Jump to content
SAU Community

Recommended Posts

..... isn't the manual rated lower than the auto too? Anyway, isn't the 6 speed auto much better suited to the car, even unladen?

I don't see the logic in towing with an underated tow vehicle, crash it and no insurance for anything, bye bye to both vehicles.

The clutches in them do not cope with towing, even with loads under the limit (mind you, the 1600kg limit is for a car with a 65kg driver and nothing else on board) stick with the auto's with the heavy duty tow pack and they are Ok.

I don't see the logic in towing with an underated tow vehicle, crash it and no insurance for anything, bye bye to both vehicles.

Bingo!!!

Also, something that most people don't know is that if you're towing more than 2000kg, then your trailer must be equipped with brakes on all 4 wheels, and must also have a break away system fitted (so that the trailer brakes automatically apply if the trailer becomes disconnected from the car). Very few car trailers have this unless it's specified as a 2500kg (or more) trailer. That's why you'll see the load rating on all car trailers as 2000kg TOTAL.

I haven't read the wording lately, but I believe that the 2000kg refers to the total trailer mass + the load on the trailer - the downforce on the tow ball (normally about 100kg or so). Note I haven't double checked for a while, so that last bit may not be correct. Best to determine for youself before committing.

The auto Falcons used to have a higher towing capacity than the manuals (in the days of the EL, anyway). Don't know if that's changed in recent times though.

Many modern 4WD's have piddly clutches that aren't really up to the task of regular towing. In the name of making the 4WD's more user friendly for their intended purpose (soccer moms, etc.) they have lightened a lot of the controls by fitting more car-sized components. My PAthfinder will quickly smoke the clutch while towing if I'm not careful, although after 75,000km it is still going strong.

Many modern 4WD's have piddly clutches that aren't really up to the task of regular towing. In the name of making the 4WD's more user friendly for their intended purpose (soccer moms, etc.) they have lightened a lot of the controls by fitting more car-sized components. My PAthfinder will quickly smoke the clutch while towing if I'm not careful, although after 75,000km it is still going strong.

they shoulda stuck with the power assisted clutch like my 88 GQ TD42 has instead!

What the hell is wrong with heavy clutches anyway? My wife hates these modern light clutches as much as I do. We both loved the heavy clutch in the GTS2 we owned many years ago (was a heavy sumbitch, but great feel - the clutch that is, not my wife :banana: ). all others since then have felt like shopping trolley clutches - very disappointing.

I've been towing my 1200kg car+trailer abit lately with my brand new Holden Ute SS-V and love it. I put the cruise control on the speed limit and it sits on it the whole way everywhere I go. When on a flat road it switches the v8 into 4 cylinder mode and I can do 6L/100km whilst towing.

I've been towing my 1200kg car+trailer abit lately with my brand new Holden Ute SS-V and love it. I put the cruise control on the speed limit and it sits on it the whole way everywhere I go. When on a flat road it switches the v8 into 4 cylinder mode and I can do 6L/100km whilst towing.

IRS :)

I've been towing my 1200kg car+trailer abit lately with my brand new Holden Ute SS-V and love it. I put the cruise control on the speed limit and it sits on it the whole way everywhere I go. When on a flat road it switches the v8 into 4 cylinder mode and I can do 6L/100km whilst towing.

Changed how many rear tyres Ben ?? The IRS on these is a JOKE. My mate had had 3 sets on the back in 50K

Only Commodore/ute that can really tow properly is the VZ Crewman crew cab which has a live rear axel and 2500kg towing capaity. Preferably with a V8.

I have a 6 cylinder one which is marginal/good for towing a car but is great otherwize.

Having said that. You will prob not have an issue cause you car/trailer is so light. The massive trailer and the zed on it where pushing 2000kg. It was a very long trip from QLD.

PICT3904.jpg

Edited by Tektrader69

yeah thanks for the comments. I really want a manual and i know that it's rated at less but I'll be getting an aftermarket heavy duty (2000kg) tow bar. will prob wear out the clutch. I only tow every couple of months so hopefully it will be ok. Gotta be better than my VS SS.

I've just read on the ford forums that they flog out tailshaft uni's. Might need to beef up the suspension so it's not dragging on the ground.

I really don't want an old 4WD. They may have the weight to make it legal to tow with but they're slugs. and uncomfortable.

Also, something that most people don't know is that if you're towing more than 2000kg, then your trailer must be equipped with brakes on all 4 wheels, and must also have a break away system fitted (so that the trailer brakes automatically apply if the trailer becomes disconnected from the car). Very few car trailers have this unless it's specified as a 2500kg (or more) trailer. That's why you'll see the load rating on all car trailers as 2000kg TOTAL.

I haven't read the wording lately, but I believe that the 2000kg refers to the total trailer mass + the load on the trailer - the downforce on the tow ball (normally about 100kg or so). Note I haven't double checked for a while, so that last bit may not be correct. Best to determine for youself before committing.

Well my trailer weighs 700 and I'll say my gtst is about 1300 :cool: so I just scrape in under 2000kg.

so you plan to exceed your towing capacity by at least 25%. good idea, what could possibly go wrong?

and your biggest concerns are clutch and unis? legality, safety and insurance don't even rate a mention.

I wish cops actually targetted real safety issues like these rather than putting speed cameras on highway on-ramps...

Well my trailer weighs 700 and I'll say my gtst is about 1300 :cool: so I just scrape in under 2000kg.

Sure you can put a two tonne rated towbar on it, but it doesn't mean it will be legal. If the manufacturer states 1600kg, then 1600kg it is.......

(as an aside does anyone know if the legalities of towing still vary massively from state to state? I remember many years ago it was always a drama when towing our 7 metre Sharkcat into NSW because the rules changed dramatically)

so you plan to exceed your towing capacity by at least 25%. good idea, what could possibly go wrong?

and your biggest concerns are clutch and unis? legality, safety and insurance don't even rate a mention.

I wish cops actually targetted real safety issues like these rather than putting speed cameras on highway on-ramps...

Well I've towed the same setup on a 1200kg tow bar coz I didn't have anything else.

Sure you can put a two tonne rated towbar on it, but it doesn't mean it will be legal. If the manufacturer states 1600kg, then 1600kg it is.......

I know it won't be legal but I'll pay the fine. I think it would be over engineered and 1600 is conservative. Manufacturers would have to be on the conservative side.

Back on topic, a F150 LWB with 351 on LPG makes a great tow vehicle.

Yeah but would be a pigg to drive around.

I've towed far in excess of legal and manufacturer's limits too, the point I am trying to make is now I'm older and smarter I certainly wouldn't be risking (for arguments sake) a 40k tow car, a 30k race car, and a 4k trailer being totally uninsured if I was to have a major accident, keeping in mind if you run into another car and hurt someone, no insurance there either.

Changed how many rear tyres Ben ?? The IRS on these is a JOKE. My mate had had 3 sets on the back in 50K

Bought it new and only put 3500km on it so far in 2mths with 1500km of that done in 3 days (towing) so haven't had a chance to wear out the back tyres yet, besides it only gets driven 50-100km in a normal week so i'll have traded it in before it reaches 50,000km.

Only Commodore/ute that can really tow properly is the VZ Crewman crew cab which has a live rear axel and 2500kg towing capaity. Preferably with a V8.

The VZ SS Crewman has a lower towing capacity than my VE SSZ Ute.

Having said that. You will prob not have an issue cause you car/trailer is so light. The massive trailer and the zed on it where pushing 2000kg. It was a very long trip from QLD.

My trailer is rated at 680kg and my car is 560kg so 1240kg all up and usually around 150kg of tools n stuff in the ute tray. You have to look in the rear view mirror and see the car on the trailer to remind yourself that you are actually towing something.

My previous tow car was a 2000 Toyota HiAce 2.4L Auto with 85kw and 200nm (probably 65kw coz it had 350,000km on the clock) that thing struggled just to tow the trailer over speed humps.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • @Haggerty this is your red flag. In MAP based ECU's the Manifold pressure X RPM calculation is how the engine knows it is actually...running/going through ANY load. You are confusing the term 'base map' with your base VE/Fuel table. When most people say 'base map' they mean the stock entire tune shipped with the ECU, hopefully aimed at a specific car/setup to use as a base for beginning to tune your specific car. Haltech has a lot of documentation (or at least they used to, I expect it to be better now). Read it voraciously.
    • I saw you mention this earlier and it raised a red flag, but I couldn't believe it was real. Yes, the vacuum signal should vary. It is the one and only load signal from the engine to the ECU, and it MUST vary. It is either not connected or is badly f**ked up in some way.
    • @Haggerty you still haven't answered my question.  Many things you are saying do not make sense for someone who can tune, yet I would not expect someone who cannot tune to be playing with the things in the ECU that you are.  This process would be a lot quicker to figure out if we can remove user error from the equation. 
    • If as it's stalling, the fuel pressure rises, it's saying there's less vacuum in the intake manifold. This is pretty typical of an engine that is slowing down.   While typically is agree it sounds fuel related, it really sounds fuel/air mixture related. Since the whole system has been refurbished, including injectors, pump, etc, it's likely we've altered how well the system is delivering fuel. If someone before you has messed with the IACV because it needed fiddling with as the fuel system was dieing out, we need to readjust it back. Getting things back to factory spec everywhere, is what's going to help the entire system. So if it idles at 400rpm with no IACV, that needs raising. Getting factory air flow back to normal will help us get everything back in spec, and likely help chase down any other issues. Back on IACV, if the base idle (no IACV plugged in) is too far out, it's a lot harder for the ECU to control idle. The IACV duty cycle causes non linear variations in reality. When I've tuned the idle valves in the past, you need to keep it in a relatively narrow window on aftermarket ecus to stop them doing wild dances. It also means if your base idle is too low, the valve needs to open too much, and then the smallest % change ends up being a huge variation.
    • I guess one thing that might be wrong is the manifold pressure.  It is a constant -5.9 and never moves even under 100% throttle and load.  I would expect it to atleast go to 0 correct?  It's doing this with the OEM MAP as well as the ECU vacuum sensor. When trying to tune the base map under load the crosshairs only climb vertically with RPM, but always in the -5.9 column.
×
×
  • Create New...