Jump to content
SAU Community

Recommended Posts

fair connection

Hardware is Fast Ethernet, address is 000e.8373.7618 (bia 000e.8373.7618)

Description: Telstra Bigpond Cable 10mbps

MTU 1500 bytes, BW 10000 Kbit, DLY 100 usec,

reliability 255/255, txload 11/255, rxload 226/255

30 second input rate 18957000 bits/sec, 1633 packets/sec

30 second output rate 459000 bits/sec, 811 packets/sec

Bad conclusion at philip island historics. Possible fatality as driver ejected from car after coming unstuck in last corner before straight and hitting the wall. I hope david is ok.

Not to mention all the skylines retiring from the second run.

Looks like good weather tomorrow.

If anyone is interested might be doing a black spur run tomorrow with lunch a bit further up.

If anyone else is interested let me know.

Come to Winton you pony!

6 RB's, 9 SR's, and at 370z entered thus far.

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • Possibly avoid using a Cometic one unless the deck/head surface are perfectly flat. I did have a look just then and forgiving gaskets such as Tomei or Nitto don't exist for the FJ20, however the Bar-Tek or Kameari ones look good and might do the trick.
    • Because pipe threads for pipe things. M threads for bolt things. Throw some teflon sealant onto it and dust your hands off knowing you did the right thing, instead of going twice around the block to achieve a result using the wrong things. Of course, all of these solutions are ignoring the fact that the minimum thread pitch we're talking about here is 1.25mm, with the 1/4" in NPT or BPS being out around 1.4mm. You will need to know that the boss you're tapping has enough thickness for at least a few threads. That's one of the reasons that 1/8" is commonly used - because the pitch is <1mm. And why would you look to use 1/4" NPT in a BSP country anyway? Ugh.
    • Just throwing around ideas, does it need to be in the compressor cover? Why not the hot side piping?
    • 1/8NPT drill size = 8.7mm. Since the hole got messed up by me, it’s probably around 9mm.    So 1/4” NPT would be next step. A drill size of around 11mm would be preferred there which is not way of my M12 (drill 10.5mm and tap M12 threads) 
    • 3 Kids are starting to hit that ages. I wanted to get them something special to learn on, put down the screens and have some fun. 4Door 2001 R34DE Black Pearl GV1 Jap Import, AU 2nd owner. Pre Work done. Suspension - Wheels Pedders SportsRyder Coilovers   Wheels TSG Spokey Boi 18'x9.5"+15 Body JASI Aero 4 door Type R Full Kit LED Conversion - Parker, Blinkers, & Reverse Exhaust Hurricane Headers 100 CPI high flow cat 2.5" Piping Cannon muffler Internal Bride low max stradia ii - front seats  Bride RO seat base and Rails (R/H) Cube short shifter LED Conversion - Interior   
×
×
  • Create New...