Jump to content
SAU Community

Recommended Posts

Hi guys,

I'm in a 70's apartment complex and I really wish I could hand wash my Skyline.  I currently take it to the $1 wash places.

I do have power but I have no water/tap nearby.  Also, I don't want too much soapy water run off in the common driveway area, I'm sure a little is fine though.

I'd like to know what type of high pressure washer would be best.  I saw at Aldi there are some available that can source water from a bucket via a hose, and also at Bunnings there are these things these Ryobi 20L bladders.

My questions are - how much pressure would I need to give my car a good wash?  These things range from $99 up to $499 and brands Ryobi, Karcher, Gurni, etc.

This Ryobi 1800W 2000PSI for $129 looks good, although it doesn't look like it can use a portable water source.

Questions:

  1. I've noticed some have a soap tank and some a separate soap bottle attachment - either of these good or should I just stick with soapy water in a bucket?
  2. How quickly do these units use up the water?  I mean, if I had a standard household bucket or the 20L bladder, would that be enough for a good wash or would I need to keep refilling it?
  3. What would be the minimum power / PSI I would want for a reasonable clean?
  4. Are any of the brands much better / worse than the others?
  5. Any recommendations on a mains powered portable water version?

Thanks!!

Edited by Haxorz

There's also the waterless wash and wax stuff. Depending on how much you trust the science behind it it may be an option. Seeing people use it on Ferraris and Porsches for years has made me believe it works fine for my 34.. 

/prepares to be brutally murdered

You don't need any pressure at all.  Any pressure washer will do more than enough.  You only want to wet the car prior to bucket&glove wash, then gently rinse it off.  High pressure concrete cutter type washes are for boats and bro-dozers, not nice cars.

Ok cool.  Just the most basic one then.

My current problem is finding a basic one that draws water from a bucket - the only one with the portable water source that I can see is the high end V36 battery powered Ryobi for $349 - 499...

Wish I jumped on the Aldi one sooner.

I like power washers, not paint stopper power held close though.

I use a little Karcher that has a foam attachment and hose that sucks u p car wash.

 

1st, I foam the car and let it sit

I then Karcher the foam of to remove all dirt and grit that a hose wo u ld leave, I get in nice and deep like....

 

I then hand wash and dry with bath towels.

 

Gee that ONR stuff looks awesome.  Does it really work?  I've seen a few YouTubes and it's people using it to clean already clean looking cars. 

Mine is black, parked outside and looks TERRIBLE and filthy after a downpour.  Hard to imagine it turning that into something clean with little friction based 'washing'.

I wouldn't use a spay on wipe off stuff if you like your paint, hell, I foam and pressure wash my car before I use my microfiber wash cloth.

 

I've done alot of work with soils, in construction, with that alot of soil testing and research.

 

Alot of that fine dust you see is fine sand and silt, both are bulky materials, whilst it is small it does scratch shit up good.

But, don't let that get in the way of good marketing

 

images.jpeg

Having lived with a Skyline in the inner city, I'd be less worried about micrometer scratches from dirt and more worried about people who employ "touch parking" techniques.

  • Haha 2

It does work yes. But generally recommended for light to medium dirt buildup, so I wouldn't use the method on a really filthy car. 

When i was driving my S14 every weekend, I would clean it every Sunday night with a quick detailer and 2x clean microfibre cloths - never had issues with swirls or scratches

22 hours ago, junkie said:

It does work yes. But generally recommended for light to medium dirt buildup, so I wouldn't use the method on a really filthy car. 

Cool, I thought so.

Mine gets really really filthy with trips out the country.

I was thinking of combining both, a cheapie $99 Karcher pressure washer , this $45 suction hose kit (which is a rip off but required because it has the fancy valves in it to stop sucking in air and allow it to work against gravity) to first spray it all down and then use the rinse-less wash to 'wash' the car and perhaps a powerful air blower to dry it.

I just can't see the rinse-less wash washing off splattered on bugs, heavy dirt and other hard to remove things like that.

Combined with buckets and sponges it looks like I'd be spending near $200 just to wash my car at home, now I know why I've been using the $5 do it your things.  Went to wash it at my nearest one but the queue was 3 cars deep, one of the cons of living inner city.

The rinseless wash stuff feels like magic when you use it though. Now I don't know about the chemicals but the claim is that it breaks the bonds down between the paint and the dirt itself. It "feels" like it dissolves it instead of wiping it off. So quite often you will spray something stubborn and it wipes right off, which is... skeptical.

Things do exist for bug stuff though - Pretty much the hardest things that exist to clean off a car really is good ol dried up splatters after going for a drive in the country.

That said, the rinseless wash stuff is often regarded to as "the wash between washes" so to speak. The bonus is if you do it once a week it literally takes ~5 minutes. Hasn't really been in use long enough yet for someone to say "I did this once a week for 10 years and this is what happened to my paint" yet.

  • 2 months later...

Like others, I have been using Meguiars waterless wash for a few years now and am sold on it.  I wash the car properly about every 3rd or 4th time, but in between I use the Meguiars.  An added bonus is the 'as good as wax' finish it gives you,  And I can do my whole car in 15-20 minutes.  Only thing I do before starting is to use a dust mop/brush on the car first, a 5 minute job.

And you need so little of the waterless solution that I am still using the same bottle.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Clutch is a spec brand, new clutch system,( PP, flywheel, friction disc, etc. pull type) installed 100 miles ago, with no problems.
    • looking for some help and maybe some insight on others experience with a new LSD. R34 GT ran and drove beautifully, but always alot of grip loss due to the open R200 rear end, so I just installed a new 1.5 LSD way into the stock open R200 for a ER34. Simple. Everything seemed right. I test drove for the first time this weekend. as I started to back out the garage the first time slowly with tires straight it sounded and felt like I had a loose or half disconnected drive shaft...that was clucking around loose and shaking entire vehicle, and making it feel like the trans clutch was spontaneously slipping then grabbing very roughly while just letting out pedal slowly. I backed it out went to pull forward with the same noise, shake and slip grab feeling with hesitation, I turned the tires to back out more and then pulled ahead some same thing but worst because of added wheel resistance (which that I expected) puzzled … pulling it back in checking everything over and finding nothing wrong, I tried it the next day. same thing, couldn’t believe how it shook everything again making a terrible noise and making it feel like the trans clutch was slipping and grabbing, but I got it out of garage into the driveway, got it straight, drove forward and then reveres a few times in a straight line everything shaking , causing what felt like clutch slip and grab every time, sounded like right behind front driver tire and I could feel it in the floor board with my feet,... worst right when beginning to let clutch pedal out to engage slightly, shuttering and sounding terrible along the way…I managed to slowly get down the road, babying it the whole way, once I was rolling (out of 1st) seemed to be better and between shifts, then clutch felt closer to normal…not slip/ grab etc., but back down to any stop, straight road or turning, same thing. Made no difference if all tires were straight or if I was turning. All other gauge read out correct. with in 2 miles as planned I reached the empty parking lot and performed the break in procedure that came with lsd, essentially to drive in a figure 8 a bunch.  Did this, binding chattering, and shaking the car the whole way. I drove it back home seemed somewhat normal once I was in straight line and past 10 mph or so, and I know it will “bind” on corners and cause some tires squeal when turning especially from a stop, but when I begin to move it still causes what feels like the trans clutch to slip and jerk badly as well as shaking the entire car, and sounds terrible, that I didn’t expect. I used the fluid they supplied with LSD kit and did the breaking, planning to change fluid as they suggest after breaking, but wondering will it get smoother or less aggressive with use? maybe a 1.5 is just too aggressive for normal road driving?   I have a LSD that I put in my 71 cuda when I restored it, with amazing smooth , quite yet effective results. Different style LSD but that ones a joy to drive. maybe expecting too much from this R200?
    • Join SAU NSW for a flame-grilled feed & flame-spitting cruise! Sunday 17th August 2025 3:30PM Meeting Archies Flame Grille Sylvania Waters 4:45PM Cruise Departure 5:15PM Arrival at Cape Solander Kurnell Meet Location: Archies Flame Grille Final Destination: Cape Solander Kurnell *Disclaimer* There will be a lead and follow car so no one should get lost. If you would like to attend or bring others along please put your name down and a +1 as numbers will be needed prior! This is NOT a race and we will all be adhering to all road rules. If this is what you want please come to one of our many track days. This is an official SAU:NSW event and will be run under a CAMS permit. One of the things that really sets our club apart is our commitment to being true enthusiasts. When on normal roads we strive to maintain good relations with the authorities as well as the public in general. When attending one of Skylines Australia NSW events please try to: • Be aware of surrounding environment and act accordingly. • Drive courteously on the state’s roads as a true enthusiast should. • Understand how important it is to maintain the good name of SAU NSW and thus, treat others accordingly. • Any misbehavior will not be tolerated and you will be asked to leave.
    • Yeah good luck out there! Will be good to see a mighty GTST going harder than the GTRs
    • i will be there 😁
×
×
  • Create New...