Jump to content
SAU Community

Recommended Posts

I went to the 'Dyno B' and got my car

dyno'd. Except i only got about 163rwkw 'Dyno B', unlike 193rwkw which i got at 'Dyno A'.

The guys at 'Dyno B' said that peak power dropped off at about 5000rpm, when it actually

should still be increasing. The only thing i have changed since the first dyno was, i installed a S/S

inlet pipe between AFM & turbo.

The power curve was fine at 'Dyno A'. Have you ever come across this before?

Both dyno runs showed good AFR's.

What would be the more appropriate power output figure for my current mods.

Mods:-

1993 R32 Skyline

RB20DET

Stock internals

5-speed manual

R33 S1 turbo

Trust front mount intercooler

Full exhaust (Split 3' dump/front pipe)

GTR fuel pump

Boost controller running at 14psi

Re-mapped ECU

Air pod

S/S inlet pipe

Edited by lows_13
Link to comment
https://www.sau.com.au/forums/topic/166491-power-figure-issue/
Share on other sites

163rwkw sounds realistic

lots of things can affect the readouts, post both dyno sheets

one could have air temp correction, the other might not

one could be in a different gear or different ramp rate etc

Dynos can be calibrated differently therefore showing that some cars have less powerful then they do on a different dyno. The stainless steel intake pipe shouldn't have made any difference as the only problem i've heard of is with the stock plastic one contracting under suction and limiting air flow so if anything the s/s one should be better. my suggestion would be to go back to dyno A and get a re-run on that

most Rb20's with the 25 turbos make any where from 160 to 180 ish rwkw, even more if they are pushed to 14 psi. but for the sake of it we'll assume 12 or so psi.

dont be too fussed about different dyno reads out tho, does the car feel any different on road compared to both dynos?

maybe the stainless inlet pipe has made your car slower/less powerful? I mean if that's the only thing you've changed and your power has gone down... how does it feel to you?

maybe the stainless inlet pipe has made your car slower/less powerful? I mean if that's the only thing you've changed and your power has gone down... how does it feel to you?

Power feels about the same after the S/S inlet mod.

Theres a lot more turbo sucking sound, thats about it.

The ambient temps clearly show the 2 runs weren't done on the same day, probably not even the same month! Is it any wonder then that you encountered differences. Although I would expect the colder day to produce better power.

Are both dynos the same model? Same manufacturer?

They say that each 3 degree increase in intake air temp makes a 1% reduction in power.

So for a 20 degree (at least) increase in temp thats probably 8% power just there, compounded by the hotter air going through the intercooler...

So more like 10-15% power drop from increased temp and your getting to be in the same ballpark kW reading.

Rhett

  • 3 months later...

im going with the 160 mark because near on 200kw? on 14psi with a tiny 2lt engine?? hahah no chance... not with a standard r33 turbo.. ive driven one of those b4 and damn they are torqueless and slow :rofl: sorry dude but theres no chance urs makin near on 200rwkw

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Seat of the pants assessment of the new intake: The car is way less "doughy" when hitting the loud pedal, especially off idle when stopped or in traffic, I did use a cheapo lazer thermal thingo to measure the temp around where the pod filter got its air, it was between 55 - 60°C, in saying this the car was shut off and not moving, so the OEM intake pipe was not supplying any fresh air to where the pod was when the car was at least moving A weird bonus was induction noise on the throttle in the cabin increased a bit,  I was worried that I was actually going to lose some of that induction noise I love so much, outside though, when I got the daughter to do a WOT drive by pass for me, the induction noise has increased alot when on the throttle, not quite ITB doort, but well up there I'm extremely happy with the results and have been exploring the country roads in the region  As for house mods: 1.New front fence is up and is awesome, it really upgraded how the joint looks from the street, and the added security is nice 2. Electricians have replace some interior lights, and with more lighting in the garage, a few new motion detecting lights out the front above the garage, front room, and at the front door, which I have already found heaps helpful coming and going, also now has fancy pants CCTV all round the house The only hold point for power though is the solar and batteries due to supply issues, although this will happen over the next few weeks 3. I have done a heap of landscaping out the front and I'm almost ready to do a new small retaining wall with some nice blocks to replace the brick and cemented in rocks around the raised garden beds cemented in river stone "was the fashion at the time" the house was built. I currently have a pallet of retaining wall blocks and 2 bulka bags of 20mm blue metal to replace the wood chip that is in the raised garden beds around the house 4. I now have 3 big raised garden beds for out the back to grow some vegetables, about 70cm high, 200cm long and 100cm wide 5. My 2 compost bins are already pretty full with brown, green and kitchen waste from the landscaping I'vedone so far, but they will probably take a few months to break down, so anything else that gets chopped, trimmed, and kitchen waste will just start filling the base of the raised garden beds to about 30cm before I start throwing 40cm of good compost, and stuff, for the vegetables to grow in, I'll need a few ton of compost and soil, but the local supplier can sent me bulka bags of the stuff Basically the logs, wood chips and a few strategically placed rocks for drainage, will give the beds some good organic materials down low to break down over time, and they will hold moisture during the warmer months to save the water in my big arse water tank if we don't get alot of rain So, all in all, the car and house mods are going well, and I'm really enjoying being retired, I sleep in too 0700 and slowly plod around inside until I feel like actually doing anything, and only work in the yard for as long as want, which has actually been alot over the last few weeks,  although when you look at it, it seems that not a huge amount of work has been done,  until I look at the before I started the work pics Happy days and good times indeed 
    • hahaha yeah. Plan is to get side skirts and probably just rear pods. But going to do them one-by-one. I've got a set that I really like from RHDJapen, but that one isn't shipped to AU. So need to find someone who can get it for me
    • Here's an idea, answer the questions I asked you as they are trying to work out WHY the LSD will be binding up in a straight line.
    • You haven't driven many modern cars then have you? Most of them have sfa steering feel with their stupid electric bullshit steering systems.
×
×
  • Create New...