Jump to content
SAU Community

Recommended Posts

Hey guys so here are the technical specs

 

Rb25det series 2 neo manual

Fmic

Blitz pod

3 inch turbo back

Splitfire coil packs

 

Okay so the car runs fine for 10 mins and will come on boost fine and rev out though I only took it 5k as it was cold. This sputtering as if the traction control has come on the sound is like a limiter the same sound it makes when traction control comes on. Btw I leave traction co troll off because when it would turn on before it would cause knock and then the check engine light would come on. This problem has only occured after installing the splitfires. It happens no matter where in the rev range its just as soon as I got past vacuum and come on to positive pressure bit when it's cold it runs properly. The cars temperature gauge never comes up to halfway either I am replacing the thermostat not sure if this will fix it or if this is a coolant temp sensor.

 

If anyone has I had a similar cutting of power and popcorn sounding noise, point me in the right direction otherwise off to the shop.

  • 2 weeks later...

So I have replaced spark plugs, have splitfires and replaced coil pack harness but whenever I put a bit of load on the car it just breaks up, I'm thinking now to do o2 sensor as I get a misfire on idle, I replaced thermostat as it never comes up to temp but it must be the coolant temp sensor. Basically whenever I give it more than a qtr throttle it sounds like the fuel cut you get when traction control would kick in.

There's no boost leak sadly, I had a boost leak and fixed it car was running fine until the splitfires went in it hold boost fine as I said will go to red line, I'm really leaning towards a dud o2 sensor as it deals with load and I have terrible fuel economy

It will drive fine when the car is completely cold and drives perfect for 10 mins im thinking between the o2 sensor and coolant tempo sensor throwing out the afr I also cleaned maf 3 weeks ago when I found the boost leak

Hey guys I think I've found the problem ive got extreme regarding from the cas, or pre ignition and why my fuel economy is so bad as well I found that a dodgy coolant temp sensor can cause this on skyline owners forum

5 hours ago, zirbmail said:

Hey guys I think I've found the problem ive got extreme regarding from the cas, or pre ignition and why my fuel economy is so bad as well I found that a dodgy coolant temp sensor can cause this on skyline owners forum

Have you checked your sensor or just assume it is the issue?

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • That still isn't a lot to go on. I don't have a Y50 Fuga Head Unit wiring diagram. I can say that a lot of nissans of that age shared head unit plugs, so if you are in Australia something like this would probably help: https://aerpro.com/app091# You plug that into the car loom, then either plug the head unit ISO into that (if it has ISO), or you buy and ISO adapter harness that you wire in. Bit of stuffing around, but once you have ISO its easy to change things in future.
    • It is a kunfine Android screen . Does anyone know the wirering diagram of the fuga ??
    • just an update to this, poor man pays twice  Tried sanding down the pulleys but it didnt do the trick. Chucked another second hand alternator in the na car which I got for free off my mate and its fixed the squelling. Must have been unlucky with the bearings.    As for my turbo car, I managed to pick up a cwc rb alternator conversion bracket + LS alternator for 250 off marketplace, looked to be in really good nick. Installed it , started the car and its not charging the battery.... ( Im not good with auto elec stuff so im not sure if this was all I needed to do but I verified such by using a multimeter on the battery when the engine was running and I was only getting 12.2v )   I had to modify the earth strap for the new LS alternator , factory earth strap was a 10mm bolt which did not fit the bolt on the LS alternator which was double the size so I cut it off , went to repco bought some ring terminals that fit, crimped it onto the old earth strap and bolted it up to the alternator , started the car and same issue. Ran like shit and was reading 12.2 at the battery.  For a "plug and play" advertised kit thats not very plug and play but alas.  My question is , am I missing something ? Ive been reading that some people recommend upgrading the stock 80 amp alternator fuse to a 140 amp but I dont see how that would stop the alternator charging especially at idle not under load.  Regardless ive pulled it out and am going to get it bench tested by an auto elec tomorrow but it would be handy to know if ive missed something silly or have done something wrong.   
    • My wild guess is that you have popped off an intake pipe....check all of the hoses between the turbo and the throttle for splits or loose clamps.
    • Awesome, thanks for sharing!
×
×
  • Create New...