Jump to content
SAU Community

Recommended Posts

Hi I just recently purchased a r33gtr and looking to get it tuned on 98 as I don’t want to go e85 I was hoping for 380kw atw on 98 do you guys thing it’s reliable to achieve this power with these old turbos mod list below

Starting with r33 block, r33 crank with n1 oil pump, eagle rods,wiseco pistons, arp main studs,acl race bearings, tomei 260 deg pon cams, cometic head gasket.

Trust t517z turbos wiyh trust hard pipe kit

Trust race intercooler, hks dump pipes and 3in exhaust

R33 twin synchro box with twin plate clutch.

Sard fuel pump with 720cc injectors and billet fuel rail, Sard fuel pressure reg

Brake vacuum chamber

Apexi power fc with z32 airflow meters

Trust boost controller, and turbo timer

Edited by Berksgtr
Link to comment
https://www.sau.com.au/forums/topic/480867-400kw-goal/
Share on other sites

For reference, back in 2011 my 33 gtr with a built motor, good head t51r, full fuel system 1000cc injectors, and everything that should go with it was making 422kw on 20psi with 98

before going the full fuel system with surge tank and extra pump and to 4” exhaust, I think we maxed out out at 401 from memory.

Best bet would be to look through the dyno section for something with similar mods to you to get a reference of what to expect.

the end of the day a dyno is just numbers that can be fudged either way. True test of power is 1/4 mile

Link to comment
https://www.sau.com.au/forums/topic/480867-400kw-goal/#findComment-7937297
Share on other sites

Thanks for the replies I just bought the car last week I know it’s an old set up I’m be holding the car for a long time and will change things gradually Ben c34 what needs work any recommendations as I don’t know which direction to go thanks

Link to comment
https://www.sau.com.au/forums/topic/480867-400kw-goal/#findComment-7937310
Share on other sites

46 minutes ago, Berksgtr said:

Thanks for the replies I just bought the car last week I know it’s an old set up I’m be holding the car for a long time and will change things gradually Ben c34 what needs work any recommendations as I don’t know which direction to go thanks

Immediately just lose the turbo timer so it doesn't give you problems one day. For the rest just try to track down a good tuner and post up the results!

Link to comment
https://www.sau.com.au/forums/topic/480867-400kw-goal/#findComment-7937315
Share on other sites

Hang on, so does the car already have that list? Or is that to purchase?

 

No sane person would buy a power fc new nor those injectors considering the substantially better options available now. . If you already have them it's a different story.

 

 

And as above lose the turbo timer.

  • Like 1
Link to comment
https://www.sau.com.au/forums/topic/480867-400kw-goal/#findComment-7937321
Share on other sites

Haha yeh wow. Genuinely had to check if this post was from 2003 ?

 

OP, if your car already has those mods then just get the car tuned and be happy with where it ends up knowing that there is plenty of money to be wasted in the future chasing more. 

  • Haha 3
Link to comment
https://www.sau.com.au/forums/topic/480867-400kw-goal/#findComment-7937324
Share on other sites

3 hours ago, KiwiRS4T said:

Immediately just lose the turbo timer so it doesn't give you problems one day. For the rest just try to track down a good tuner and post up the results!

Why get rid of the turbo timer? I thought they were a good thing for turbo engines to let them sit for a bit after driving before shutting off the engine.

Link to comment
https://www.sau.com.au/forums/topic/480867-400kw-goal/#findComment-7937328
Share on other sites

2 hours ago, nouveau_poor said:

let them sit for a bit after driving before shutting off the engine.

And this is something that you cannot do for yourself? After all, it only needs doing if the car has been working the turbo a bit hard in the last couple of minutes before stopping. It hardly needs to be run to cool down on about 95% of stops.

Link to comment
https://www.sau.com.au/forums/topic/480867-400kw-goal/#findComment-7937331
Share on other sites

@Berksgtr It'll get close to 400 rwkw or 380ish awkw on 98. T517 is rated closely to -5s. Unopened 26s have hit that target. It'll just be a tad laggy by todays standards. Will still be good. Gotta start somewhere! Congrats on the car :)

Link to comment
https://www.sau.com.au/forums/topic/480867-400kw-goal/#findComment-7937338
Share on other sites

7 hours ago, GTSBoy said:

And this is something that you cannot do for yourself? After all, it only needs doing if the car has been working the turbo a bit hard in the last couple of minutes before stopping. It hardly needs to be run to cool down on about 95% of stops.

fair enough sure, but why get rid of the timer if he's already got it? The other post sounded like the timer itself would cause an issue.

Link to comment
https://www.sau.com.au/forums/topic/480867-400kw-goal/#findComment-7937354
Share on other sites

Can attest to the shittness of turbo timers, I had one in the Skyline as a young pup. Caused all sorts of issues from not starting, to not switching off when the countdown reached 0, to being a parasitic drain on the battery, etc. Even after pulling it out, the loom has been hacked into, there's no making that reliable again. Its one of the reasons I undertook a complete rewire of my car.

 

Stupid things. Feel embarrassed to have had one. As GTSBoy says, try to think of the last time you boosted your car hard and then switched the engine off. It just doesn't happen, there is always 1 or 2 minutes of sedate driving before you park up that is far more effective than 30 seconds of idling. Superbly ricer modification.

  • Like 2
Link to comment
https://www.sau.com.au/forums/topic/480867-400kw-goal/#findComment-7937363
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Was going to say the car pulls up nicely everywhere, especially going into that last long right hander before the main straight. Looks like a lot of fun.
    • Hey Dave, welcome aboard! Good to see another soon-to-be Stagea owner here. The wagons are awesome — plenty of space, still got that Skyline DNA, and loads of potential if you’re into mods. Definitely post up pics when you get it, everyone here loves seeing new builds. What model/year are you looking at?
    • See if you can thermal epoxy a heatsink or two onto it?
    • The other problem was one of those "oh shit we are going to die moments". Basically the high spec Q50s have a full electric steering rack, and the povo ones had a regular hydraulic rack with an electric pump.  So couple of laps into session 5 as I came into turn 2 (big run off now, happily), the dash turned into a christmas tree and the steering became super heavy and I went well off. I assumed it was a tyre failure so limped to the pits, but everything was OK. But....the master warning light was still on so I checked the DTCs and saw – C13E6 “Heat Protection”. Yes, that bloody steering rack computer sitting where the oil cooler should be has its own sensors and error logic, and decided I was using the steering wheel too much. I really appreciated the helpful information in the manual (my bold) POSSIBLE CAUSE • Continuing the overloading steering (Sports driving in the circuit etc,) “DATA MONITOR” >> “C/M TEMPERATURE”. The rise of steering force motor internal temperature caused the protection function to operate. This is not a system malfunction. INSPECTION END So, basically the electric motor in the steering rack got to 150c, and it decided to shut down without warning for my safety. Didn't feel safe. Short term I'll see if I can duct some air to that motor (the engine bay is sealed pretty tight). Long term, depending on how often this happens, I'll look into swapping the povo spec electric/hydraulic rack in. While the rack should be fine the power supply to the pump will be a pain and might be best to deal with it when I add a PDM.
    • And finally, 2 problems I really need to sort.  Firstly as Matt said the auto trans is not happy as it gets hot - I couldn't log the temps but the gauge showed 90o. On the first day I took it out back in Feb, because the coolant was getting hot I never got to any auto trans issues; but on this day by late session 3 and then really clearly in 4 and 5 as it got hotter it just would not shift up. You can hear the issue really clearly at 12:55 and 16:20 on the vid. So the good news is, literally this week Ecutek finally released tuning for the jatco 7 speed. I'll have a chat to Racebox and see what they can do electrically to keep it cooler and to get the gears, if anything. That will likely take some R&D and can only really happen on track as it never gets even warm with road use. I've also picked up some eye wateringly expensive Redline D6 ATF to try, it had the highest viscosity I could find at 100o so we will see if that helps (just waiting for some oil pan gaskets so I can change it properly). If neither of those work I need to remove the coolant/trans interwarmer and the radiator cooler and go to an external cooler....somewhere.....(goodbye washer reservoir?), and if that fails give up on this mad idea and wait for Nissan to release the manual 400R
×
×
  • Create New...