Jump to content
SAU Community

Recommended Posts

On September 24 a driver in a silver or grey FD Honda Civic (or some other Honda sedan) decided it'd be a good idea to speed through a red light.

I couldn't stop in time and we collided :( . The guy in the Civic then left the scene :mad:

Thought I'd share the damage while I sit here waiting for the bad news that my baby is written off.

Out of interest, what do you guys think? Definitely a write off?

 

Also, just in case, if anyone has seen a smashed up civic in the Cabramatta area in the last week - any info would be appreciated.

1.jpg

2.jpg

3.jpg

4.jpg

5.jpg

Edited by Wight
Link to comment
https://www.sau.com.au/forums/topic/467070-it-might-be-bye-bye-to-my-34/
Share on other sites

Damn that's rough mate, write off for sure!! 

I had Troy from iron chef try to source me another clean bayside GTT for around 6 months with very little luck before I called it quits, hopefully you can find another one!

sorry to hear
Exact same thing happened to my mate's super clean r33 gtst too in 2005 when the r33s were going for around 20k still, except it was hit by a kingswood and the kingswood fled the scene.
Police wasn't much help back then.
It's a shit thing to go through and I definitely know how you feel

I'm considering buying the car back, getting a front cut (without the engine) and repairing it that way. Hopefully engineless front cuts aren't too expensive.

That is, of course,  it isn't a statutory write off - which I doubt.

 

Unfortunately the police haven't done much now either. Because of where it happened there is just no footage. They did at least check the servo nearby,  which was nice.

Essentially you need to ask the insurance company for the salvage value of the car. This is what you need to pay them.to keep your wreck. If you choose to keep it then they pay you out the insured value less your excess less salvage, then you.need to goto the rms to get a form to fill out to apply for the right to repair it. Then have the repairs sign off saying it's done properly. Then get a blueslip. Then take the rms permission, the repairers sign off and all recipes to the rms to get it registered again.
However there is still a small loop hole. The wovr will ignore most 15 year old or older cars and not record them as write offs. So that may or maynot happen

  • Like 1

I was aware about the salvage value. But wasn't aware of the specifics regarding the RMS. Thanks heaps for the info - I'll look further into it.

I love this car, so will definitely be trying everything to get it back on the road, unless the cost is exorbitant.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Update: O2 sensor in my downpipe turned out to be faulty when I plugged in to the Haltech software. Was getting a "open circuit" warning. Tons of carbon buildup on it, probably from when I was running rich for a while before getting it corrected. Replaced with new unit and test drove again. The shuffle still happens, albeit far less now. I am not able to replicate it as reliably and it no longer happens at the same RPM levels as before. The only time I was able to hear it was in 5th going uphill and another time in 5th where there was no noticeable incline but applying more throttle first sped it up and then cleared it. Then once in 4th when I slightly lifted the throttle going over a bump but cleared right after. My understanding is that with the O2 sensor out, the ECU relies entirely on the MAP tune and isn't able to make its small adjustments based on the sensors reading. All in all, a big improvement, though not the silver bullet. Will try validating the actuators are set up correctly, and potentially setting up shop time to tune the boost controller on closed loop rather than the open loop it is set to now. Think if it's set up on closed loop to take the O2 reading, that should deal with these last bits. Will try to update again as I go. 
    • More so GReddy oil relocation kits, sandwich plates, etc. all use 10AN fittings. And same, I've only used 10AN and my car sees track work (circuit, doing laps, not 10 sec squirt business).
    • street use or race track, what hose size and why? what factors change with the hose size options ?   see most comon is an10. when you see most oem external coolers are closer to an12? does high volume oil pump like nitto need an12 or 10 be just fine
    • The rod I was moving left and right you can see looking from the passenger side floor up into the center console.  IMG_8095.mov
×
×
  • Create New...