Jump to content
SAU Community

Recommended Posts

I'm looking into to changing over to a Lithium battery; it will be a pain to move the battery from stock location so the next best thing is to reduce weight on the front right corner.

Is anyone using a Lithium battery? Which brand/model, any problems or observations?

Link to comment
https://www.sau.com.au/forums/topic/461626-anyone-running-a-lithium-battery/
Share on other sites

Ever seen supercapacitor car batteries? Extremely high "CCA" due to low ESR (equivalent series resistance) in the capacitors. Also very light, and has no liquid to spill, virtually unaffected by temperature (within specs of the capacitors) and virtually unlimited charge/discharge cycles (you'd never reach them in the lifetime of a car). Only downside is much lower amp/hour figure compared to chemical batteries.

thanks for the responses. I'll check out Braille too, I had looked at SSB. Yes they are not cheap, about 1/3 the weight and 3x the price of AGM batteries

interesting question about A/hr ratings, I don't know what I actually need given it is race use. I expect the alternator to do all the work, I never lean on the battery except for starting. I currently use a 16ahr battery which claims 520PHCA / 170CCA at the moment and it is fine (Odyssey PC680). Might end up back there depending on what I learn :)

I ran a Lithium for a few years, I just converted back to a sealed battery as I needed one ASAP and was being povo.

They hate the cold. On cold Targa mornings they appear to go dead flat, but come back to life once they have some load on them. I ended up going to the car of a cold morning and turning the lights on for a few mins so I could start the car.

You will want to keep the car on a trickle charger too, as once they go below a voltage level they never come back to life.

I took the life out of mine when my alternator failed and I drained the battery a few times in a day.

I ran the 550ca from here http://www.tuningworx.com/#!wwwlithiumaxcomau/sitepage_12

I've been running a ballistics evo2 16 cell for the last 2 and a bit years. Claimed 500cca and around 1.3kg.

As Ben mentioned they hate the cold. Won't stay the car below 2 deg without the help of a jumper pack.

Am going to replace this before tt next year but the crap aus $ makes them v expensive. Have found a local supplier for antigravity batteries who make one in a similar spec. May try this.

Have also tosser up the idea of running a second one as backup with a switch between the two, just in case one failed mid event.

BTW interesting point about the cold, it was kind of left of every manufacturers' websites.

The LEAF obviously uses Lithium batteries for the main pack, they come with what I assume was coolant...but maybe it is actually warmant for cold climates. They certainly work fine in places like Norway where it is 2nd top selling car behind tesla s (which also runs lithium)

They do heat up quite quickly when current is drawn. Problem is in this size/capacity by the time they are heated up they are pretty much flat. On a big scale like the leaf and Tesla it probably isn't an issue.

I have no experience with lithium batteries in a car but I do use a dual battery system in my 4WD that has a AGM battery as the second battery and the standard lead battery as the engine one. I was told by a battery bloke that each type of battery requires a different charge rate and that factory alternators are not set up to directly charge lithium battery's so you should use a smart DC/DC charger between the alternator and battery to help extend the life of the battery. I am not sure if any of this is true but I purchased a ctek DC/DC charger and it seams to work well.

I have an SSB in my racecar - sunny old Perth isnt that cold usually but have cranked it over with sucess on some low single digit cold mornings

All other times never had a problem, obviously coupled with isolator etc but sitting for months at time and cranks over first time no probs been going 18 mths strong and not charged it once since initial full charge

Edited by bcozican

thanks mate, the SSB were what I was looking at too. I decided to stick with the current setup for reliability.

and good point about different batteries Ryan, that is my understanding too...its why the expensive chargers have different modes for different batteries....I am not sure of the detail but there is something about both batteries being limited to the voltage of the lower battery when you charge, which is not sufficient for an AGM battery. I guess a single battery system with a lithium battery will be OK as long as the alternator's regulator charges high enough for what the particular battery wants.

Just run two fat cables to the rear. Put a battery box in. Leave everything else in normal place.

Bug heavy item is now in the bar of the car and you haven't stuffed with the other looms.

Actually one epic cable to the rear would suffice.

  • 5 months later...

I know this is an old thread but i actually purchased a lithium battery for my R34 and i will never own another one. I was luckily only on the dyno doing a couple of test runs and we had an alternator failure that inturn sent a 16v spike through the system and sent the lithium battery into meltdown... now sitting in a car that is getting sprayed in lithium wasnt fun at all!!

458ddeb1d67a9f6a77d9765338c9d46e.jpg

It has basically spiked one of the cells and it in turn ruptured now if i was at the track i think it could have been a whole lot worse. We ended up junping out, killing it and cutting the battery loose and turfing it out the workshop. So for me i have just gone for a small AGM optima yes its abit heavier but i have no stress that anything is going to go wrong..

Just my 2c

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Well, the trouble with that ^^ is: The configuration shown is absolutely a 1-way, not a 1.5-way. There is no way that a 1.5-way can be said to offer LSD action only on acceleration. If Nismo cannot get that right, then it is impossible to believe their documentation. That ^ is not a 1.5 way setup. That is a 1-way.   And so now I have allowed all doubts to flourish and have gone back to look at the MotoIQ video. I originally made the mistake of believing him when he said "this is a 1.5-way" at the ~6:10 mark. Because what he did was take the gear assembly out of the 2-way opening and just rotate it one place to the left to drop it into the 1-way opening. When he dropped it in there, the cam was "backwards" compared to the correct orientation shown in all other photos of that config. The flat shold have been facing the 1° ramp side of the opening, not the 55° ramp side. And I thought, "gee that's cute", but I was concerned at the time, when he put the other ring back on, that the gap between the rings looked like it was wider then in the 2-way config. And then I said a lot of things in my long post on Tuesday that could only make sense if the guy from MotoIQ was correct about what he'd done. BUT... I have now done my homework. I grabbed a frame of the video with the 2-way config, and then grabbed another with the "1.5-way" config, snipped out the cam and opening of that frame and just pasted it direct on top of the 2-way config. I scaled it so that the triangular opening was almost exactly the same height in both. AND.... the gap between the plates is wider with the cam installed in the triangualr opening backwards. That is.... it cannot go together that way. There would be massive force on the plates all the time, if you could even reassemble it.  So, My statement on the matter? The Nismo diff is actually only a 2-way and 1-way. There is no 1.5-way option in it, regardless of what they say. Here's a photo of a real 1.5-way ramp opening from Cusco (along with the 1 way option). And the full set of 1 through 2 way options from their racing diff, which is not same-same as what we'd typically be using, but...the cams work the same. A little blurry, but it comes from this Cusco doc, which is quite helpful. AND.... Cusco do in fact do what I suggested would be sensible, which is to have rings that do 1 and 1.5, and 1.5 and 2. Separately.  
    • Welcome Adam. Car looks great!
    • "With a 1.5-WAY, the LSD is effective only during acceleration."
    • Well it wasn't as easy as I thought.... and it also wasn't in my original manual which I did end up finding. They discuss the process in the Nismo catalogue though and it requires slight machining. Page 145.  NISMO PARTS CATALOGUE 2020
    • I'm an idiot, my intercooler is rated for 1000hp. I had clicked on the wrong product. Knowing the delta P would be nice, but I'm doubtful I'll do it. Now as for an EMAP, that would be great and I'll get around to it eventually but from my findings in my last post, I'm considering a turbo swap now. 
×
×
  • Create New...