Jump to content
SAU Community

Recommended Posts

from what i saw when I went to interviews my bike was better than em all lol

mines pretty light too.. wouldnt be hard lift front wheel with 2 people on the back of a van, up it goes.

if parked on street / footpath I'd almost make a bet that it'd be gone :P already had 2 stolen off me

Edited by UNR33L

Got schooled by Winterbottom on a Phillip Island racing sim

1:54 vs 1:41

Surprised how well he did; those sims can be counter intuitive to real drivers. Obviously pays to know the track well

Got schooled by Winterbottom on a Phillip Island racing sim

1:54 vs 1:41

Surprised how well he did; those sims can be counter intuitive to real drivers. Obviously pays to know the track well

I would have expected this

  • Like 1

Fictional is all the more reason to claim it; no real world result to back it up

Lucky for Frosty it wasn't a real track or my GTS-T with KU31s could have rekt his contract renewal chances

  • Like 1

I wonder how you would go driving a real car (with a dog box) like a daytona car?

I mean, I know you would break it but how long would you last before removing gears from your legs?

Need a cassette type transmission like a bike

That would be a big advantage to building one of those motorbike engined smart cars, instant clutchless sequential shifting

I wonder how you would go driving a real car (with a dog box) like a daytona car?

I mean, I know you would break it but how long would you last before removing gears from your legs?

haha no need for brakes, just downshift & drift. dayyytonaaa
  • Like 2

nope, unless its been replaced by some dodge bolt from bunnings that is more likely imperial not 11mm

I think there's an 11mm bolt holding the crossover pipe to bracket on RB25...could be wrong, it is the internet afterall

Edited by ARTZ
Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • So for the wide band is a Bosch 4.9 correct for the Link G4+ along with a Can bus? Just get the Link gear or is generic ok too? Eg here: LINK LINK DIGITAL WIDEBAND CAN MODULE WITH BOSCH 4.9 SENSOR : KYP Performance House  
    • Bit difficult to follow. Have a look below and see what the standard R32 layout was like. Note there was a restrictor in place immediately before "turbocharged pressure control solenoid" that, if removed, magically got you 1 bar boost.
    • I might be way off the mark here.. there must be a T junction under the manifold. That takes manifold pressure through a check valve prior to the T, one side splits out to this bleed off orifice, the other straight to the wastegate actuators. 
    • Carrying out some engine due diligence before my first drive in a 260RS that has been in storage for 10+ years, and found two lines that are susposed to be plumbed into the boost control solenoid. One of the lines (the wastegate boost supply line) to actuate the gates, had a bolt in one end blocking it. The other line (main boost signal line) from the very rear of the intake manifold (RB26DETT) and runs up to the boost controller had this pill in the end of it as seen in photos. Other than the obvious (T28 Ceramic turbos might well be cooked)  Can anyone shed any light on if there is any validity at all with this mod, bleeding a constant fixed rate of manifold boost pressure off through this 3mm hole?  Is it deliberate?  Was this a 90s Jap mod done to RB26's? Or has someone just fitted this without any idea of what happens to ceramic T28s if they are not gate controlled?    
×
×
  • Create New...