Jump to content
SAU Community

Recommended Posts

Whilst I don't disagree with your statement, what I meant by "better" is feeling smoother and more effortless. The car may actually be faster at the same boost, but I couldn't really tell this from the feel...I'd have to do some timing tests.

The psychological feeling that your foot is only at half throttle, producing the boost that normally appears at full throttle, is certainly nice.

. I take it you're running an SS1PU, siks?

Yep, normal SS1PU

7psi on stock turbo doesn't = 7psi on this turbo which is why it feels so much better. it is pumping a lot more air.

This is true with the SS1PU compared to stock - I noticed on the freeway in 5th gear more than anything - light throttle and 10psi gives you better acceleration than flooring it on 10psi with the stock turbo.

Holy hell im excited to install this bad boy!

Any fitmeant issues?

Also where did you get your gaskets from?

I didn't fit it, OTR did the installation for $450, which included replacing all exhaust manifold studs. There were some broken studs, so I'm glad I didn't screw around with the install myself. As far as I can see, the only fitment issue they would have had, is that my whole exhaust now sits about 1 inch further back, because Stao's dump flange sits closer to the firewall than the standard dump flange. They didn't modify the exhaust though, and my tail pipes come further out the rear, so the whole system must have had enough slack in it. According to Stao, all you have to do with the standard exhaust system is remove the gearbox mounted exhaust bracket. I'd previously removed this part and my exhaust is custom made, so not applicable.

Exhaust manifold gasket was genuine Nissan, the rest were "permaseal" that I got on eBay (don't get the cheap eBay ones, they are shit).

Cheers for the info birds

I'm going to have a shot at installing it myself if I fail then I'll go to an exhaust shop or similar.

let that guy in the chopper install it for ya Kasko ! ! He looks up to the task....pinch.gif

It always scared me, the thought of upgrading my turbo and losing too much of the factory response / daily drivability. If you have these concerns, get this turbo. What little response I have lost, translates to a better daily drive all round

haha,

Oh how concerns of lost response quickly fade when the boost hits ya.

haha,

Oh how concerns of lost response quickly fade when the boost hits ya.

Agreed. Honestly, most people I have met (in person) who are concerned with stock response blah blah have never been in a laggier but fast car.. once they experience that they forget about off boost and at low rpm issues.

Same with with NA is best crowd - ive lost count of how many of those people i have taken for a ride after which they shut up about NA and suddenly want to buy a new turbo car lol

glade to know every thing's going well.

This might be off skyline topics but any one know any good ecus or perferred plugin ecus or flash software that I can run with a VW Golf GTI 2L turbo DSG motor? Got a offer to develop bigger bolton turbo for that car but its totally new to me. cheers.

Also I will be starting some evaluation on externally gated turbo combinations, and will be able to supply those at a very reasonable price including some of the popular TD06 and T67 combinations. Possibly with billet wheel and ceramic roller centers.

God I can't wait for my tune, this turbo is begging to be unleashed! So much self control required :(

It would be interesting once you get your car tuned to drive back to back against Ric's GT3071r 280rwkw car.

Should be a very good comparison :thumbsup:

Agreed. Honestly, most people I have met (in person) who are concerned with stock response blah blah have never been in a laggier but fast car.. once they experience that they forget about off boost and at low rpm issues.

Same with with NA is best crowd - ive lost count of how many of those people i have taken for a ride after which they shut up about NA and suddenly want to buy a new turbo car lol

There are extremes of it though. When I drove Stao's R33 I didn't like the lag at all, it totally nullified the awesomeness of 300rwkw+ in the top end. Each to their own though - I like a car that can move through the traffic gaps quickly or rolling drag without dropping down a gear. The SS1PU, so far seems like a very good balance between a boost machine and a commuter.

It would be interesting once you get your car tuned to drive back to back against Ric's GT3071r 280rwkw car.

Should be a very good comparison :thumbsup:

Will be doing this for sure! I'll also be heading down the E-flex path after I'm done with the PULP tune, has anyone done this with the SS1PU yet? Will be interesting to see what she is capable of.

Pulled out everything today and will be fitting the PU tomorrow. Can you believe my dump pipe bolts were able to be unscrewed by hand and also the manifold bolts

Either the freezing stuff I purchased from autobahn is amazingly good and everyone should get it or the last person who did them up had no clue!

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • @GTSBoy Ok so that was the shops problem...they showed R33 rotors on R34 page and i did not know 296 do not fit(and are for R33) Yes i bought "kit" with rotors and pads. Pads are ok(i have GTT calipers front and rear). They have some 324mm but no 310mm. So i dont know if they would fit. I have 17inch LMGT4s So another question. Can i fit those in the rear or they are just "too" big for that?
    • I started removing the tank a while back with the intent to give it a proper clean. Got to a bolt that I couldn't undo completely due to a diff being in the way, so just said f**k it and siphoned the gluggy old fuel out and called it a day. Looking it the tank it looks less corroded than the one in the pics for that billet hanger from Frenchy's anyway. Isn't it the fuel filters job to worry about this stuff? I scraped off most the crusty shit of the hanger but will give it another go before reinstall coz maybe the fuel and return pipes are also full of gunk  
    • Pretty sure it is a common fault. I believe this is the only part you need, but don't quote me as I don't have a V36.  I also believe it is a bit of a pain to change and the device needs to be encoded to the car once it is replaced, so may need someone with the right tools. Buy Genuine Nissan 48700JF00D (48700-JF00D) Lock Set-Steering. Prices, fast shipping, photos, weight - Amayama
    • Pads for R32 GTS-t, R32 GT-R non V-Spec (Sumitomo), R33 GTS-t and R34 GT-t are all interchangeable. R34 GT uses a 2x piston caliper, hence it didn't fit.
    • Checked with amayama and nope, the full S2 manual set is not available anymore. Unsurprising, but still disappointing as the ? on availability gave a glimmer of hope.
×
×
  • Create New...