Jump to content
SAU Community

The Epa Thread/Roadworthy Thread

Do-Luck

By Do-Luck,
in Victoria

 Share

Recommended Posts

stolen_s15 Mentor

stolen_s15

Posted
Posted
just got pinned today... :P

i can get the RWC part sorted (ride height, seat belt retractors and non padded steering wheel, afaik - still waitin on letter) but its the EPA i'm worried about... copper didn't say if it was a full test or just exhaust vol and i was WAAAAAAY too scared to ask him as he was in a FOUL mood when he pulled me over.

i have an aftermarket turbo (not highflow but lowmount) / ecu / injectors / fuel pump / BC / exhaust etc

if its a full test and i just put on the stock zorst from the dump or cat back and change out the ecu for the stocker am i gonna pass or are they going to look @ the turbo and simply say no way?

i'd MUUUUCH rather not have to go changing out turbo's as its only been in a week! :)

If you get the full test you will need to remove ecu/inj/turbo & bc. If the pump is just an in tank you will be fine. You might even be ok with a big one in the boot or similar, I never had my boot opened the 4 times I have been.

They will see the colour of you injectors is not normal and you will fail, they will see your shiny HKS heat shield and turbo (yeah they look that closely) and you will fail, they will check your ecu and you will fail.

To answer your question R34 NRG you roll up into a little booth and they visually inspect the car (engine bay, exhaust setup, etc) they will take notes on your setup incase you re-offend. They then stick a probe up your exhaust and do some emission testing (not 100% sure what they do here) I never had a problem with this section.

Then you move you car out to an open space where they test noise. Basically placing a microphone about 1.5m away from the exhasut tip and reving your car to 3/4 (from memory, might be more or less) of the rev range. You must be under 90db.

They then slap a green defect like sticker on if you fail and tell you you have 28 days to fix it otherwise your rego will be suspended, you cant sell the car in this time either (but it can be driven any time).

If you pass you go on your way and pray you never return

I would advise you are very polite and dont try to lie to them, they really know their sh*t.

  • Replies 1.6k
  • Created
  • Last Reply

Top Posters In This Topic

Popular Days

Top Posters In This Topic

Popular Days

Popular Posts

Miguelone
Miguelone

Both fairly straightforward jobs. Really depends how fussy workshop is and how bad the leaks are. If you pressure wash beforehand and it's a minor weep it may not be an issue. ANother option is of cou

wht510
wht510

It is interesting, the dynamic currently. I think with the camera/database and automated method of checking number plates, they already know what kind of driver you are (speeding fines, previous

SKY031
SKY031

Useful links: Legal stuff Traffic Law in Victoria < READ THIS! Approved EPA Testers EPA Guidelines (2006) Is it legal to drive a 33 GTS-t on P's? The answer can be found here .....more inf

Posted Images

Count Grantleyish Grand Master

Count Grantleyish

Posted
Posted

G'day,

I have one question regarding tyres.

Would road legal semi-slicks such as Bridgestone Re55 pass RWC providing there's decent tread?

Or i'd be better off using radials?

Cheers

Grant

joeyjoejoejuniorshabadoo Grand Master

joeyjoejoejuniorshabadoo

Posted
Posted

just hoping he didnt bother.... he left in a better mood than when he started (gool ol-fashioned citizen to officer felatio) and left a few things he mentioned off the canary...

*crosses fingers...moreso*

stolen_s15 Mentor

stolen_s15

Posted
Posted
im on the new p plate laws with no engine modifications that increase performance.

would i get away with a lightened flywheel?

They will never find out. But a lighter flywheel wont increase power anyway.

  • 2 weeks later...
cosmokram3r Proficient

cosmokram3r

Posted
Posted

Im on my green P's right.. got a r32 gts-t with fmic/pod/bc/turbo back exhaust..

now i know they can get me on the high powered laws if they knew i had the turbo back exhaust and bc.. but can they get me for having the fmic and pod? because stock the car is under the power to weight ratio but if i got rid of the BC and just had a fmic and pod i know they can defect me for having them both.. but can they say my car is high powered because ive modified it and those mods could increase the power?

cosmokram3r Proficient

cosmokram3r

Posted
Posted

So what can I do to prove its not.. dyno it and have the sheet's ready if the cop's pull me over to say here are the specific spec's for my car its under the power-to-weight ratio? but then they can say u couldve done that before the dyno etc..

I know the FMIC/POD is illegal for EPA but whethere i get EPA'd or Defected its no big fuss to get rid of the pod.. I was thinking if i get a heatshield made or a sheet or metal covering the pod, i know it wont help me on the EPA side of things but legal wise would it considering the cops wouldnt be able to see it? Or maybe even see if i can get someone to do a custom job with my stock airbox to fit over the pod so you cant see it?

It wouldnt be such an issue if i could fit the airbox in there but apparently where i took it they said theres no room for the airbox, only the POD.. so im not really sure what to do i want to make it look as stock as possible under the bonnet and as legal as it can be til i get off my P's..

DogKnight Mentor

DogKnight

Posted
Posted

From my knowledge, the majority of the time they will go off factory power to weight figures to determin if its oevr what it should be.

If situations where its modded they probably wont accept a dyno sheet from you proving the power, rather they will just tell you to return it to stock or rather epa/defect you for everything under the sun they can find :blink:

boostn0199 Grand Master

boostn0199

Posted
Posted

wtf a cop pulled me over and could find nothing defect me for and end up major defecting my s2 r33 which is stock height for being to low by .5mm. is there anything i can do to appeal it or should i just get a rwc and clear it

cosmokram3r Proficient

cosmokram3r

Posted
Posted
From my knowledge, the majority of the time they will go off factory power to weight figures to determin if its oevr what it should be.

If situations where its modded they probably wont accept a dyno sheet from you proving the power, rather they will just tell you to return it to stock or rather epa/defect you for everything under the sun they can find :(

Under the bonnet my car isnt heavily modded.. Just fmic/pod, blocked off BOV which i need to unblock, stock plumb back is on there, and im gonna get my SSQV welded near the REO. Also got the R33 turbo but im sure they couldnt figure out that i've changed the turbo. oh and BC but im gonna get a new one installed hidden. But coz of the blue paint job and black bonnet i got now it looks really flashy.. Before i got the car painted i had never been pulled over with my car.. 1 week after the paint job and i get pulled over lol

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing


  • Similar Content

  • Latest Posts

    • Dose Pipe Sutututu
      What brakes on R34 GTT(Europe)

      By Dose Pipe Sutututu · Posted

      Pads for R32 GTS-t, R32 GT-R non V-Spec (Sumitomo), R33 GTS-t and R34 GT-t are all interchangeable. R34 GT uses a 2x piston caliper, hence it didn't fit.
    • soviet_merlin
      WGNC34 - floor mats

      By soviet_merlin · Posted

      Checked with amayama and nope, the full S2 manual set is not available anymore. Unsurprising, but still disappointing as the ? on availability gave a glimmer of hope.
    • joshuaho96
      Tomei gasket

      By joshuaho96 · Posted

      I've heard the Tomei USA head gaskets are decent if you want to o-ring the heads but otherwise not recommended.
    • GTSBoy
      What brakes on R34 GTT(Europe)

      By GTSBoy · Posted

      The 296mm rotors are the R33 turbo brakes. The 310mm rotors are the R34 turbo brakes. The calipers are nearly the same, but not. They're the same caliper but the R34 caliper has longer legs so that it sits out far enough to go over the rotor. The pads are the same for both. When you say, "I bough tsome EBC"....did you just mean pads? Or rotors? 310mm rotors fit under 17" wheels. There may be some wheels without enough clearance though. I can't fit my fingers between the barrel of my wheel and the "corners" of my R34 calipers, but there is plenty of room behind the spokes. This is on Enkei RPF1. You can fit 324mm rotors inside a 17" wheel, but I'd be willing to bet that it would be close to impossible with the Nissan/Sumitomo caliper (using an adapter, of course), because the Sumitomo caliper is fatter than the Brembo caliper that is supposed to go on the 324mm rotors.
    • Kapr
      What brakes on R34 GTT(Europe)

      By Kapr · Posted

      Hi. Can someone tell me what brakes(and mainly WHERE) can i buy brakes on R34 GTT? I bought some EBC which SHOULD go on my car(i have GT but it has GTT brakes) but it does not fit, Brakes are "too" small(296mm) Are 310mm be good or? I have 17 inch wheel so no "big boys" but for me driving i just need one that fits and i can get here in EU/Czech.
×
×
  • Create New...