Jump to content
SAU Community

Recommended Posts

Spotted a white 32gtr at space station (shell) on epping road at 4.20pm today. Car had a sau sticker on the qtr window :)

That was me DIF! Yew!!! No mention if the car looked any good dammit!

spotted rr33yo this moring in the tunnel off castlehill rd onto penno rd, sau sticker, car sounded nice going through the tunnel.

Yay spotted :) i lovvve that tunnel.. what were u in mate?

That was me DIF! Yew!!! No mention if the car looked any good dammit!

Well, you know what they say.. If you can't say anything nice don't say anything at all...

..

...

KIDDING..

Nah looked pretty clean and sounded alright.. You need to rub that silly "drag/race number" off the window.. I can't stand that on cars..

Haha I was right behind your mate at the counter I was going to go over and say hi after I paid (I was just in my daily) but you guys left.

Yay spotted :) i lovvve that tunnel.. what were u in mate?

ahh i was in stealth mode my friend...in my work ute with mower on the back :)

also spotted a black na 33 leaving maccas at dural last night....i gave a little flutter as i went past when u were turning off (if your on here)

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • There are black hose clamps as well if you care. Plazmaman for example sells some: https://plazmaman.com/product/black-hose-clamps-premium-quality-stainless-breeze/
    • After using a protractor for an actually accurate assessment of what is required,  and by NOT using my uncalibrated eyeball I worked out I need a 25° silicone bend from the TB ro the MAF, but, my choice was either a 30° or a 23° (23° is a weird spec), so I grabbed the 23° one from Raceworks I also grabbed 1mtr of 3" straight from Just Jap, I needed 350mm, but they only had 300mm, or 1mtr lengths....meh Also ordered a 1/2" hose bulkhead fitting from fleabay, this has a smoothish mushroom looking head (they are designed for below the water line of boats) that will fit inside the bend, the hose bit and threaded bit looks to long, but nothing that a hacksaw cannot fix if required, the hose will then just get jamed on the threaded bit up to the retaining nut Fingers crossed and the unsightly amount of hose clamps will be reduced down to 4 once all the parts arrive 
    • Oil change does not trigger code 21. Code 21 is for coilpacks primary side connection. You can try to clear the code with a battery disconnect, hold down the brake pedal to drain capacitors through the brake lights with the ignition on for 10-15 seconds before you reconnect the battery. I have seen R35 coil conversion permanently cause this code with no ill effects so it might be the resistance it wants to see isn't quite right on one or more coilpacks. Could be inside the ECU, could be the harness, could be a coil. You can test it all if you want or just ignore until the car actually starts misfiring.
    • I forgot you have a Nistune ECU. Use Nistune to do all the tests I mentioned instead of faffing with 30+ year old electrical connectors. You can read MAF volts off that too, there are reference values in the service manual to tell you roughly what it should be in different conditions.
×
×
  • Create New...