Jump to content
SAU Community

Recommended Posts

Sorry to hear it....

Argo rods too, bummer. I'm running Argo's in mine so hopefully I don't meet the same fate!

I've seen crank oil galleries blocked from a ball of sealant that has fallen off the sump to block join over time. It's very easy to overdo it went applying it.

Other than that the fact that it happened on cruise is a worry. Hopefully there is a clear cut reason as it sucks arse when a motor dies and you don't know why!

Im going to pull the oil pump apart today, but i was still getting normal pressures, so I doubt its the pump. Only about 2,000 miles on her since the rebuild. Havent even turned up the boost :( I was fun as hell at 12psi though.

Edited by ZT-R
I wouldnt think it would get any better the a R.I.P.S. build. Everything is out now, so its no longer a rips :( Anyone can assemble them, but not to his specs and attention to detail, Although I think i will debur the inside of this block, its ugly and quiet scary looking.

The number one piston is out of round by 8 thousandths. and the crank is egged. So for sure needs a new crank and rod.

Anyway, more disassembly pics.

9386364494_f24d348749_b.jpg

9386367866_e26b6d7d56_b.jpg

9386370446_26897ba032_b.jpg


9383595285_5f1d7c5282_b.jpg

9386374994_b86b841403_b.jpg


9383599745_1fd673ec1d_b.jpg

9386379730_98b7b45846_b.jpg

9386381850_049c60b9f1_b.jpg

9386383942_f02602b673_b.jpg


9383610619_a70243bb6a_b.jpg

IMO the mains dont look great, but its hard to tell from pics, the fact all the big ends are trashed points to oil issues, could there be contaminants in the cooler etc? have you asked rips? Theres not somthing funny like oil thermostat or oil filter block incorrectly plumbed? how do the cams look?

Edited by Adriano

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • What copper washer do you guys use on the bleeder bolts? The existing one I have I had no idea where to find it in a local store, I did buy some online but that are only 1mm thick whereas my old one is 2mm+ thick and when I put the new washer out and squeeze the top radiator hose I can hear a bit of air but not with the old one. Does this matter? The new one doesn't leak, but the inner diameter is a bit loose whereas the old one threads on the bolt.
    • Howdy all, after being out a few weeks ago on a spirited drive in my GTR I have 2 issues that oddly have appeared at the same time. Whilst accelerating quickly through the gears all of a sudden i’ve lost power at the top of third gear (below redline around 6000rpm) for no obvious reason.    From that point onwards the car has been running rich on idle, won’t really rev under load without a ton of black smoke and the odd backfire, and dying as a pull up to a set of lights unless I keep the revs up around 1500rpm. In addition when shutting down the car that same night (I was 10 minutes from home) I noticed one of the turbos was significantly noisy on wind down when shutting off the engine. After letting the car cool down overnight it starts up fine, although once it gets to temp the revs start to creep up and down, the exhaust is darker than it should be and it also sounds like it’s running rich (fat note) I’ve put a new set of plugs in it - no change, the old plugs all seemed OK with two of them being somewhat richer/fueled up than the other 3 with 1 being borderline. I’ve smoked tested the intake system via the front of the Turbos, found a split vacuum hose going to the factory boost gauge sender, which I have since replaced.  Also found another leak on the gasket coming off the rear turbo outlet, have also replaced this. After fixing both of these leaks - still have the running rich issue. I’ve also tried another pair of AFM’s - no change here After pulling off the front turbo intake pipes, there is obvious shaft play in the front turbo, which now hisses loudly on light revvs although I can’t see why this would make the car run funny even under idle. I’m curious to know why it’s running rich before I potentially replace/rebuild turbos. The car is completely stock <50,000kms  other than an exhaust. Oil and coolant are all clear. I haven’t bothered with coil packs as it looks like they won’t be the issue due to condition of the plugs. Any help appreciated as I cry myself to sleep!
    • No probs at all. I used to love trying to dig up obscure info for those in need where possible going back 20+ years on SAU.  I did have another look and couldn't come up with any closer match. I'm leaning towards those skirts in your first pic are custom fitments, cut down/extended or from another car entirely and modded to fit an R34 sedan. I would've thought someone in Japan had them and taken a photo at some stage over the last 2 decades but there's nothing. Someone out there must know surely.
    • Welcome mate. Any pics? Even with a DE I'd be well happy if I had that as a 1st car. 
×
×
  • Create New...