Jump to content
SAU Community

Recommended Posts

  • Replies 355
  • Created
  • Last Reply

Top Posters In This Topic

Top Posters In This Topic

Posted Images

I was told each dealer in Adelaide area has been allocated one car each and will keep them as demo's for 12 months. I asked about putting my name down for a EX demo but no luck. Ill be driving the GTS auto from one dealer then going to another dealer with the car and swapping to drive the manual.

I think he was watching to see if the pointy end of your key was getting close to the paintwork !

Yeah, he was an older professional looking kind of person... looking nervously at his iPhone.

I really was hoping he'd get out of his car so I could ask him questions about the car (and maybe look inside)

And JZP, you're a younger looking non-professional person circumnavigating his car in baggy pants that could've concealed a weapon - lol?

Hah!, I'm over 40...and dress pretty conservatively I think it was cos it was so dark and I sorta followed him a bit.... hmmm, don't blame the guy now!!

meh.. 200hp.. couldnt be bothered driving one,..

My Datsun 1600 had maybe 90hp. It's still to this day the most fun, and fastest car aside from in a straight line, I've ever driven.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • The final part arrived today to un-clampify and simplify the intake Who would have though a 1/2" hose stainless bulkhead fitting designed for below waterline bilge pumps would be what I needed Test fit on a 3" offcut I had laying around to see if it would work, and it worked a treat All going well the intake will be on its "final version" tomorrow 
    • Good luck on the weekend mate
    • Must have been an absolute nightmare to drive when the power steer was out, the rack ratio/wheel size/caster is all set up for power assistance
    • Welcome to SAU, what are you looking at buying?
    • I checked the injectors again (1 and 2, since they’re easiest to access) to make sure they weren’t clogged. Even though the entire fuel system had been cleaned, I wanted to be certain. Everything looked clean, so I reinstalled and connected everything. When I started the car to confirm everything was okay, it immediately revved up high, so I shut it off straight away. I checked to see if I’d missed a vacuum hose or something, but everything was connected. On the second attempt, the car ran without the high idle, but I noticed a distinct “compressed air” sound coming from the engine bay. Tracing the sound, I pushed injector #6 forward slightly and the noise stopped — it turned out it wasn’t seated properly, despite the fuel rail being bolted down. While holding it in place, the car idled steadily without stalling and ran for over 5 minutes. At this point, I pulled all six injectors out just in case I hadn’t seated them correctly or dirt had gotten onto the O-rings. Unfortunately, I discovered that I had damaged 3 out of 6 injectors (the OEM 270cc ones) during installation. So yes, this was my fault. Since only the pintle caps were damaged, I’ve ordered a Fuel Injector Service Kit from NZEFI to refurbish them. In the meantime, I reinstalled my new injectors – the car now idles fine for over 15 minutes without stalling. I have not attempted to drive it so far. It’s not perfect yet, as it hesitates when the throttle is pressed, but it’s a big improvement. Unplugging the IACV with the new injectors idles at around 800rpm, even with the IACV screw tightened fully. But this is probably due to tune.
×
×
  • Create New...