremongering would have you believe the Liberals will decimate the state like Skynet in The Terminator, where "big business" will destroy everyone but themselves

Liberal scaremongering would have you believe the Labor will decimate the state like the Tripods in War of the Worlds where "the unions" will destroy everyone but themselves

It's the same shit, just a different title.

I cant believe people actually fall for it.

anyone that voted for labor, just because they will scrap that tunnel is going to very disappoint.

as if a political party backed and controlled by unions is going to cancel a major construction project.

heres to the east west tunnel opening maybe 6 months later than it would have under the libs.

anyone that voted for labor, just because they will scrap that tunnel is going to very disappoint.

I suspect those people largely voted for the Greens... who continue to trumpet their own relevance despite holding probably 1 of the 88 seats in the lower house

I suspect those people largely voted for the Greens... who continue to trumpet their own relevance despite holding probably 1 of the 88 seats in the lower house

dont get me started on those idiots.

f**k the people save the enviroment.

as liberals would not have had a delay..

oh wait I hear what about the nagambie bypass, delayed over a year...(sorry this was the most recent I could think of built in past 4 years)

built under the liberals.

burnley tunnel.

massive issues had to be closed and repaird

built under labour.

seriously they as bad as each other

  • Like 1
Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • So for the wide band is a Bosch 4.9 correct for the Link G4+ along with a Can bus? Just get the Link gear or is generic ok too? Eg here: LINK LINK DIGITAL WIDEBAND CAN MODULE WITH BOSCH 4.9 SENSOR : KYP Performance House  
    • Bit difficult to follow. Have a look below and see what the standard R32 layout was like. Note there was a restrictor in place immediately before "turbocharged pressure control solenoid" that, if removed, magically got you 1 bar boost.
    • I might be way off the mark here.. there must be a T junction under the manifold. That takes manifold pressure through a check valve prior to the T, one side splits out to this bleed off orifice, the other straight to the wastegate actuators. 
    • Carrying out some engine due diligence before my first drive in a 260RS that has been in storage for 10+ years, and found two lines that are susposed to be plumbed into the boost control solenoid. One of the lines (the wastegate boost supply line) to actuate the gates, had a bolt in one end blocking it. The other line (main boost signal line) from the very rear of the intake manifold (RB26DETT) and runs up to the boost controller had this pill in the end of it as seen in photos. Other than the obvious (T28 Ceramic turbos might well be cooked)  Can anyone shed any light on if there is any validity at all with this mod, bleeding a constant fixed rate of manifold boost pressure off through this 3mm hole?  Is it deliberate?  Was this a 90s Jap mod done to RB26's? Or has someone just fitted this without any idea of what happens to ceramic T28s if they are not gate controlled?    
×
×
  • Create New...