Jump to content
SAU Community

Recommended Posts

Hey Paul, if by oil analysis you mean take a test tube to someone for scientific analysis then probably not. I wouldn't know the first thing about that

If you mean visuals of water contamination + photos, of course! :P

Plus, I'm not sure how relevant my analysis would be to you, I only own a lowly gtst, not a full house 2.8 GTR! :P

Hey Paul, if by oil analysis you mean take a test tube to someone for scientific analysis then probably not. I wouldn't know the first thing about that

If you mean visuals of water contamination + photos, of course! :P

Plus, I'm not sure how relevant my analysis would be to you, I only own a lowly gtst, not a full house 2.8 GTR! :P

Ethanol and fuel is same same. It gives no fark for car type or capacity haha.

I made the change to E85 a few months back. I have been using the Penrite sin range for years.

After going to E85 I put some fresh Penrite sin 20/50 in and dropped it today after maybe 3000km.

Oil looked fine. My car is making 270rwkw and has nearly 200k on the clock. It gets looked after but does get a boot full every now and then. To be honest I can't fault the Penrite stuff. I have tried RP and the Motul oils and my car just doesn't seen to like it as much as the Penrite. My 2cents anyway.

I made the change to E85 a few months back. I have been using the Penrite sin range for years.

After going to E85 I put some fresh Penrite sin 20/50 in and dropped it today after maybe 3000km.

Oil looked fine. My car is making 270rwkw and has nearly 200k on the clock. It gets looked after but does get a boot full every now and then. To be honest I can't fault the Penrite stuff. I have tried RP and the Motul oils and my car just doesn't seen to like it as much as the Penrite. My 2cents anyway.

i run pentrite with E85 as does everyone i know when they are running E85. Seems to be the oil of choice and doesnt seem to break down as quick as some of the others under these conditions..

if you do some searching on the net you will find that ALOT of people say the same thing so thats a winner IMO

Ok so dropped out the Edge 10w60 over the weekend. Here's my super scientific analysis: It was fine. It looked and smelled like any other oil I've changed before.

I copied the technique I read in Performance Imports magazine by stirring up the oil to see if there was water separated from the oil that would show up as white stuff where you stir it, but I saw nothing.

Note: this is a 270kw r33 gtst that is driven every day, South East QLD weather, lots of extra urban trips when cold < 5 mins driving.

Pics:

IMG_20130323_173240.jpg

IMG_20130323_173319.jpg

IMG_20130323_173352.jpg

I made the change to E85 a few months back. I have been using the Penrite sin range for years.

After going to E85 I put some fresh Penrite sin 20/50 in and dropped it today after maybe 3000km.

Oil looked fine. My car is making 270rwkw and has nearly 200k on the clock. It gets looked after but does get a boot full every now and then. To be honest I can't fault the Penrite stuff. I have tried RP and the Motul oils and my car just doesn't seen to like it as much as the Penrite. My 2cents anyway.

20w50 is too thick for dailying an SR20 with just a squirt here and there...

honestly i'd look at something a little thinner, especially on the cold viscosity... penrite have a 10w50 syn dont they?

i run pentrite with E85 as does everyone i know when they are running E85. Seems to be the oil of choice and doesnt seem to break down as quick as some of the others under these conditions..

if you do some searching on the net you will find that ALOT of people say the same thing so thats a winner IMO

Edge 10w60 is probably the most one common used in vic

Well it looked pretty good to me? How can you tell if it's broken down?

I would have thought with the type of conditions I operate my car in, it would have gone bad if it was ever going to.

I drive plenty of short trips with a cold engine, where fuel can apparently wash past the rings and into the oil etc and break it down. I do no highway kms, all around town driving. Stop start.

Well it looked pretty good to me? How can you tell if it's broken down?

I would have thought with the type of conditions I operate my car in, it would have gone bad if it was ever going to.

I drive plenty of short trips with a cold engine, where fuel can apparently wash past the rings and into the oil etc and break it down. I do no highway kms, all around town driving. Stop start.

heaps of people use it however I havent ith e85, only 98... personally I prefer motul 6100 15w50 with e85 so I can't really comment personally...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • Hey Dave, welcome aboard! Good to see another soon-to-be Stagea owner here. The wagons are awesome — plenty of space, still got that Skyline DNA, and loads of potential if you’re into mods. Definitely post up pics when you get it, everyone here loves seeing new builds. What model/year are you looking at?
    • See if you can thermal epoxy a heatsink or two onto it?
    • The other problem was one of those "oh shit we are going to die moments". Basically the high spec Q50s have a full electric steering rack, and the povo ones had a regular hydraulic rack with an electric pump.  So couple of laps into session 5 as I came into turn 2 (big run off now, happily), the dash turned into a christmas tree and the steering became super heavy and I went well off. I assumed it was a tyre failure so limped to the pits, but everything was OK. But....the master warning light was still on so I checked the DTCs and saw – C13E6 “Heat Protection”. Yes, that bloody steering rack computer sitting where the oil cooler should be has its own sensors and error logic, and decided I was using the steering wheel too much. I really appreciated the helpful information in the manual (my bold) POSSIBLE CAUSE • Continuing the overloading steering (Sports driving in the circuit etc,) “DATA MONITOR” >> “C/M TEMPERATURE”. The rise of steering force motor internal temperature caused the protection function to operate. This is not a system malfunction. INSPECTION END So, basically the electric motor in the steering rack got to 150c, and it decided to shut down without warning for my safety. Didn't feel safe. Short term I'll see if I can duct some air to that motor (the engine bay is sealed pretty tight). Long term, depending on how often this happens, I'll look into swapping the povo spec electric/hydraulic rack in. While the rack should be fine the power supply to the pump will be a pain and might be best to deal with it when I add a PDM.
    • And finally, 2 problems I really need to sort.  Firstly as Matt said the auto trans is not happy as it gets hot - I couldn't log the temps but the gauge showed 90o. On the first day I took it out back in Feb, because the coolant was getting hot I never got to any auto trans issues; but on this day by late session 3 and then really clearly in 4 and 5 as it got hotter it just would not shift up. You can hear the issue really clearly at 12:55 and 16:20 on the vid. So the good news is, literally this week Ecutek finally released tuning for the jatco 7 speed. I'll have a chat to Racebox and see what they can do electrically to keep it cooler and to get the gears, if anything. That will likely take some R&D and can only really happen on track as it never gets even warm with road use. I've also picked up some eye wateringly expensive Redline D6 ATF to try, it had the highest viscosity I could find at 100o so we will see if that helps (just waiting for some oil pan gaskets so I can change it properly). If neither of those work I need to remove the coolant/trans interwarmer and the radiator cooler and go to an external cooler....somewhere.....(goodbye washer reservoir?), and if that fails give up on this mad idea and wait for Nissan to release the manual 400R
    • So, what else.... Power. I don't know what it is making because I haven't done a post tune dyno run yet; I will when I get a chance. It was 240rwkw dead stock. Conclusion from the day....it does not need a single kw more until I sort some other stuff. It comes on so hard that I could hear the twin N1 turbos on the R32 crying, and I just can't use what it has around a tight track with the current setup. Brakes. They are perfect. Hit them hard all day and they never felt like having an issue; you can see in the video we were making ground on much lighter cars on better tyres under brakes. They are standard (red sport) calipers, standard size discs in DBA5000 2 piece, Winmax pads and Motul RBF600 fluid, all from Matty at Racebrakes Sydney. Keeping in mind the car is more powerful than my R32 and weighs 1780, he clearly knows his shit. Suspension. This is one of the first areas I need to change. It has electronically controlled dampers from factory, but everything is just way too soft for track work even on the hardest setting (it is nice when hustling on country roads though). In particular it rolls into oversteer mid corner and pitches too much under hard braking so it becomes unstable eg in the turn 1 kink I need to brake early, turn through the kink then brake again so I don't pirouette like an AE86. I need to get some decent shocks with matched springs and sway bars ASAP, even if it is just a v1 setup until I work out a proper race/rally setup later. Tyres. I am running Yoko A052 in 235/45/18 all round, because that was what I could get in approximately the right height on wheels I had in the shed (Rays/Nismo 18x8 off the old Leaf actually!). As track tyres they are pretty poor; I note GTSBoy recently posted a porker comparo video including them where they were about the same as AD09.....that is nothing like a top line track tyre. I'll start getting that sorted but realistically I should get proper sized wheels first (likely 9.5 +38 front and 11 +55 at the rear, so a custom order, and I can't rotate them like the R32), then work out what the best tyre option is. BTW on that, Targa Tas had gone to road tyres instead of semi slicks now so that is a whole other world of choices to sort. Diff. This is the other thing that urgently needs to be addressed. It left massive 1s out of the fish hook all day, even when I was trying not too (you can also hear it reving on the video, and see the RPM rising too fast compared to speed in the data). It has an open diff that Infiniti optimistically called a B-LSD for "Brake Limited Slip Diff". It does good straight line standing start 11s but it is woeful on the track. Nismo seem to make a 2 way for it.
×
×
  • Create New...